石灰乳输送泵的失效分析与优化设计

结合某水泵厂提供的石灰乳输送泵的设计资料,根据试制的离心渣浆泵出现的失效现象,分析失效原因,研究改进方法,为低比转数离心渣浆泵的设计提出优化设计意见。     

气相法聚乙烯BCG-Ⅱ型催化剂的开发和应用

对气相法聚乙烯BCG-Ⅱ型催化剂的组成、粒径分布及催化剂的淤浆聚合性能进行了研究。研究结果表明，BCG—Ⅱ型催化剂的活性较高，聚合物堆密度适中，应用在Unipol乙烯气相聚合工艺装置上操作良好，所生产的树脂颗粒均匀。干爽且流动性好，产品质量合格、稳定。     

美国能源部的浆态床F－T合成技术

浆态床Ｆ－Ｔ合成技术是美国能源部Ｆ－Ｔ合成技术的主要开发项目。本文就浆态相Ｆ－Ｔ合成催化剂的开发、中试示范实验和浆态反应器的化工基础研究作一扼要的介绍。     

Synthesis and electrochemical performance of LiNi0.5Mn1.5O4 spinel compound

Spinel compound LiNi_0.5Mn_1.5O₄ was synthesized by a chemical wet method. Mn(NO₃)₂, Ni(NO₃)₂·6H₂O, NH₄HCO₃ and LiOH·H₂O were used as the starting materials. At first, Mn(NO₃)₂ and Ni(NO₃)₂·6H₂O reacted with NH₄HCO₃ to produce a precursor, then the precursor reacted with LiOH·H₂O to synthesize product LiNi_0.5Mn_1.5O₄. The product showed a single spinel phase under appropriate calcination conditions, and exhibited a high voltage plateau at about 4.6-4.8 V in the charge/discharge process. The LiNi_0.5Mn_1.5O₄ had a discharge specific capacity of 118 mAh/g at about 4.6 V and 126 mAh/g in total in the first cycle at a discharge current density of 2 mA/cm². After 50 cycles, the total discharge capacity was above 118 mAh/g.     

磷酸铁锂锂离子电池正极材料的研究

锂离子电池是绿色高能可充电池，具有工作电压高、比能量大、自放电小、循环寿命长、无记忆效应、无环境污染等突出优点。本文从磷酸铁锂的结构与性能、材料的制备方法、改性、粒径控制等几方面综述了近年来对橄榄石型磷酸铁锂（LiFePO4）锂离子电池正极材料的研究进展。材料的粒度大小及其分布、离子和电子的传导能力对产品的电化学性能影响很大。在制备时，采用惰性气氛、掺杂导电材料和控制晶粒生长制备粉体是获得性能优良的LiFePO4的有效方法。     

New analysis of non-newtonian turbulent flowndashyield-power-law fluids

The writers' new analysis of non-Newtonian turbulent flow is extended to the yield-power-law model. As the value of the exponent of the yield-power law decreases from unity, the calculated friction factor begins by converging toward the Newtonian line at high velocity, then parallels it, and finally diverges downward. This prediction agrees with previously unexplained experimental results.     

EIS and GITT studies on oxide cathodes, O2-Li(2/3)+x(Co0.15Mn0.85)O2 (x=0 and 1/3)

Li ion kinetics in the O2-phase layered manganese oxides, Li_2/3(Co_0.15Mn_0.85)O₂ (O2(Li)) and Li_(2/3)+x(Co_0.15Mn_0.85)O₂ (x=1/3 (O2(Li+x))), has been studied by the electrochemical impedance spectroscopy (EIS) and galvanostatic intermittent titration technique (GITT) at room temperature and the results were correlated with the observed cathodic behaviour. Both compounds show a reversible capacity of ∼180 mA h/g at low current density (∼5 mA/g). EIS studies as a function of cycle number show an increased contribution of resistance associated with surface film formation and bulk contribution which is in agreement with the increased capacity fading observed in O2(Li+x) after 10-15 cycles. The Li ion diffusion coefficient (D_Li) vs voltage plots show minima during the first charge cycle coinciding with the irreversible plateau of the voltage vs capacity profiles reflecting the irreversible phase change in both the compounds. The values of D_Li (GITT method) observed for the second and subsequent cycles (≤6) in the full voltage range (3.0-4.4 V) are 2×10⁻¹¹-10×10⁻¹¹ cm²/s for O2(Li+x) and 0.5×10⁻¹⁰-3.0×10⁻¹⁰ cm²/s for O2(Li). Variation of D_Li as a function of cycle number (up to 35) indicates that, in addition to the interface kinetics, changes in the D_Li values with cycling also contribute to the capacity fading of the compounds, especially in O2(Li+x).     

A Fully Continuous Supercritical Fluid Extraction System for Contaminated Soil

A fully continuous lab scale supercritical fluid extraction system has been designed, built and tested. The system continuously pumps carbon dioxide under supercritical conditions and soil slurry into a counter‐current contacting column. Delhi Loamy Sand, spiked with approximately 10 mg/g of naphthalene, was used as the testing soil. The soil slurry ranged from 0.0028 g dry soil per g slurry to 0.072 g/g. The operating temperature was 43°C and the operating pressure was 7.7 MPa. Near steady state, fully continuous flow was achieved with runs lasting as long as 2 h. All carbon dioxide samples contained measurable quantities of naphthalene and the measured mass transfer coefficients were as high as 4.6×10^?4 s^?1.     

泥磷回收制磷危险性分析与防治

泥磷回收制磷属于化学危险品生产,由于黄磷本身的易燃特性和生产中其他因素的诱导,极容易发生泄漏引发火灾和灼伤。介绍了泥磷的产生和泥磷回收制磷的工艺特点。应用系统安全工程的原理和方法,辨识了泥磷回收制磷生产的潜在危险性;辨识了泥磷回收制磷生产过程中的物质危险性、装置危险性和工艺危险性。运用预先危险性分析法（PHA）对泥磷回收制磷的主要危险、有害因素进行分类和分级。根据对主要危险、有害因素分类和分级的结果,提出技术措施和管理措施来提高企业安全生产管理水平和预防生产性事故的发生。     

堆场疏浚泥颗粒分选特性初步量化方法

为了准确评估堆场存储能力和合理选择疏浚泥处理工艺,以泥沙运动学为理论基础,将疏浚泥颗粒分为d0.005 mm、0.005 mm≤d≤0.01 mm和d0.01 mm 3个粒组,分析了各粒组相对含量的沿程变化规律,明确了堆场疏浚泥分选的主要原因是d0.01 mm粒组与0.005 mm≤d≤0.01 mm粒组的相对运动;以分选系数量化堆场疏浚泥分选的显著程度,以偏离系数量化原泥颗粒组成对堆场疏浚泥分选的影响,分析了分选系数、偏离系数分布与堆场疏浚泥土性分布的关系,提出了堆场疏浚泥分选特性的初步量化方法。研究结果表明:随着离吹填口距离的增大,分选系数沿程减小,呈幂函数分布,堆场疏浚泥分选性沿程减弱,吹填口附近分选系数最大,颗粒分选显著,粒度差异大,退水口附近分选系数趋近于零,分选不明显,颗粒分布均匀;偏离系数沿程先减小后增大,呈勺形分布,反映堆场前、后段疏浚泥土性与原泥相差较大,而堆场中段疏浚泥土性与原泥接近;分选系数、偏离系数的沿程分布与堆场疏浚泥土性分区具有良好的相关性。