The study on the conductivity of styrene-maleic anhydride copolymer electrolytes based on poly(ethylene glycol)400 and LiClO4

Polyelectrolytes, in this study were synthesized from styrene-maleic anhydride (SMA) copolymer, poly(ethylene glycol)400 (PEG400), and lithium perchlorate (LiClO₄). Fourier transform infrared spectroscopy (FTIR), and magic angle spinning (MAS) solid-state NMR were used to monitor the interaction between Li⁺ ions and polymer. The results of FTIR and MAS solid-state NMR indicate the Li⁺ ions are preferentially coordinated to the ether oxygen of PEG. The T_g of the PEG segments in polyelectrolyte increases with LiClO₄ concentration, as determined by differential scanning calorimetry (DSC), indicating that solubility of the Li⁺ ions in the host polymer increases with the PEG content. Impedance spectroscopy (IS) shows that the bulk conductivity of polyelectrolytes and the conductivity behavior obeys the Vogel-Tamman-Fulcher (VTF) equation.     

基于Visual C++的0-1背包问题的分枝限界算法

0-1背包问题是经典的NP问题。本文对0-1背包问题的分枝限界算法进行了分析,用Visual C++实现该算法。     

The Chemistry of Water Treatment Processes Involving Ozone,Hydrogen Peroxide and Ultraviolet Radiation

Advanced oxidation processes are defined as those which involve the generation of hydroxyl radicals in sufficient quantity to affect water purification. The theoretical and (practical yield of OH from O₃ at high pH, 0₃/H₂0₂, O₃/UV and H₂O₂/UV systems is reviewed. New data is presented which illustrates the importance of direct photolysis in the O₃/UV process, the effect of the H₂0₂:0₃ ratio in the O₃/H₂O₂ process, and the impact of the low extinction coefficient of H₂O₂ in the H₂0₂/UV process.     

球形零价铁生物炭吸附Cd(II)的性能和机制

本研究提供了一种一步热解法制备纳米零价铁生物炭的方法。将海藻酸铁在高温缺氧条件下热解制备了球形零价铁生物炭复合材料（ZVIBC），考察了Cd(II)溶液pH、初始浓度、吸附时间、背景离子、空气中老化时间对ZVIBC吸附Cd(II)性能的影响，通过FTIR、XRD、XPS、EDS等方法对ZVIBC以及ZVIBC-Cd(II)进行了表征，研究了ZVIBC对Cd(II)的吸附机理。结果显示：pH对ZVIBC吸附Cd(II)有显著的影响，4为最佳吸附pH条件。ZVIBC吸附Cd(II)的过程符合Langmuir模型，拟合的饱和吸附量为240 mg/g。主要吸附机理为：活性官能团（O—H、C—O、C=C、C=O、COO）与Cd(II)形成配合物，以及Cd(II)与Fe2+生成Cd(OH)2沉淀。     

压挤成形--固化法制备0-3型压电复合材料的性能研究

详细地叙述了室温压挤成形———固化工艺制备 0 -3型压电复合材料工艺 ,使用XRD、SEM和HP42 94测试并分析了样品的结构和性能 ,并与压电陶瓷性能参数进行了对比 ;同时用这种工艺制备可以获得介电损耗小、机电耦合系数为 2 5 .11%、压电应变常数为 3 2PC N和机电品质因数可达到 3 0 2的 0— 3型压电复合材料。     

Suppression of the α → β-nickel hydroxide transformation in concentrated alkali: Role of dissolved cations

The presence of dissolved cations such as Al and Zn in alkaline electrolyte (6 M KOH) suppresses the -nickel hydroxide transformation. The uptake of Al (10 mol%) and Zn (30 mol%) exhibited by the active material likely stabilizes the -phase. Dissolved Al is deleterious to the performance of the nickel hydroxide electrode, whereas, dissolved Zn enhances the specific discharge capacity of nickel hydroxide by approximately 25% showing that the mode of metal uptake is different in the two cases.     

α-Tocopherol alteration of soybean antiherbivory toTrichoplusia ni larvae

The antioxidant vitamin E, -tocopherol, was tested as a candidate elicitor of alterable antiherbivory in soybean plants against cabbage looper larvae. Although a nonspecific antioxidant, vitamin E proved elicitory to the involved sulfhydryl-dependent receptor-energy transducer protein in soybean plasma membrane. Effects of -tocopherol were dependent on dosage, time, and space in the plant. The observed elicited effects were all decreases in herbivory. The best negative phytochemical correlate of looper feeding was the percentage of increased total HPLC peak area of extractables from elicited as compared to nonelicited leaves. Some specific compounds, e.g., glyceollins, were quantitatively major components of the total profile of secondary metabolites.     

The influence of an intermediate MoO3 layer on the solid state reaction of cobalt oxide withγ-Al2O3

In view of the importance for Co_xO_y,-MoO₃/-Al₂O₃ hydrodesulphurization (HDS) catalysts, the reactivity of cobalt oxide layers towards cobalt aluminate formation was investigated on both MoO₃-covered and bare -Al₂O₃ substrates. Co₃O₄/MoO₃/-Al₂O₃ and Co₃O₄/-Al₂O₃ systems were prepared by vapour-deposition of MoO₃ (12 × 10¹⁵ Mo atoms/cm²) and Co (400 × 10¹⁵ Co atoms/cm²) layers onto a -Al₂O₃ substrate, followed by oxidation of the Co layer to Co₃O₄. After annealing at 800°C for 40 h, the interfacial reaction to cobalt aluminate was assessed using Rutherford backscattering spectrometry. The presence of molybdenum oxide appeared to enhance cobalt aluminate formation. The Mo atoms, which spread out over the entire cobalt-containing layer, presumably caused a high defect density, which explains the observed higher reaction rate. The amount of MoO₃ was much too low to stabilize all cobalt atoms by cobalt molybdate formation.     

Assessment of a redox alkaline/iron-chelate absorption process for the removal of dilute hydrogen sulfide in air emissions

The oxidative absorption of hydrogen sulfide (H₂S) into a solution of ferric chelate of trans-1,2- diaminocyclohexanetetraacetate (CDTA) was studied in a counter-current laboratory column randomly packed with 15 mm plastic Ralu rings. The present investigation takes concern about the Kraft pulping situation where dilute H₂S concentrations are omnipresent in large-volume gas effluents. A fractional two-level factorial approach was instigated to determine the significance of six operating variables, namely the solution's alkalinity (pH; 8.5-10.5), the liquid mass flow rate (L;1.73-), the solution's ionic strength (I_C;0.01-), the gas mass flow rate (G;0.19-), the inlet H₂S concentration (C_H2S,0;70-430 ppm) and the initial ferric CDTA concentration (C_Fe,0;100 -). Initially, a Plackett-Burman design matrix of seven duplicated experiments revealed that pH is the leading factor controlling the H₂S conversion rate while the ionic strength and ferric CDTA concentration effects remained negligible within the factorial domain. Surface response analysis based on 11 duplicated factorial experiments plus 10 central composite trials revealed that the H₂S conversion significantly increases with liquid flow rate but decreases with growing H₂S load up. Further examination about the influence of ferric CDTA on H₂S absorption rate was set up over a broader concentration range (C_Fe,0;0- at pH of 9.5 and 10.5. It showed good potential at as H₂S conversion increased by a significant 25% for both pH values in comparison to pure alkaline solutions containing no ferric CDTA.     

The ring transformations of 1,2,3,4-diepoxybutane (2,2′-bioxirane) catalysed by various aluminosilicates

The transformations of a molecule containing two adjacent epoxide rings, 2,2-bioxirane that is, were studied over various acidic aluminosilicates (HZSM-5, HY-FAU, AlMCM-41), for the first time, In the 373–473 K temperature range, in a pulse reactor, a ring-opening–ring-enlargment reaction producing furan only occured over the zeolites and it was the predominant reaction on AlMCM-41 as well. The driving force of this transformation route is water formation via elimination from 2,2-bioxirane. Suprising is the lack of the mono- or dialdehyde, the would-be products of the cleavage of the sterically more hindered C–O bonds – an acid-catalysed reaction typical for alkyl-substituted oxiranes.