Ionoluminescence decay measured with single ions

A new ion beam analysis-based, single ion technique called the time to first photon has been developed to measure the decay of the luminescence signal of phosphors. Such measurements are currently needed to study luminescence decay mechanisms following high-density excitations and to identify strongly luminescent phosphor coatings with short lifetimes for ion photon emission microscopy (IPEM). The samples for this technique consist of thin phosphor layers placed or coated on the surface of PIN diodes. Single ions from an accelerator strike this sample and simultaneously create ion beam induced luminescence (IBIL) from the phosphor that is measured by a single-photon-detector, and an ion beam induced charge collection (IBICC) signal in the PIN diode. In this case, the IBICC signal provides the start pulse and the IBIL signal the stop pulse to a time to amplitude converter. It is straightforward to show that this approach also measures a signal proportional to activity versus time with an accuracy of 5% as long as the number of detected photons per ion is less than 0.1, which usually requires the use of absorbers for the IBIL detector or electronic discrimination for the IBIL signals. Details of the new analysis are given together with examples of luminescence decay measurements of several ceramic phosphors being considered to coat IPEM samples. IPEM is currently being developed at Sandia National Laboratory (SNL), the University of North Texas in Denton, and the Universities and INFN of Padova and Torino.     

工程监理取费偏低,阻碍监理行业发展

工程监理制在我国建筑市场中，对提高工程质量、控制投资效益起着极其重要的作用，目前我国工程监理行业在低取费的条件下，困难重重，只能维持低水平运行。我们应找出存在的差距，采取相应的措施，适当提高监理取费，使监理行业迅速发展壮大。     

成藏流体历史分析——以黄骅坳陷三马地区为例

应用储集层岩石烃类流体包裹体研究方法，对黄骅坳陷三马地区沙一段油藏进行了重建成藏流体历史的尝试。对包体流体状态的分析表明，成藏流体具有高密度，高矿化度的性质，被捕获时的温度约为110－140℃，成藏流体的主要充注时期在明化镇组沉积期，距今为10－4Ma之前，充注成藏后的小幅度构造抬升中可能使原称油水界面以下的地层水矿化度发生变化，导致现今储集层流体矿化矿比包裹体流体矿化度明显下降。图5表2参6（钟宁宁摘）。     

热释电系数的测量方法

描述热释电系数的两种测量方法。其一为电荷积分法，测试系统简单，测量数据准确，且能满足零电场条件下的测量。其二为动态电流法，采用调制热源技术，研究在特定温度条件下热释电材料的动态热释电响应。     

Halogen-induced charge transfer polymerization of pyrrole in aqueous media

Simultaneous polymerization and doping of pyrrole have been carried out in the presence of a halogenic electron acceptor, bromine (Br₂) or iodine (I₂), in aqueous dispersion or in a two-phase solvent system. The morphology of the polypyrrole (PPY) so produced is granular and porous. The electrical conductivity of the PPY-I₂ charge transfer (CT) complex is of the order of 10¹ ohm⁻¹ cm⁻¹ while that of the PPY-Br₂ complex is about one order of magnitude less. Both complexes are stable in the atmosphere. The physicochemical properties of the PPY-I₂ and PPY-Br₂ CT complexes prepared under various experimental conditions are examined in detail.     

Chemistry and Physics of Alkali Metals on MoS2 Surfaces

The interaction of alkali metal with surfaces has been of great interest to the community of catalysis since alkali metal can play an important role as a promoter. On alkali-doped MoS₂, such a promotion effect of alkali metal has been exemplified in the direct synthesis of linear alcohols from CO and H₂, where the alkali-doping switches the catalyst selectivity from methanation to alcohol synthesis. This paper reviews recent high-resolution X-ray photoelectron spectroscopy experiments that have provided direct observation of electron transfer from alkali metals to a model single crystal MoS₂ and the capture of the supra-valence electrons in the subsequent oxidation reactions.     

Electrical conductivity in iodine-doped ethyl cellulose

The electrical conductivity of solution-grown ethyl cellulose (EC) films, 5–30 μm thick, has been studied in the sandwich configuration (metal–EC–metal) as a function of iodine concentration from 0.5 to 5.0 wt% ratio. The studies were conducted in the temperature range 333–383 K, while the field was varied over the range (3.0–5.5) × 10⁴V/cm. Aluminium was used as the lower electrode, while the upper electrode was of Al, Ag, Cu, Au or Sn. Certain transient effects such as a large burst of current immediately after the application of field were observed. An attempt was made to identify the nature of the current by comparing the observed dependence on electric field, electrode material and temperature with the respective characteristic features of the existing theories of electrical conduction. The results show that the electrical conduction follows Ohm's law at lower fields, while at higher fields, space-charge limited current (SCLC) was observed. It was also found that Richardson–Schottky emission was responsible, to some extent, for the transport of charge carriers in the polymer. The conductivity of the films increased on doping with iodine. The dopant molecules are considered to act as additional trapping centes and provide links between the polymer molecules in the amorphous region, thus resulting in the formation of charge transfer complexes.     

DC-DC电荷泵的研究与设计

以Dickson电荷泵的基本原理为出发点，研究了一种将正电压输入转为负电压输出的开关电容电路。由于开关电容的充放电特点，为确定电容时间常数，采用非交叠时钟控制信号避免了由于时钟交叠而造成的当电容充电还未完成即对下一级电容进行放电的现象。同时，参考功率MOS-FET的电容模型通过增大驱动电路的电流减小了开关管的上升延时，提高了开关动作的速度，使转换效率得到明显提高。此电路结构简单，性能优良，易于集成，可广泛应用于输出负电压的电源产品中。     

LC4L-20增压中冷柴油机的研制

介绍了LC4L-20增压中冷柴油机的性能与结构特点，着重分析了增压中冷技术，及各主要运动件的可靠性设计。     

平面药包抛掷爆破的漏斗特征解析

根据惠州港通用码头陆域平面药包抛掷爆破的实爆堆积测量分析成果 ,结合药包设计的主要参数 ,对平面药包产生的爆破漏斗的范围与形态、不同药包部位的残方比与抛掷率、药包的长抗比与圆柱体药包的应力波形演变关系予以解析 ,供硐室爆破的理论研究、模拟试验和总结条形药包特性时参考