化学还原法制备导电涂料用片状超细铜粉的研究

以CuSO4·5H2 O为原料 ,抗坏血酸为还原剂 ,NH3 ·H2 O为络合剂 ,将络合剂在反应温度加到CuSO4·5H2 O溶液中 ,再加入还原剂 ,制备了粒径分布为 1～ 10 μm的片状铜粉。探索与分析NH3 ·H2 O的用量、反应温度和CuSO4浓度对铜粉形貌及产率的影响。结果表明 :络合剂的使用是制备片状超细铜粉的关键 ,其与Cu2 + 形成络合物 ,减少溶液中游离Cu2 + 的浓度 ,控制铜的生成速度 ,并影响铜的成核和生长 ,最终形成片状铜粉。     

Carbon nanofibers: Synthesis, characterization, and electrochemical properties

Carbon nanofibers (CNFs) have been synthesized by co-catalyst deoxidization process by a reaction between C₂H₅OC₂H₅, Zn and Fe powder at 650 °C for 10 h. These nanofibers exhibit diameters of ∼80 nm and lengths ranging from several micrometers to tens of micrometers. X-ray diffraction, Raman spectroscopy, and high-resolution transmission electron microscopy indicate that as-prepared CNFs possess low graphitic crystallinity. The resultant CNFs as electrode shows capacity of ∼220 mAh/g and high reversibility with little hysteresis in the insertion/deintercalation reactions of lithium-ion. In addition, the possible growth of CNFs is discussed.     

Catalytic Conversion of NO and C3H6 in Exhaust Gases Over Silver Catalysts Under Stoichiometric or Excess Oxygen

The role of Ag in simultaneously catalyzing NO reduction and C₃H₆ oxidation was shown to be strongly dependent on the redox properties of its local environment. Under an atmosphere of 1,000 ppm NO, 3,000 ppm C₃H₆, and 1% O₂ and a GHSV of 30,000 h⁻¹, a perovskite La_0.88Ag_0.12FeO₃ prepared by reactive grinding is active giving a complete NO conversion and 92% C₃H₆ conversion at 500 °C. These values are much higher than the NO conversion of 55% and C₃H₆ conversion of 45% obtained over a 3 wt.% Ag/Al₂O₃ catalyst under the same conditions. Under an excess of oxygen (10% O₂) a good SCR performance with a plateau of N₂ yield above 97% over a wide temperature window of 350–500 °C along with C₃H₆ conversion of 90% at 500 °C was observed over Ag/Al₂O₃, while minor N₂ yields (∼10% at 250–350 °C) and high C₃H₆ conversions (reaching ∼100% at 450 °C) were obtained over La_0.88Ag_0.12FeO₃. Abundant molecular oxygen is desorbed from Ag substituted perovskite after 10% O₂ adsorption as verified by O₂- temperature programmed desorption (TPD). This reflects the strongly oxidative properties of La_0.88Ag_0.12FeO₃, which lead to a satisfactory NO reduction at 1% O₂ due to the ease of nitrate formation but to a significant C₃H₆ combustion above that value. The formation of nitrate species over the less oxidizing Ag/Al₂O₃ was accelerated under an excess of oxygen resulting in an excellent lean NO reduction behavior. The redox properties of silver catalysts could be adjusted via mixing perovskite with alumina for an optimal elimination of both NO and C₃H₆ over the whole range of oxygen concentration between 0 to 10%.     

High Throughput Screening of Low Temperature SCR and SCD De-NOx Catalysts in Scanning Mass Spectrometer

High-throughput synthesis and screening methods have been developed for the discovery of highly active lead compounds for the selective catalytic reduction as well as direct decomposition of NO in the temperature range 200–300 °C. The discovery libraries for primary screening consisted of 16 × 16 catalyst arrays on 4in. square quartz wafers. Catalysts were prepared by robotic liquid dispensing techniques and screened for catalytic activity in Symyx' scanning mass spectrometer. The scanning mass spectrometer is a fast serial screening tool that uses flat wafer catalyst surfaces, local laser heating, a scanning/sniffing nozzle and a quadrupolar mass spectrometer to compare relative catalytic activities. The feed consisted of NO/NH₃ mixtures with optional O₂ cofeed and Kr as the internal standard in Ar carrier gas. QMS detection allowed for tracking of H₂O, N₂, NO, O₂, N₂O and Kr. Screening protocols for catalytic materials encompassed metal precursors and carriers for supported vanadia systems, extensive doping of V₂O₅/TiO₂, and broad screening of mixed redox metal oxides and supported base and noble metal systems. More than 500 samples could be screened in a single day. Active hits (high NO consumption accompanied by corresponding N₂ production) identified in discovery libraries were re-synthesized as focus libraries for lead confirmation and further optimization. These libraries used shallower compositional gradients, for example 56 points (compositions) per ternary, with four 56-point ternaries per 4in. wafer. Broad screening ternaries were generally 8 or 15 points. The focus libraries more clearly reveal the trends and provide guidelines for secondary screening and scale-up. High conversions were achieved in scanning mass spectrometer so the scalability risk is small for the short contact time reactions.     

Electrochemical promotion of Rh catalyst in gas-phase reduction of NO by propylene

The concept of non-faradaic electrochemical modification of catalytic activity (NEMCA) has been applied for the in situ control of catalytic activity of a rhodium film deposited on YSZ (yttria stabilized zirconia) solid electrolyte towards reduction of 1000 ppm NO by 1000 ppm C₃H₆ in presence of excess (5000 ppm) O₂ at 300 °C. A temporary heating at this feed composition results in a long-lasting deactivation of the catalyst under open circuit conditions due to partial oxidation of the rhodium surface. Positive current application (5 A) over both the active and the deactivated catalysts gives rise to an enhancement of N₂ and CO₂ production, the latter exceeding several hundred times the faradaic rate. While active rhodium exhibits a reversible behaviour, electrochemical promotion on the deactivated catalyst is composed of a reversible and an irreversible part. The reversible promotion results from the steady-state accumulation of current-generated active species at the gas exposed catalyst surface whereas the irreversible effect is due to the progressive reduction of the catalyst resulting in an increased recovery rate of lost catalytic activity. The results are encouraging with respect to application of rhodium for the catalytic removal of NO from auto-exhaust gases under lean-burn conditions.     

Electrochemical pre-treatment of effluents containing chlorinated compounds using an adsorbent

Electrochemical pre-treatment of industrial wastewater to remove refractory and/or toxic organic components, making them more amenable to biological treatment, is likely to be more cost-effective than using a physical or chemical process for complete organic removal. This paper demonstrates the use of a carbon-based adsorbent material that preferentially removes chlorinated organic compounds. Electrochemical regeneration of the adsorbent is shown to be a quick, easy and cheap process, because the adsorbent is both highly electrically conducting and non-porous. High regeneration rates over a number of cycles were obtained by passing a charge of 25 C g⁻¹ through a bed of adsorbent particles, at a current density of 20 mA cm⁻² for 10 min. The energy required to remove a kg of COD from an industrial wastewater was calculated to be 27 kWh.     

Electrochemical properties of carbon-coated CaWO4 versus Li

Carbon-coated CaWO₄ nano-crystalline phases have been synthesized by ambient temperature solution precipitation method, characterized by X-ray diffraction, SEM and thermogravimetry and their electrochemical properties were studied versus Li metal. Galvanostatic cycling at a current of 60 mA/g in the voltage range 0.005-3.0 V on the 5 wt.% C-coated CaWO₄ gave a reversible capacity of 230 ± 5 mAh/g corresponding to 2.5 mol of Li, which is almost stable from 20 to 50 cycles. Under the same conditions, the 10 wt.% C-coated CaWO₄ showed a capacity of 355 ± 5 mAh/g (3.8 mol of Li) during the initial cycles, but the capacity degraded at a rate of 1.6 mAh/g per cycle in the range 5-100 cycles. A good operating voltage range was found to be 0.005-3.0 V with average discharge and charge potentials being 0.6 and 1.3 V, respectively. Coulombic efficiency in all cases was 96-98%. Cyclic voltammograms compliment the galvanostatic results. Impedance spectral data on the 10 wt.% C-coated CaWO₄ at different voltages during the first and 20th discharge-charge cycle have been interpreted in terms of the variations in the bulk and charge-transfer resistances of the composite electrode. A reaction mechanism involving the formation/decomposition of the oxide bronze, ‘Li_xWO_y’ has been proposed to explain the electrochemical cycling.     

X-ray photoelectron spectroscopic study of the oxidation and reduction of a cerium(III) oxide/cerium foil substrate

X-ray photoelectron spectroscopy has been used to examine the nature of the oxide overlayers on a passivated cerium metal foil as a function of a variety of oxidation and reduction treatments. Oxidation of a clean uncontaminated cerium(III) oxide surface is facile at room temperature and produces non-stoichiometric ceria (CeO_2–x) at oxygen doses as low as 10 L. At higher doses the overlayer thickens, and after a dose of 160 L the layer depth exceeds the Ce 3d photoelectron attenuation distance of about 20 Å. High pressure treatment of the foil in oxygen (0.5 bar at RT and 473 K) produces CeO₂ in a high degree of crystallographic order such that O 1s photoelectron intensities are increased above that expected from a randomly oriented powder. An attempt to reduce the CeO₂ layer formed by controlled oxidation with CO (633 K, 14 h, 0.6 bar) results in the formation of a carbonated surface layer. Results following attempts to reoxidise this layer are discussed.     

Activation of plant foliar oxidases by insect feeding reduces nutritive quality of foliage for noctuid herbivores

The foliage and fruit of the tomato plantLycopersicon esculentum contains polyphenol oxidases (PPO) and peroxidases (POD) that are compartmentally separated from orthodihydroxyphenolic substrates in situ. However, when leaf tissue is damaged by insect feeding, the enzyme and phenolic substrates come in contact, resulting in the rapid oxidation of phenolics to orthoquinones. When the tomato fruitwormHeliothis zea or the beet army-wormSpodoptera exigua feed on tomato foliage, a substantial amount of the ingested chlorogenic acid is oxidized to chlorogenoquinone by PPO in the insect gut. Additionally, the digestive enzymes of the fruitworm have the potential to further activate foliar oxidase activity in the gut. Chlorogenoquinone is a highly reactive electrophilic molecule that readily binds cova-lently to nucleophilic groups of amino acids and proteins. In particular, the —SH and —NH₂ groups of amino acids are susceptible to binding or alkylation. In experiments with tomato foliage, the relative growth rate of the fruitworm was negatively correlated with PPO activity. As the tomato plant matures, foliar PPO activity may increase nearly 10-fold while the growth rate of the fruitworm is severely depressed. In tomato fruit, the levels of PPO are highest in small immature fruit but are essentially negligible in mature fruit. The growth rate of larvae on fruit was also negatively correlated with PPO activity, with the fastest larval growth rate occurring when larvae fed on mature fruit. The reduction in larval growth is proposed to result from the alkylation of amino acids/protein byo-quinones, and the subsequent reduction in the nutritive quality of foliage. This alkylation reduces the digestibility of dietary protein and the bioavailability of amino acids. We believe that this mechanism of digestibility reduction may be extrapolatable to other plant-insect systems because of the ubiquitous cooccurrence of PPO and phenolic substrates among vascular plant species.     

Application of an improved control-variate scheme to local neoclassical transport simulations

A new radially local neoclassical transport code is developed based on the radially global two-weight δf$\delta f$ Monte Carlo code, FORTEC-3D (Satake et al., 2008). In the collisional two-weight δf$\delta f$ method, the variance of weight increases in time due to the so-called weight spreading, which leads to an increasing numerical noise in long time simulations. A new improved control-variate scheme was proposed by Kleiber et al. (2011) to reduce the variance. We investigate the effectiveness and validity of the new control-variate scheme for a practical collisional transport problem in a plasma described by the drift kinetic equation. It is demonstrated that the new scheme reduces the variance of weight by approximately 75% in an axisymmetric magnetic field configuration. The burst-like behavior of a transport observable caused by a large numerical noise can be avoided. As a result, the time evolution of a transport observable can be successfully smoothed.