浅谈降低电解槽氟化铝单耗的方法

氟化铝是电解生产中十分重要的原料，它对控制电解槽电解质温度，保持电解槽技术条件发挥着重要的作用。但随着电解生产成本的逐渐降低，氟化铝的消耗成为电解生产成本中的一项重要内容。本文就某分厂电解槽氟化铝添加的生产工艺、设备、控制以及管理等方面，提出降低氟化铝单耗的简要方法。     

铝电解槽磁流体稳定性有限元分析

本文采用有限元法求解分层磁流体小扰动方程系统特征值，研究铝电解槽稳定性。研究结果表明，在没有电磁力时，铝液表面波动（内波）是稳定的。存在电磁力时，它会激发铝液表面波动的某些低频长波分量不稳定性，高频短波不受影响。被激发的不稳定波动频率和扰动增长率与电流密度，磁感应强度垂直分量，铝电解槽长宽比，电解质和铝液的密度差，厚度等因素密切相关。减少电流密度，磁感应强度，增加电极距离和铝液厚度可以提高铝电解槽的稳定性。这对铝电解槽优化设计和在线控制有重要意义。     

Determination of instantaneous corrosion rates and runoff rates of copper from naturally patinated copper during continuous rain events

Instantaneous corrosion rates of naturally patinated copper of varying age (16 months, 138 and 145 years) have been determined during continuous rain events in the laboratory with electrochemical impedance spectroscopy using a two-electrode cell. The two-electrode cell was found to yield the same information in bulk rainwater as a conventional three-electrode cell.Relatively constant corrosion rates, between 0.2 and 0.6 μm/y, were determined for samples having a two-layer structure with an inner brownish layer of cuprous oxide and an outer greenish layer of basic copper salts (138, 145 years). Samples with cuprous oxide as the dominating phase of the patina (16 months) showed higher and somewhat increasing corrosion rates during a rain event (from 0.6 to 1.2 μm/y). During a continuous rain event, corrosion rates were found to be approximately 10 (brownish patina) and 25 times (greenish patina) lower than corresponding instantaneous runoff rates. The first flush phenomena of the runoff process, with an increased concentration during first flush and a relatively constant concentration during steady state, was indirectly seen as an increase in solution conductivity during the first rain volume followed by relative constant value. The contribution of the concentration in the first flush to the total annual runoff rate was significant for panels having a greenish layer (138, 145 years) whereas it was negligible for panels having a brownish layer (16 months).     

An orthogonal basis for the hyperbolic hybrid polynomial space

Motivated by the wide usage of the Tchebyshev basis and Legendre basis in the algebra polynomial space, we construct an orthogonal basis with the properties of the H-Bézier basis in the hyperbolic hybrid polynomial space, which is similar to the Legendre basis and holds remarkable properties. Moreover, we derive the transformation matrices that map the H-Bézier basis and the orthogonal basis forms into each other. An example for approximating the degree reduction of the H- Bézier curves is sketched to illustrate the utility of the orthogonal basis.     

纳米Fe粉的制备研究

总结了纳米Fe粉的制备方法,重点介绍了一种新的制备方法——封闭循环氢还原法。该方法以FeSO·47H2O和NaOH为原料,采用沉淀方法制备粒径为30～70nm的Fe2O3粉末,其反应条件为:反应温度50℃,反应终点pH值大于12,陈化时间1h。用封闭循环氢还原法,在400℃下还原Fe2O3得到了Fe粉。其粒径在20～50nm之间,含量为99.16%。     

Kinetics of DyNi2 film growth by electrochemical implantation

Electrochemical implantation was performed at Ni electrodes to form DyNi₂ films at 0.55 V (vs. Li⁺/Li), 0.62 V, and 0.70 V for 0.5-5.0 h in a molten LiCl-KCl-DyCl₃ (0.50 mol%) system at 700 K. It was found that the DyNi₂ films grew linearly with time with coulomb efficiency of about 100%. The obtained growth rates were higher at more negative potentials, i.e., 0.47 μm min⁻¹ at 0.55 V, 0.32 μm min⁻¹ at 0.62 V, and 0.14 μm min⁻¹ at 0.70 V. On the analogy of the metal oxide growth, the observed rapid and linear growth of DyNi₂ films may be explained by the existence of the outer and inner DyNi₂ layers.     

Effect of Organic Additives on Electrochemical Surface Precipitation and Polymorphism of CaCO3

The inhibition effect of three organic additives on the precipitation and polymorphism of CaCO₃ deposited on gold surfaces was investigated using electrochemical and microscopic techniques. Additives, two polyacrylic acid (PAA) polymers with different molecular weights (Mw 2100, Mw 30,000), and 1,2,4,5‐benzenetetracarboxylic acid (BTCA), were either added to the solution before or during deposition. In the presence of 100 ppm of one of the three additives in solution, almost no scale was observed on the surface for at least 24 hours. In the presence of lower concentrations of PAA Mw 2100, only distorted calcite crystals were obtained while with PAA Mw 30,000 the polymorph was spherical vaterite. A mixture of calcite and vaterite was observed with the BTCA additive. Addition of the polymers inhibits further nucleation and growth even if added after partial deposition of CaCO₃ while BTCA has no effect once nucleation has started. The results indicate that the inhibit ion effect of the PAA polymers is due to adsorption on the electrode surface while the effect of BTCA is related to chelation of calcium ions in solution.     

A new family of ionic liquids based on the 1-alkyl-2-methyl pyrrolinium cation

Five new salts based on 1-alkyl-2-methyl pyrrolinium ion are reported, two involving the iodide ion and three involving the bis(trifluoromethanesulfonyl) amide ion. The iodide salts have melting points around 100 °C, while the amide salts have melting points around room temperature. Two of the amide salts can be easily quenched into the glassy state and exhibit glass transition temperatures around −70 °C. The 2-methyl pyrrolinium cation bears structural similarities to the aromatic imidazolium cations on one hand and the cyclic ammonium cation family based on the pyrrolidinium cation on the other. The properties of the salts reported here are compared within these two related families of salts.     

天津钢管公司DRC直接还原厂生产工艺与自动控制

天津钢管公司DRC直接还原厂将采用英国戴维国际工程公司的DRC煤基直接还原技术,以铁矿石、煤、石灰石为原燃料,用回转窑来生产直接还原铁(DRI)。该厂将由两条回转窑生产线组成,每条生产线的生产能力为15万tDRI/年,回转窑规格为φ5.0m×80m。工厂生产主线将采用计算机集散控制系统(DCS)以实现对生产过程的自动控制。