一种基于MPEG-2的立体视频编码中的视差匹配快速算法

高效，快速的视差匹配是立体视频处理中的一项关键技术。本文在分析立体图像序列的视差矢量与运动矢量之间的相关性的基础上，提出一种基于MPEG-2的立体视频编码中的视差匹配快速算法。实验结果表明，与全搜索法相比，在保证重建图像质量的前提下，快速算法能显著降低视差估计的计算复杂度。     

潮汐河口平面二维非恒定流数值模拟

本文基于三角形网格划分，采用有限元法，建立了平面二维非恒定潮流数学模型。采用了质量集中、压缩存储的处理方法和“预估校正”的时间推进算法，较好地解决了有限元计算存储量和计算速度问题。对长江口南北支河段进行了验证计算，结果表明模型能较好模拟长江口南北支河段的潮流运动情况，且计算稳定性好、速度快、精度高。     

Effect of the Liquid-Phase Characteristic on the Microstructures and Dielectric Properties of Donor- (Niobium) and Acceptor- (Magnesium) Doped Barium Titanate

Changes in the microstructure and dielectric properties with the variation of the donor/acceptor ratio in BaTiO₃ ceramics were investigated. In donor-rich specimens, a liquid that appeared during sintering did not penetrate into grain boundaries. However, in the acceptor-rich specimens, the grains were separated by a liquid film during sintering. The much higher mobility of the liquid film than that of the grain boundaries was suggested to cause extensive grain growth in acceptor-rich BaTiO₃. The macroscopic homogenization of dopants because of grain growth in acceptor-rich specimens resulted in changes in the dielectric properties.     

Effect of material and process parameters on the mechanical properties of unidirectional and multidirectional flax/polypropylene composites

Unidirectional (UD) and multidirectional (MD) flax/polypropylene composites were studied. Flax with varying retting degree and boiled flax was used as reinforcement for the UD composites and unmodified and maleic acid anhydride modified polypropylene (MAA-PP) was used as matrix. Multidirectional flax/polypropylene composites were manufactured on laboratory scale and on pilot scale. They were made from needle-punched hybrid flax/PP non-wovens. Normally retted flax as well as boiled flax was used. For the specimens made on pilot scale, a third kind of flax, namely bleached flax was also studied. The influence of different process times and temperatures on the mechanical properties of the composites was analysed. Generally, the composites have adequate good mechanical properties. The unidirectional composites of boiled flax combined with MAA-PP show the best mechanical properties. Contrary to the UD composites, flax treatment did not lead to the expected property improvements for MD composites.     

TiO2纳米薄膜的微结构控制

通过有机酸修饰的水基so1-gel法，分别制备了由层状、针形和球形纳米粒子构成的纳米二氧化钛薄膜，采用SEM、XRD、红外光谱进行了表征.研究发现，调节水解过程中钛酸四丁酯：醋酸的摩尔比，可以控制薄膜的微结构，并对其机理进行了分析.该方法可以应用于sol-gel法制备其他纳米薄膜过程中的材料微结构控制.     

铜铟铋硫对Sn-Ag基无铅焊料性能的影响

研究了Cu、In、Bi、S元素对Sn-Ag基无铅焊料熔点和铺展性的影响。结果表明:Sn-Ag-Cu三元合金成分为95.5%Sn3.5%Ag1%Cu时具有较低熔点(215℃)和好的铺展性;加入适量的In可降低Sn-Ag合金的熔点和改善铺展性能;随w(Bi)的增加Sn-Ag-Bi三元合金的熔点降低、铺展性变好;Sn-Ag合金的熔点随w(S)的增加而升高,加入少量S能改善Sn-Ag合金的铺展性。     

利用单片机80c196kc实现等间隔采样及采样值的回显

本文主要介绍以单片机80c196kc为CPU对模拟信号进行等间隔采样以及实现对采样值回显的问题。详细介绍了测频软件及电路的实现，对等间隔采样软件实现进行了详细论述：详尽讨论了对于MG-12864-2液晶显示器的电路连接与软件控制方法；对MG-12864-2液晶显示器应用的独特之处做了细致的分析。     

光纤码分多址技术在城域接入网中的应用

分析了光纤码分多址技术O -CDMA在城域接入网中的应用。回顾了O -CDMA技术的发展历史 ,详细地介绍了O -CDMA技术的特点 ,其具有的公平性、灵活性、网络控制管理、对服务区处理能力以及高的安全性使O -CDMA技术成为较好的城域接入网技术。阐述了目前在应用中O -CDMA存在的一些技术方面的问题     

PE/PP共混物卷绕丝微观结构的研究

用透射和扫描电子显微镜研究PP/PE共混物在熔融纺丝时 ,PE掺入对PP结构的影响。研究结果表明 :PE与PP存在一定程度的相互作用 ,PP中加入PE能改变卷绕丝中PP结晶结构 ;PP中加入质量分数低于 10 %的PE时可以顺利纺丝 ,所得的卷绕丝断裂伸长率较大 ,具有良好的可拉伸性     

On connections between 3-d microstructures and their 2-d images

The problem of recovery of three-dimensional microstructural parameters from two-dimensional images is addressed in its inverse form. Three-dimensional inhomogeneous solids with known microstructures are generated virtually and images of their cross-sections are analyzed. Three different types of randomly oriented microcracks and microcracks having preferential orientation with some scatter. Somewhat unexpected result is that, in all the cases considered, three-dimensional defect densities are very close to average values of corresponding two-dimensional parameters.