Modeling of Diffusion in Capillary Porous Materials During the Drying Process

This paper presents a model of heterogenous diffusion in capillary porous materials during the process of drying. The governing heat and mass transfer equations have been established using the liquid as well as vapor flow. Two models have been presented. Model 1 does not consider the heat conduction while the model 2 has been established by considering the conduction. The developed models and the numerical solutions of the resulting differential equations can take into account the moisture and temperature dependent thermophysical properties of the product. All equations have been established in spherical coordinates but the programme written for the purpose of calculations can be used for other geometries also. Numerical calculations have been performed for gas concrete and tiles using model 1, while model 2 has been used for gas concrete only because of the lack of data for thermophysical properties of the tile. For gas concrete it was seen that conduction has only marginal effect on the drying process and the numerical predictions of the drying process were reasonably accurate.     

ATMOSPHERIC DEPOSITION OF CHEMICAL SPECIES TO POLAR SNOW

Particles and gases can deposit from the atmosphere to polar snow by several mechanisms. Dry deposition can be considered to consist of three steps: aerodynamic transport from the free atmosphere to the viscous sublayer near the surface, boundary layer transport across the sublayer, and interactions with the surface. The particle dry deposition mass flux is dominated by the largest particles present in a size distribution. Wet deposition includes in-cloud and below-cloud scavenging, where the former refers to uptake of particles during nucleation of cloudwater as well as scavenging of particles and gases by existing droplets and ice crystals. Of all the wet deposition mechanisms, nucleation scavenging is often the most important mechanism for particles in the polar regions. Finally, incorporation of particles and gases into fog droplets and subsequent settling of the fog to the snow surface can be an important removal process in regions of frequent fog. For Summit, Greenland, the total deposition of MSA, SO₄^2-, Na⁺, K⁺, and Ca²⁺ during May 24-July 13, 1993 was dominated by wet deposition: this mechanism accounted for an average of 62% of the total deposition for these species. Fog and dry deposition accounted for 21% and 17% of the total, respectively. These results suggest that all three mechanisms may need to be considered when estimating total deposition of certain chemical species to polar snow.     

三峡水库减淤增容调度方式研究——多汛限水位调度方案

本文建议在汛期中小流量时（Q<35000m3/s），将坝前水位维持在148～151m；出现汛情且流量更较大后，将坝前水位降低到143m；入库流量大于35000m3/s且短期预报将出现大于十年一遇洪水时，预泄洪水到135m.按这一调度，汛期约80％时间可以维持在较高水位，一般洪水期。汛限水位143m不影响坝区通航，135m水位迎洪可大量增加防洪库客。到100年后可减淤30亿m3，增加防洪库容约40亿m3.变动回水区减淤40%，优化了坝区水沙搭配，可改善通航条件。降低库区洪水位，缓解防洪与移民的矛盾。可对发电带来较大好处：提高发电效益，减少粗沙过机。初期水库排沙比大于原方案，可减轻下游冲刷。同时，可减小三峡汛初泄水与鄱阳湖防洪的矛盾。     

孤岛油田西区聚合物驱开发研究

孤岛油田西区注聚区1997年3月投入注聚后，高渗层得到有效封堵，吸水剖面得到明显改善。注聚期间，通过实施注聚区外围水井降水或停注、油井放大生产压差和调整注聚井注入速度等开发措施，扩大了聚合物波及体积，聚合物驱取得了明显效果。     

Skeletal Isomerization and Inter—molecular Hydrogen Transfer Reactions in Catalytic Cracking

Bimolecular hydrogen transfer and skeletal isomerization the important secondary reac-tions among catalytic cracking reactions,which affect product yield distribution and product quality,Catalyst properties and operating parameters have great impact on bimolecular hydrogen transfer and skeletal isomerization reactions .Bimolecular hydrogen transfer activity and skeletal isomrization activity of USY-containing catalysts are higher thn that of ZSM-5-containing catalyst.Coke deposition on the active sites of catalyst may suppress bimolecular hydrogen transfer activity and skeletal isomer-ization activity of catlys in different degrees.Short raction time causes a decrease of hydrogen trans-fer reaction,but and increase of skeletal isomerization reaction compared to cracking reaction in catalytic cracking process.     

用化学腐蚀制备多孔硅太阳电池减反射膜的研究

采用HF HNO3溶液化学腐蚀 ,在硅片上制备减反射效果优良的多孔硅太阳电池减反射膜 ,借助原子力显微镜 (AFM)和X光电子谱 (XPS)对其表面形貌和成分进行观察 ,发现该膜与电化学阳极腐蚀得到的多孔硅具有相似性 ,其主要成分为非化学配比的硅的氧化物SiOx(X <2 )。采用带积分球的光度分光计 ,测得形成多孔硅减反射膜后 ,硅片表面反射率大大下降 ,,在波长 330～ 80 0nm范围反射率只有 1 5～ 2 9%。研究指出这种强减反射作用 ,与多孔硅具有合适的折射率及其多孔特性的光陷阱作用有关     

碳/碳复合材料CVI工艺中热解碳形成机理的研究

对碳碳复合材料CVI或（CVD）工艺中热碳组织的类型，沉积机理等研究情况进行了简要的综述，并对其进一步研究提出了相应观点。     

氧化铝生产过程结疤溶解的研究

针对氧化铝生产过程结疤现象。研制出一种新型清洗溶剂，溶垢率可达95%，清洗效果达到《工业设备化学清洗质量标准》要求。     

化学镀非晶态Ni—B合金的研究

本文通过化学镀方法在铜和钢上沉积非晶态Ni-B合金。着重讨论了还原剂浓度、络合剂浓度对化学镀沉积速率的影响;分析了它的耐蚀原因和其显微硬度随退火温度的变化情况并就其应用和发展略作说明。     

三水草酸铀酰的红外激光化学

文章研究了三水草酸铀酰(UO_2C_2O_4·3H_2O)在兆瓦脉冲二氧化碳激光辐照下的红外激光化学反应,它与草酸铀酰的热分解反应不同,反应产物是二氧化铀和二氧化碳。反应的量子效率随激光波长不同而变化。