Methane/natural gas storage and delivered capacity for activated carbons in dry and wet conditions

Methane/natural gas storage and delivered capacity for three different activated carbons in dry and wet conditions were measured. In all tests the temperature of the bed was maintained constant at 277.15 K and pressure was increased up to 10 MPa. Natural gas storage capacity was less than methane storage capacity in dry conditions for all the three activated carbons tested, while the gas delivery was almost the same. One of activated carbon tested (NC120) showed the possibility of hydrate forming for pressures higher than 4 MPa but the amount of gas stored still was less than the amount stored in dry conditions over the whole range of pressure. The analysis of the gas delivered at each pressure steps shows that considerable amount of heavy components do not come out from the bed even at very low pressures in both dry and wet condition tests. Repeatability of the sorption/desorption processes - vital for possible commercial/industrial use - has been examined over various cycles.     

A disposable sensor based on immobilization of acetylcholinesterase to multiwall carbon nanotube modified screen-printed electrode for determination of carbaryl

A simple method has been devised for immobilization of acetylcholinesterase (AChE) covalent bonding to a multiwall carbon nanotube (MWNT)-cross-linked cellulose acetate composite on a screen-printed carbon electrode (SPCE) and a sensitive and disposable amperometric sensor for rapid determination of carbaryl pesticide is proposed. The immobilized enzyme was preserved on this film because of the excellent biocompatibility and non-toxicity of cellulose acetate. Based on the inherent conductive properties of the MWNT, the immobilized AChE had greater affinity for ATCl and excellent catalytic effect in the hydrolysis of ATCl. MWNT improved the interface enzymatic hydrolysis reaction and increased the amperometric response of the sensor. Under optimum conditions, the inhibition of carbaryl on AChE increased linearly with the increasing concentration of carbaryl in two ranges, from 0.01 to 0.5 μg mL⁻¹ and from 2 to 20 μg mL⁻¹, with the correlation coefficients of 0.9985 and 0.9977, respectively. The detection limit was 0.004 μg mL⁻¹ taken as the concentration equivalent to 10% decrease in signal. The sensor showed acceptable stability, accuracy and could be fabricated in batches, thus it is economic and portable. This type of disposable enzyme-based amperometric sensor has extensive application potential in environmental monitoring of pesticides.     

Influence of pencil lead hardness on voltammetric response of graphite reinforcement carbon electrodes

This work studied the voltammetric response of graphite reinforcement electrodes made of different pencil lead hardness. The studies showed that harder graphite leads, regardless of their manufacturer, are more appropriate as electrode material for voltammetric purposes due to their higher peak currents, increasing sensitivity and reproducibility, with ΔEp closer to the theoretical value for a reversible system.     

Polyaniline-multiwalled carbon nanotube composites: Characterization by WAXS and TGA

Polyaniline/carboxylated multi-walled carbon nanotube (PAni/c-MWNT) nanocomposites have been synthesized by micellar aided emulsion polymerization with various c-MWNTs compositions, viz., 0.5, 1, 5, and 10 wt %. The microcrystalline parameters such as the nanocrystal size (〈N〉), lattice strain (g), interplanar distance (d_hkl), width of the crystallite size distribution, surface weighted crystal size (D_s), and volume of the ordered regions were calculated from the X-ray data by using two mathematical models, namely the Exponential distribution and Reinhold distribution methods. The effects of heat ageing on the microcrystalline parameters of the PAni/c-MWNT nanocomposites were also studied and the results are correlated. The thermal stability and electrical resistivity of the PAni/c-MWNT nanocomposites were examined with thermogravimetric analysis (TGA) and a conventional two-probe method. The TGA data indicate that the thermal stability of the nanocomposites improved after the incorporation of c-MWNTs. The influence of temperature on the resistivity of the nanocomposites was also measured. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci 2008     

130t RH脱碳模型建立及超低碳钢处理工艺优化

建立了RH真空处理脱碳数学模型，并通过130t RH工业试验结果对此数学模型加以验证。根据模型分析了[C]0、[O]0、真空度、提升气体流量等对脱碳效果的影响，据此优化了处理工艺，取得较好的效果。     

剖析全板电镀镍金发白现象

简要介绍了全板电镀镍金加工过程中镀金面发白现象及改善措施。特别是针对高位发白(或粗糙)的产生原因和处理过程进行较为详细的描述,并对工艺在此处理过程中存在问题进行了简要剖析。     

Continuous hydrogen evolution from cyclohexanes over platinum catalysts supported on activated carbon fibers

The continuous production of hydrogen from cyclohexanes is achieved effectively using Pt/ACF (ACF = activated carbon fiber) catalysts in a fixed-bed flow reactor. The Pt catalysts are more effective than a Pd/ACF catalyst for the reaction. Besides cyclohexane, methylcyclohexane, 1,4-dimethylcyclohexane, and p-menthane can also be employed as hydrogen source in the reaction system.     

Laboratory simulated slipstream testing of novel sulfur removal processes for gasification application

The Wabash River Integrated Methanol and Power Production from Clean Coal Technologies (IMPPCCT) project is investigating an Early Entrance Coproduction Plant (EECP) concept to evaluate integrated electrical power generation and methanol production from coal and other carbonaceous feedstocks. Research, development and testing (RD&T) that is currently being conducted under the project is evaluating cost effective process systems for removing contaminants, particularly sulfur species, from the generated gas which contains mainly synthesis gas (syngas), CO₂ and steam at concentrations acceptable for the methanol synthesis catalyst. The RD&T includes laboratory testing followed by bench-scale and field testing at the SG Solutions Gasification Plant located in West Terre Haute, Indiana. Actual synthesis gas produced by the plant was utilized at system pressure and temperature for bench-scale field testing.     

高滴熔点微晶蜡中碳数分布的测定

采用冷柱头进样的高温气相色谱技术,建立了测定高滴熔点微晶蜡中正构和非正构烃类含量及碳数分布的方法。对滴熔点在90℃以下的微晶蜡进行测定。实验表明,使用大口径高温毛细管柱可以分析碳数在72以下的微晶蜡。方法快速,准确,实用性强。     

真空碳热还原法制备高密度碳化钒

研究了采用真空碳热还原法由三氧化二钒制备碳化钒，并研究了碳化钒产物密度随实验条件的变化规律。找到了用于强化碳化钒产物密度的添加剂，研究结果表明，反应温度，添加剂是影响碳化钒产物密度的主要因素。反应时间对产物密度也有一定影响。研究结果同时表明，含铁化合物能有效地提高产物密度。