氯乙酸生产工艺的改进与探讨

介绍了影响氯乙酸质量、消耗的因素,探讨了对氯乙酸工艺的改进措施。     

电除尘器出口烟气废热的利用

介绍了采用热管锅炉回收硫酸系统电除尘器出口烟气废热情况，可回收废热生产0．8MPa饱和蒸汽1．0t/h。通过严格控制饱和蒸汽压力、炉气的三氧化硫含量及入炉原料的水分含量，热管锅炉连续运行两年未发生泄漏。运行一年即可收回成本，经济效益显著。     

甲苯三氧化硫磺化反应抑制副产物二甲苯砜的研究

对SO3磺化甲苯反应的副产物二甲苯砜成因及反应历程进行了分析,通过实验比较了醋酸与二甲苯砜的抑制效果,提出用磺化副产物二甲苯砜自身抑制的新方法.考察了二甲苯砜力入量和甲苯转化率对抑制副反应的影响.反应温度:10℃,三氧化硫:6%,甲苯转化率为35%时,外加甲苯质量3.3%的二甲苯砜就能控制二甲苯砜含量不增加,且甲苯磺酸异构体的对位含量由84%上升到89%,间位含量由2.5%下降到1%.     

新型层状表面相锆基固体酸催化酯化反应研究

将所研制的层状表面相锆基固体酸催化剂用于一元、二元醇醋酸酯和其他羧酸酯类产品的合成 ,考察了其催化性能。研究发现 :层状表面相锆基固体酸催化剂对所考察的酯化反应具有很好的普遍适用性 ,但其酯化率与醇的性质和结构密切有关。催化反应动力学研究表明乙酸与丁醇、戊醇、己醇的酯化反应均为二级反应 ,且反应活化能均较低 ,分别为 47 4kJ/mol、2 3 3kJ/mol和 19 8kJ/mo     

锌精矿制酸三级旋风除尘器的设计与实践

介绍了锌精矿制酸系统采用三级旋风除尘器替代电除尘器的设计及运行情况。为了提高旋风除尘器的除尘效率，硫酸系统各工序作了适当调整。运行实践表明，三级旋风除尘器除尘效果良好，硫酸系统能长期稳定运行。     

耐盐性树脂PAA的合成及应用研究

以丙烯酸-丙烯酰胺为单体，过硫酸钾为引发剂，N，N-亚甲基双丙烯酰胺为交联剂。水浴阶梯升温共聚合成耐盐性树脂，采用正交试验通过分析，研究了主要因素对产物性能的影响，确定较佳反应条件：T=50℃(2h)～65℃(3h)，单体配比nAM：nAA=1：11，单体中和度[N]=90％～95％。引发剂浓度[I]=0．3％，单体浓度[M]=30％～35％，交联剂浓度[C]=0．025％～0．03％，并将此树脂作为缓释剂应用于固载二氧化氯中，取得了良好的效果。     

熔融缩聚法制备聚乳酸

通过熔融缩聚法制备了聚乳酸。探讨了反应温度、催化剂类型及用量、反应时间对聚乳酸的影响，并用红外光谱和1↑H NMR对聚合物进行了表征。结果表明，最佳的反应条件为：聚合时间30h左右、聚合温度160℃、以O．2％的对甲苯磺酸作为酸催化剂、O．5％的氯化亚锡为催化剂、真空度为O—1333Pa；而提高乳酸纯度是制备高摩尔质量聚乳酸的关键条件之一。     

脂肪醇聚氧乙烯醚的厌氧与好氧生物降解性

以脂肪醇聚氧乙烯醚(AEO)为目标污染物，在等同条件下做厌氧消化污泥和好氧活性污泥对其生物降解性能的对比实验，得出了同一系列AEO分子中聚氧乙烯基与整个分子的降解难易程度的关系。表明：①污泥会对AEO分子产生吸附一脱附作用而出现假降解率，克服假降解率的干扰是准确测定AEO生物降解性的关键因素；②厌氧和好氧条件下，AEO均可降解，但厌氧降解要稍优于好氧降解；③AEO中聚氧乙烯基的单元数(n)是影响其生物降解的重要因素，相同碳链的直链烷基，生物降解率随n的增加而明显降低。     

Synthesis of Biodiesel from Soybean Oil using Heterogeneous KF/ZnO Catalyst

Biodiesel was produced by transesterification of soybean oil with methanol using ZnO loaded with KF as a solid base catalyst. It was found that the catalyst with 15 wt.% KF loading and calcined at 873 K showed the optimum activity. XRD, IR and Hammett indicator method were employed for the catalyst characterization. The results showed the activity of the catalysts was correlated with their basicity. The influence of various reaction variables on the conversion was also discussed.     

Raman spectroscopic study of conformational changes in the amorphous phase of poly(lactic acid) during deformation

The conformational distribution change of amorphous poly(lactic acid) (PLA) induced by deformation has been studied using Raman spectroscopy. Spectroscopic features associated with the rotational isomeric states (ttt, ttg′, tg′t, tg′g′) have been established experimentally and supported by normal coordinate analysis. Deformation induced a significant increase in the most favorable tg′t conformation. Based on the relative intensities of Raman-active skeletal modes, a quantitative method has been developed that can be used to elucidate structural changes in a variety of deformed polymer samples. For biaxially oriented PLA films, the overall tg′t conformation increased from the 76% in undeformed sample to a value as high as 92%. The change in conformational distribution in the amorphous phase follows a different trend (76-88%) as compared to the increase in sample crystallinity (0-43%). A large change in amorphous chain conformation occurred at relatively low draw ratios. In contrast, the large change in the degree of crystallinity occurred at higher draw ratios.