并行MLFMA分布层的构造及其负载均衡

研究了并行多层快速多极子算法（MLFMA）的分布层,提出了一种衡量其负载不均衡程度的方法,并在此基础上提出了分布树的一种新的构造算法。通过预先估算按分布层的不同层均分所得分布层的负载不均衡度,选取了一种负载不均衡度较小的方法来构造分布树。实验结果表明,该算法相比传统的按分布层的最细层均分所得分布树的算法,能更为有效地提高整个多层快速多极子算法的并行效率。     

On the determination of the steady film profile for a non-Newtonian thin droplet

A shooting method is used to determine a solution to a third-order ODE modeling the steady profile of a non-Newtonian thin droplet. We compare a direct approach to an iterative approach using a secant method. We obtain a nonlinear relationship between the contact angle ? and the position of the contact line r. From this nonlinear relationship we use curve fitting to obtain an empirical law of the form tan?∝r^f(k) where k is the power law coefficient and f is a nonlinear function of k.     

Fabrication of ultraviolet photoconductive sensor using a novel aluminium-doped zinc oxide nanorod-nanoflake network thin film prepared via ultrasonic-assisted sol-gel and immersion methods

Unique and novel thin films with aluminium (Al)-doped zinc oxide (ZnO) nanostructures consisting of nanorod-nanoflake networks were prepared for metal-semiconductor-metal (MSM)-type ultraviolet (UV) photoconductive sensor applications. These nanostructures were grown on a glass substrate coated with a seed layer using a combination of ultrasonic-assisted sol-gel and immersion methods. The synthesised ZnO nanorods had diameters varying from 10 to 40 nm. Very thin nanoflake structures were grown vertically and horizontally on top of the nanorod array. The thin film had good ZnO crystallinity with a root mean square roughness of approximately 13.59 nm. The photocurrent properties for the Al-doped ZnO nanorod-nanoflake thin films were more than 1.5 times greater than those of the seed layer when the sensor was illuminated with 365 nm UV light at a density of 5 mA/cm². The responsivity of the device was found to be dependent on the bias voltage. We found that similar photocurrent curves were produced over eight cycles, which indicated that the UV sensing capability of the fabricated sensor was highly reproducible. Our results provide a new approach for utilising the novel structure of Al-doped ZnO thin films with a nanorod-nanoflake network for UV sensor applications. To the best of our knowledge, UV photoconductive sensors using Al-doped ZnO thin films with a nanorod-nanoflake network have not yet been reported.     

Effect of aluminium doping on structural and gas sensing properties of zinc oxide thin films deposited by spray pyrolysis

A facile spray pyrolysis route is used to deposit aluminium doped ZnO (AZO) thin films on to the glass substrates. It is observed that on aluminium doping the particle size of ZnO reduces significantly; moreover, uniformity of particle also gets enhanced. Their XRD study reveals that intensity ratio of crystal planes depend on the aluminium doping concentration. The gas response studies of; ∼800 nm thick Al-doped ZnO films at different operating temperatures show that 5 at% Al-doped ZnO thin film exhibits highest response towards H₂S gas at 200 °C. The results suggest that the gas response strongly depends on the particle size and aluminium doping in the ZnO.     

In2O3 + xBaO (x = 0.5-5 at.%) - A novel material for trace level detection of NOx in the ambient

Indium oxide (In₂O₃) doped with 0.5-5 at.% of Ba was examined for their response towards trace levels of NO_x in the ambient. Crystallographic phase studies, electrical conductivity and sensor studies for NO_x with cross interference for hydrogen, petroleum gas (PG) and ammonia were carried out. Bulk compositions with x ≤ 1 at.% of Ba exhibited high response towards NO_x with extremely low cross interference for hydrogen, PG and ammonia, offering high selectivity. Thin films of 0.5 at.% Ba doped In₂O₃ were deposited using pulsed laser deposition technique using an excimer laser (KrF) operating at a wavelength of (λ) 248 nm with a fluence of ∼3 J/cm² and pulsed at 10 Hz. Thin film sensors exhibited better response towards 3 ppm NO_x quite reliably and reproducibly and offer the potential to develop NO_x sensors (Threshold limit value of NO₂ and NO is 3 and 25 ppm, respectively).     

Effect of soft-hard segment structure on vapor responsiveness of polyurethane conducting composite thin films loaded with multi-walled carbon nanotubes

A series of multi-walled carbon nanotubes/polyurethane (MWNTs/PU) composite conducting dispersoids were prepared via an in situ coupling reaction among linear hydroxyl-terminated polymer diols, 1,6-hexamethylene diisocyanate (HDI) and various chain extenders. The composite conducting thin films were formed by spin-coating and depositing the dispersoids onto comb-like electrode substrates. The resulting structure and the dispersion quality of MWNTs in the dispersoids were examined by means of FTIR, XRD, TEM, SEM and UV-vis analyses. The response of the as-prepared films toward some volatile organic solvent vapors such as benzene, anhydrous ether, acetone and chloroform was evaluated. The experimental results indicated that the composite conducting films constructed by hydroxyl-terminated poly(butadiene-co-acrylonitrile), trimethylolpropane, and MWNTs-OH bear better vapor responsiveness. The dispersion behavior of MWNTs in the dispersoids, types of MWNTs and soft-hard segmental compositions are believed to be closely related with the sensing properties of the films. In particular, the chemical linkage of MWNT-OH with HDI in the PU matrix is expected to improve the dispersivity and further to enhance the sensing properties of the composite sensors. The vapor sensing properties well reveal that these materials have a possibility as a candidate of volatile organic solvent vapor sensors.     

改进颜色融合的医学图像彩色化技术

彩色化后的医学图像能清晰体现患者病灶信息有利于医患沟通。提出改进颜色融合的医学图像彩色化方法,首先利用基于KNN的图像前背景区分算法,强化病灶区域的边界信息;然后以此为约束条件,只需提供简单的着色输入;最后将边界能量引入颜色融合方法,得到较好的着色结果。着色图像保持了原图的灰度信息不变,增加了彩色标记图像的颜色和真实感。实验结果表明,该算法具有较高的精确度,可有效的应用于医学图像彩色化处理。     

The thin plate spline robust point matching (TPS-RPM) algorithm: A revisit

This paper reviews the TPS-RPM algorithm (Chui and Rangarajan, 2003) for robustly registering two sets of points and demonstrates from a theoretical point of view its inherent limited performance when outliers are present in both point sets simultaneously. A double-sided outlier handling approach is proposed to overcome this limitation with a rigorous mathematical proof as the underlying theoretical support. This double-sided outlier handling approach is proved to be equivalent to the original formulation of the point matching problem. For a practical application, we also extend the TPS-RPM algorithms to non-rigid image registration by registering two sets of sparse features extracted from images. The intensity information of the extracted features are incorporated into feature matching in order to reduce the impact from outliers. Our experiments demonstrate the double-sided outlier handling approach and the efficiency of intensity information in assisting outlier detection.     

铁道钢轨断面的计算机图象处理与仿真

利用计算机图象处理和仿真技术,对铁道钢轨断面进行快速检测与处理的研究。     

A new dynamic hydrogen reference electrode for applications in thin-film sensor systems

The realization and applicability of a new dynamic hydrogen reference electrode (DHRE) within an electrochemical microcell for sensor applications is reported. The electrodes are fabricated in thin-film technology and fixed within a flow-through device. An experimental setup for accurate electrochemical potential measurements is described. Smooth platinum, platinized platinum and pHEMA coated electrodes are investigated with regard to their initialization behavior, stability, reproducibility and interference with electrolytes. It is found that platinized platinum DHREs show excellent stability and reproducibility. For uncoated electrodes, the electrochemical potential is established within seconds. The potential is independent of the pH value within the range of pH 4–10. Interference with sulfate and phosphate is observed. Thus, the platinized platinum DHRE is well suited for bioanalytical sensor applications, where the pH value is buffered and the concentrations of the disturbing anions are constant or very low.