NUMERICAL ANALYSIS AND EXPERI- MENT OF UNSTEADY THERMAL FIELD OF ROTOR PLATE FOR EDDY CURRENT RETARDER

The physical model based on heat transfer theory and virtual boundary method for analyzing unsteady thermal field of rotor plate for eddy current retarder used in automobile is established and boundary conditions are also defined. The finite element governing equation is derived by Galerkin method. The time differential item is discrete based on Galerkin format that is stable at any condition. And a new style of varying time step method is used in iteration process. The thermal field on the rotor plate at the radial and axle directions is analyzed and varying temperature at appointed points on two side-surfaces is measured. The testing and analytical data are uniform approximately. Finite element method can be used for estimating thermal field of the rotor plate at initial design stage of eddy current retarder.     

三维有限元法分析频率对接地电阻的影响

提出了用涡流场的A-V有限元分析方法计算接地系统接地电阻的方法,分析了入地电流频率的变化对接地电阻的影响。计算结果表明,频率对接地体自身电阻的影响较大,但对散流电阻的影响很小。     

ESR Refining Potential for Titanium Alloys using a CaF2‐based Active Slag

Since the end of the Cold War and due to the needs to produce titanium more cost‐efficient and thus more attractive for its civilian use, the electroslag remelting (ESR) process has become an increasingly important topic of international research programmes, because titanium and titanium aluminides can be chemically refined by ESR in some degree. Using ESR, titanium turnings from machining steps and scrap from foundries can be remelted, refined and provided as secondary titanium for the market at relatively favourable prices. This article investigates the removability of the main impurities out of titanium and titanium‐aluminium alloys by electroslag remelting using the active slag system CaF₂‐Ca‐(CaO). Thermochemical and kinetic aspects of the ESR process are considered.     

钛铁矿流态化氧化机理研究

对低品位钛铁矿进行预氧化、预还原等预处理后可满足硫酸法生产钛白粉工艺所需高品位钛铁矿的要求。本试验采用流态化预氧化方法处理风化程度低、含硫较高的钛铁矿。结果表明 :流态化氧化可大幅度地降低钛铁矿中硫含量 ;钛铁矿流态化氧化的适宜温度为 :80 0～ 90 0℃ ,且在此温度范围内 ,随温度的升高 ,钛铁矿的氧化速度增加 ,在 90 0℃时 ,5 0min钛铁矿基本能完成氧化     

三相异步电动机运行指标的分析

利用电机学理论分析了影响电机起动转矩、起动电流、最大转矩和最小转矩的因素。     

高速电路中地电流的影响及其对策

从理论上分析了产生地电流干扰的原因，从而在实践上提出了一些经常被忽略，却是行之有效的方法来减小地电流的干扰，设计出高质量的电路。     

主电机轴瓦异常情况分析解决办法

介绍南钢中板厂四辊轧机主电机轴瓦一种非典型故障现象，原因分析及解决办法，提出了对类似问题个人见解。     

万用表电压测量法查找直流接地故障

直流电源是发电站的主要设备，一旦直流系统发生接地故障，将会严重地危及到发电站的安全和经济运行。因此，本文介绍一种简单易行，能快速找出直流接地点的方法一万用表电压测量法。     

Rutile-type TiO2 thin film for high-k gate insulator

We investigated rutile-type titanium dioxide (TiO₂) films for possible use as a high-k gate insulator. The TiO₂ thin films were directly deposited on Si substrates using a RF magnetron sputtering method with a sintered oxide target. A single phase of rutile-type TiO₂ whose dielectric constant of approximately 75 was obtained when the film was deposited in an inert gas atmosphere and annealed at 800 °C in an oxidizing gas atmosphere. The oxygen ions were deficient in the as-deposited film, and consequently, a sufficient oxygen supply was needed to crystallize the film to a single phase of rutile during the post-annealing. However, the interfacial SiO₂ layer between the TiO₂ and the Si substrate simultaneously grew thicker than 2 nm. As the interfacial SiO₂ grew, the leakage current was decreased and the equivalent oxide thickness was increased, in the Au/rutile-type TiO₂/Si capacitor. Therefore, we concluded that the growth of the interfacial SiO₂ layer thicker than 2 nm is inevitable to form the single phase of rutile-type TiO₂ and to decrease the leakage.     

无磷洗涤剂的现状及存在问题

含磷洗涤剂中含的“磷”主要是STPP，作用很大但对环境的危害也很大，它是造成地表水体出现富营养化的重要原因之一，所以许多地方政府都在实行“禁磷”——禁止销售、使用含磷洗涤剂。现在我国使用的无磷洗涤剂中代磷助剂主要有3种，其中4A沸石用量最大，但它会对环境带来新的问题。主要介绍了含磷洗涤剂的危害及无磷洗涤剂的应用现状，指出了我国禁磷后将面临的问题。