Ozone-Based Advanced Oxidation Processes for the Decomposition of N-Methyl-2-Pyrolidone in Aqueous Medium

The present study investigates the decomposition of N-Methyl-2-Pyrolidone (NMP) using conventional ozonation (O₃), ozonation in the presence of UV light (UV/O₃), hydrogen peroxide (O₃/H₂O₂), and UV/H₂O₂ processes under various experimental conditions. The influence of solution pH, ozone gas flow dosage, and H₂O₂ dosage on the degradation of NMP was studied. All ozone-based advanced oxidation processes (AOPs) were efficient in alkaline medium, whereas the UV/H₂O₂ process was efficient in acidic medium. Increasing ozone gas flow dosage would accelerate the degradation of NMP up to certain level beyond which no positive effect was observed in ozonation as well as UV light enhanced ozonation processes. Hydrogen peroxide dosage strongly influenced the degradation of NMP and a hydrogen peroxide dosage of 0.75 g/L and 0.5 g/L was found to be the optimum dosage in UV/H₂O₂ and O₃/H₂O₂ processes, respectively. The UV/O₃ process was most efficient in TOC removal. Overall it can be concluded that ozonation and ozone-based AOPs are promising processes for an efficient removal of NMP in wastewater.     

Effect of crosslinkers on the preparation and properties of ETFE‐based radiation‐grafted polymer electrolyte membranes

This study concerns a comparative study of three crosslinkers, divinylbenzene (DVB), 1,2‐bis(p,p‐vinylphenyl)ethane (BVPE), and triallyl cyanurate (TAC) crosslinked poly(ethylene‐co‐tetrafluoroethylene) (ETFE)‐based radiation‐grafted membranes, which were prepared by radiation grafting of p‐methylstyrene onto ETFE films and subsequent sulfonation. The effect of the different types and contents of the crosslinkers on the grafting and sulfonation, and the properties such as water uptake, proton conductivity, and thermal/chemical stability of the resulting polymer electrolyte membranes were investigated in detail. Introducing crosslink structure into the radiation‐grafted membranes leads to a decrease in proton conductivity due to the decrease in water uptake. The thermal stability of the crosslinked radiation‐grafted membranes is also somewhat lower than that of the noncrosslinked one. However, the crosslinked radiation‐grafted membranes show significantly higher chemical stability characterized in the 3% H₂O₂ at 50°C. Among the three crosslinkers, the DVB shows a most pronounced efficiency on the crosslinking of the radiation‐grafted membranes, while the TAC has no significant influence; the BVPE is a mild and effective crosslinker, showing the moderate influence between the DVB and TAC crosslinkers. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 100: 4565–4574, 2006     

环氧丙烯酸光敏树脂的研制及应用

以环氧树脂和丙烯酸为原料,合成了紫外光固化环氧丙烯酸树脂,研究了投料比、反应时间、引发剂、阻聚剂的加入量与加料方式对反应程度的影响。用IR对环氧树脂与环氧丙烯酸树脂的结构进行了表征,并制备了紫外光固化胶。     

γ‐Irradiation effects on the thermal and structural characteristics of modified,grafted polypropylene

The effects of both the degree of grafting and γ irradiation on the thermal stability and structural characteristic of polypropylene‐graft‐polyvinylpyrrolidone and polypropylene‐graft‐polyvinylpyrrolidone modified with α‐cyano‐δ‐(2‐thienyl) crotononitrile were investigated. The employed techniques were thermogravimetric analysis, differential thermogravimetry, and X‐ray diffraction. The thermal stability of various polymeric substrates was investigated through the determination of the degradation temperature and activation energy of degradation. The effects of different parameters on the structural characteristics of different films were investigated through the determination of possible changes in the degree of ordering of the polymeric substrates. The results revealed that the thermal stability of the trunk polymer, grafted polymer, and polymer modified by α‐cyano‐δ‐(2‐thienyl) crotononitrile increased progressively with an increasing degree of grafting. The increase was, however, more pronounced for the sample undergoing the lowest degree of grafting. The activation energy of the thermal degradation process remained almost unchanged, and this indicated that the degradation processes of the different films followed almost the same mechanism. The γ irradiation at a dose of 60 kGy of the sulfur‐treated polymeric films [i.e., the polymeric films treated with α‐cyano‐δ‐(2‐thienyl) crotononitrile] reduced their thermal stability. This conclusion was reached by the consideration of the changes observed in the pre‐exponential factor of the Arrhenius equation due to different chemical and γ‐irradiation treatments. The degree of ordering, evidenced by X‐ray diffraction measurements of the trunk polymer, grafted polymer, and modified polymer, suffered a significant drop. This drop was much more pronounced for the sulfur‐containing polymeric materials. The observed drop in the degree of ordering of the polymeric substrates was taken as a measure of the structure collapse due to a certain treatment (degree of grafting and sulfur inclusion). The γ irradiation of the sulfur‐containing polymeric materials greatly increased their degree of ordering, which reached a value greater than that measured for the trunk polymer. Therefore, it was concluded that the thermal stability increased as the degree of ordering decreased. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 102: 506–515, 2006     

积层多层板用UV油墨的合成研究

采用丙烯酸改性环氧树脂E－44的方法，合成了环氧丙烯酸酯预聚物，并将其用在UV光固化油墨的配方中。在树脂合成过程中，研究了反应温度，催化剂，阻聚剂等因素对合 产品的影响。通过L9(3^4)正交试验，得到了优化的工艺参数：反应温度为90℃，催化剂为N，N－二甲苯胺，用量1％；阻聚剂对苯二酚，用量0．5％，投料环氧树脂和丙烯酸的摩尔比为1：1．08。     

The Chemistry of Water Treatment Processes Involving Ozone,Hydrogen Peroxide and Ultraviolet Radiation

Advanced oxidation processes are defined as those which involve the generation of hydroxyl radicals in sufficient quantity to affect water purification. The theoretical and (practical yield of OH from O₃ at high pH, 0₃/H₂0₂, O₃/UV and H₂O₂/UV systems is reviewed. New data is presented which illustrates the importance of direct photolysis in the O₃/UV process, the effect of the H₂0₂:0₃ ratio in the O₃/H₂O₂ process, and the impact of the low extinction coefficient of H₂O₂ in the H₂0₂/UV process.     

Photostabilization of cationic UV-cured coatings in the presence of nanoTiO2

The effect of TiO₂ nanoparticles for sun-weathering protection of UV-cured coatings is investigated. TiO₂ is either introduced in the form of nanoparticles in the photocurable formulations or generated in situ via sol–gel process. Cured films containing comparable amounts of TiO₂ were weathered for 800 h under UV irradiation and compared with free-TiO₂ coating. The TiO₂ presence induces a clear lower mass loss decrease during weathering as well as a lower gel content decrease. The TiO₂ screen effect is also confirmed by a lower alkyl-band reduction monitored by FT-IR during weathering. The TiO₂ generated in situ via sol–gel gives rise to transparent coatings without interfering with photopolymerization process and therefore without compromising UV-cured film properties.     

185nmUV降解水中4-CP、4-NP和RhB的研究

本文以对氯苯酚（4-cP）、对硝基苯酚（4-NP）和罗丹明B（RhB）为模型有机物（以4-CP和4-NP为小分子模型有机物，以RhB为大分子模型有机物），分别研究了185nmUV对水中这3种模型有机物的降解规律、性能和效果．研究结果表明，185nmUV直接对水中4-CP、4-NP和RhB有很好的降解效果．研究内容包括：185nmUV降解模型有机物的浓度、TOC（Totalorganic carbon）浓度、185nmUV降解模型有机物过程中溶液pH及电导率变化、以及降解模型有机物过程中产生的无机离子等几个方面．     

Preparation and characterization of a proton‐exchange membrane by the radiation grafting of styrene onto polytetrafluoroethylene films

Radiation‐induced simultaneous grafting of styrene onto polytetrafluoroethylene (PTFE) films and the subsequent sulfonation in the chlorosulfonic acid/dichloroethane were investigated. The effects of the main radiation grafting conditions, such as the type of solvents, irradiation dose, dose rate, the styrene concentrations, etc., on the degree of grafting (DOG) were studied. To elucidate the influence of both the grafting and sulfonation conditions on the properties of the PTFE‐g‐polystyrene‐sulfonic acid (PSSA) membranes, the sulfonation conditions, including the sulfonation temperature and the concentration of the ClSO₃H with respect to the DOG, were systematically evaluated. The grafted and sulfonated membranes were characterized by FTIR–ATR spectra, ion‐exchange capacity (IEC), water uptake, thickness measurement, etc. The as‐prepared PTFE‐g‐PSSA membranes in this work showed a good combination of a high IEC (0.85–2.75 meq g^?1), acceptable water uptake (8.86–56.9 wt %), low thickness, and volume expansion and/or contraction. © 2005 Wiley Periodicals, Inc. J Appl Polym Sci 99: 1415–1428, 2006     

Molecular motions of non-crystalline poly(aryl ether-ether-ketone) PEEK and influence of elecron beam irradiation

The dynamic mechanical relaxation of non-crystalline poly(aryl ether-ether-ketone) PEEK and the one irradiated with electron beam were studied. The three distinct γ, β, α′ relaxation maxima were observed in unirradiated PEEK from low to high temperature. It was revealed from the study on the irradiation effects that three different molecular processes are overlapped in γ relaxation peak, i.e., molecular motion of water bound to main chain (peak temperature; at ?100°C), local motion of main chain (at ?80°C), and local mode of the aligned and/or oriented moiety (at ?40°C). The β relaxation connected with the glass transition occurred at 150°C and it shifted to higher temperature by irradiation. The α′ relaxation which can be attributed to rearrangement of molecular chain due to crystallization was observed in unirradiated PEEK ～ 180°C and its magnitude decreased with the increase in irradiation dose. This effect indicates the formation of structures inhibiting crystallization such as crosslinking and/or short branching during irradiation. A new relaxation, β′, appeared in the temperature range of 40° to 100°C by irradiation and its magnitude increased with dose. This relaxation was attributed to rearrangement of molecular chain from loosened packing around chain ends, which were introduced into the non-crystalline region by chain scission under irradiation, to more rigid molecular packing, From these observations, we proposed that deterioration in mechanical properties of non-crystalline PEEK by high energy electron beam was brought about not only by chain scission but structural changes such as crosslinking and/or branching in the main chain.