Studies of influence of structural properties and thickness of NiO thin films on formaldehyde detection

The aim of the present work is to test the performance of nickel oxide (NiO) thin films to low concentrations of formaldehyde (HCHO). NiO thin films were deposited on alumina substrates by RF reactive magnetron sputtering in a mixed atmosphere of argon and oxygen. A Pt heating resistor was deposited on the reverse side for an accurate control of the operating temperature. Samples were annealed in synthetic air for 4 h at 700 °C in order to stabilise their microstructure. Two different thicknesses (150 and 300 nm) were deposited in order to study the influence of this parameter on both the microstructure and sensor response. Both XRD analysis and FEG-SEM images show a smaller grain size for the 150 nm-thick samples. The best operating temperature was established at 340 and 300 °C for 150 and 300 nm-thick samples respectively. A higher sensitivity was obtained for the samples of lower thickness for a set of HCHO concentrations ranging from 5 to 20 ppm. Moreover, the repeatability of the experiments was tested for the most sensitive samples.     

Automatic on-line monitoring of atmospheric volatile organic compounds: gas chromatography-mass spectrometry and gas chromatography-flame ionization detection as complementary systems

Traditionally air quality networks have been carrying out the continuous, on-line measurement of volatile organic compounds (VOC) in ambient air with GC-FID. In this paper some identification and coelution problems observed while using this technique in long-term measurement campaigns are described. In order to solve these problems a GC-MS was set up and operated simultaneously with a GC-FID for C₂-C₁₁ VOCs measurement.There are few on-line, unattended, long term measurements of atmospheric VOCs performed with GC-MS. In this work such a system has been optimized for that purpose, achieving good repeatability, linearity, and detection limits of the order of the GC-FID ones, even smaller in some cases. VOC quantification has been made by using response factors, which is not frequent in on-line GC-MS. That way, the identification and coelution problems detected in the GC-FID, which may led to reporting erroneous data, could be corrected.The combination of GC-FID and GC-MS as complementary techniques for the measurement of speciated VOCs in ambient air at sub-ppbv levels is proposed. Some results of the measurements are presented, including concentration values for some compounds not found until now on public ambient air VOC databases, which were identified and quantified combining both techniques. Results may also help to correct previously published VOC data with wrongly identified compounds by reprocessing raw chromatographic data.     

人为源VOC清单及重点工业贡献和治理分析

VOC的大量污染不仅不利于社会可持续发展,更为人们的生活和身体带来了严重的伤害,VOC治理问题迫在眉睫.基于此,本文以人为源VOC污染为研究对象,分析其污染特性,及人为源VOC清单排放特征,从整体排放、省份排放及地区排放特征对我国工业VOC排放的特征进行分析,结合当前所使用的人为源VOC治理的技术进行阐述.     

石化污水场含烃废气的催化燃烧试验

石化污水场所逸散的臭气主要来源于平流隔油池进出口，其主要成分为烃类等易挥发有机物。经封闭后有组织排放的废气，采用浓度调整－吸附脱硫－催化燃烧工艺技术处理，可达到国家废气排放标准，中型试验表明，其有机废气脱除率在96％以上，并尝试探索了催化燃烧中试的一些规律。     

Managing Exposure to Indoor Air Pollutants in Residential and Office Environments

Abstract Sources of indoor air pollutants in residential and office environments can be managed to reduce occupant exposures. Techniques for managing indoor air pollution sources include: source elimination, substitution, modification, pretreatment, and altering the amount, location, or time of use. Intelligent source management requires knowledge of the source's emission characteristics, including chemical composition, emission rates, and decay rates. In addition, knowledge of mechanical and natural outdoor air exchange rates, heating/air-conditioning duct flow rates, and local exhaust fan (e.g., kitchen, bathroom) flow rates is needed to determine pollutant concentrations. Finally, indoor air quality (IAQ) models use this information and occupant activity patterns to determine instantaneous and/or cumulative individual exposure. This paper describes a number of residential and office scenarios for various indoor air pollution sources, several ventilation conditions, and typical occupant activity patterns. IAQ model predictions of occupant exposures for these scenarios are given for selected source management options. A one-month period was used to compare exposures; thus, long-term exposure information is not presented in this paper.     

Comparison Of Volatile Organic Compounds From Processed Paper And Toners From Office Copiers And Printers: Methods,Emission Rates,And Modeled Concentrations

The emission of volatile organic compounds (VOC) from nine toner powders and eleven types of processed paper from photocopying machines (6), laser (3) and matrix printers (21, and one carbonless copy fm has been measured. A total of 61 VOC from toner powders were identified by heating (185 °C) the powder for three minutes for thermal desorption and by gas chromatography followed by the use of low and high resolution EI and CI mass spectrometry. VOC from processed paper were analyzed by headspace sampling on Tenax TA from nylon bags. Thirty-one VOC with a wide range of volatility and persistency were identified from processed paper. The total VOC emission from the various types of paper differed substantially. Using the field and laboratory emission cell (FLEC), the calculated initial emission rate of styrene was 5 μg m^?2h^?1 from a freshly processed paper The VOC emission from machines and the processed paper can be reduced by proper choice of o m e equipment. However, an evaluation should consider all potential pollutants.     

Characterization of Linoleum. Part 1: Measurement of Volatile Organic Compounds by use of the Field and Laboratory Emission Cell, “FLEC”⋆

The volatile organic compounds (VOCs) emitted from 12 linoleum samples were measured by use of the “Field and Laboratory Emission Cell” (FLEC) with sampling on Tenax TA followed by thermal desorbtion and GC/FID or GC/MS analysis. Major VOCs were alkanals, alkenals and fatty acids. The emissions were measured after 24 h in FLEC and again after one month's storage in a well ventilated room. The emission profiles of hexanal, nonanal and propanoic acid were modeled for four linoleum samples using a new exponential diffusion model. The time required to reach 50% of the odor threshold concentrations in a standard room was from 113 to 2296 hours. The applicability of the diffusion model for modeling long-term emission needs to be further evaluated considering possible continuous oxidative emission.     

Performance of H‐ZSM‐5‐supported bimetallic catalysts for the combustion of polluting volatile organic compounds in air

The performance of H‐ZSM‐5‐supported bimetallic catalysts with chromium as the base metal in the combustion of ethyl acetate and benzene is reported. A reactor operated from 100 to 500 °C at a gas hourly space velocity (GHSV) of 32 000 h^?1 was used for study of the activity. A combination of 1.0 wt% chromium and 0.5 wt% copper yielded a catalyst (Cr_1.0Cu_0.5/Z) with improved conversion and carbon dioxide yield. Cr₂O₃ (Cr³⁺) and CuO (Cu²⁺) were the predominant metal species in the catalyst. In agreement with the Mars–van Krevelen model, improved reducibility of Cr³⁺ in the presence of Cu²⁺ led to an improvement in activity. The copper content in Cr_1.0Cu_0.5/Z also favored the formation of deep combustion products. Condensation and subsequent growth of coke precursors in the catalyst pores led to the formation of a softer and less aromatic coke fraction while dehydrogenation activity on acid sites formed a harder and more aromatic coke fraction. The use of Cr_1.0Cu_0.5/Z favored the formation of lower molecular weight intermediates, leading to reduction in formation of softer coke. Copyright © 2005 Society of Chemical Industry     

A Study of Human Reactions to Emissions from Building Materials in Climate Chambers. Part II: VOC Measurements,Mouse Bioassay,and Decipol Evaluation in the 1–2 mg/m3 TVOC Range

Monitoring of human reactions to the emission of formaldehyde and volatile organic compounds (VOC) from four commonly used building materials was carried out. The building materials were: a painted gypsum board, a rubber floor, a nylon carpet, and a particle board with an acid-curing paint. The exposures were performed in climate chambers. The air quality was quantified on the decipol scale by a trained panel, measurements of formaldehyde and VOC being performed simultaneously. The irritating potency of the materials was measured by a mouse bioassay. The VOC measurements showed several malodorants and irritants. Some abundant VOC identified in the head-space analyses were absent in the climate chamber air. The rubber floor and the nylon carpet exhibited a marked increase in decipols compatible with a number of odorous VOC identified in the air. A high formaldehyde concentration (minimum 743μg/m³) was measured for the particle board coated with an acid-curing paint. This was not reflected by a corresponding relatively high decipol value but a long-lasting irritating potency was observed in the mouse bioassay. TVOC sampled on Tenax and expressed in mass per volume as well as in molar concentration, and decipol evaluation both have limitations and should be used with caution as indicators of (perceived) indoor air quality. Eye irritation expressed by means of the eye index reflecting the tear film quality index (comprised of break-up time, foam formation, thickness of the precorneal lipid layer of the tear film, and epithelial damage) was found to be insensitive to formaldehyde and a VOC mixture but sensitive to TVOC concentrations of 1–2 mg/m³. Lipophilic VOC may be the cause of reduced tear film quality by destabilization of the lipid multilayer of the tear film.     

Small and Large Scale Fire Experiments with Electric Cables under Well-Ventilated and Vitiated Conditions

Results from a series of small scale (using the DIN 53 436 tube furnace) and large scale experiments (using the IEC 60332-3 rig) are presented for two types of power transmission cables used in buildings. The results are unique in that they catalogue the production of a wide variety of organic and inorganic species under different fire conditions. The experiments were conducted to provide input to an LCA model and the specific organic species studied in detail have been chosen based on the information required by the LCA model.During the process of this study it became apparent that information concerning quantitative organic species evolution from cable fires is lacking in the open literature. This paper aims to provide such information for two specific sets of fire conditions, i.e., a well-ventilated and a vitiated cable riser fire.