基于区域权函数理论的多电极电磁流量计电极设计

基于Shercliff权函数提出区域权函数概念,设计多电极电磁流量计,通过测量管道截面不同位置的弦端电压,计算各区域的轴向平均速度,实现速度分布与体积流量的测量。着重研究了流量计电极设计,选取不锈钢平头方案的多电极电磁流量计,对于阀门下游的非轴对称单相流体积流量测量精度高于±1.0%,倾斜管固—液两相流实验证明:该设计对于两相流非轴对称的速度分布测量具备可靠性。     

Miscibility and fracture toughness of thermoplastic polyurethane/poly(vinyl chloride)/nitrile rubber ternary blends with special reference to the blend composition

Ternary blends of thermoplastic polyurethane and a poly(vinyl chloride)/nitrile rubber blend were investigated in this work. The blends, with weight ratios of 100/0, 80/20, 40/60, 60/40, 80/20, and 0/100, were prepared via melt blending. Dynamic mechanical analysis showed that the blends with ratios of 20/80 and 80/20 were miscible, whereas the 40/60 and 60/40 blends were partially miscible. IR spectroscopy studies showed shifts in the peaks due to specific interactions in the blends. The blends showed degradation behavior between the blend components. The fracture toughness was investigated with the J‐integral by the locus method; the components and the miscible blends had good fracture toughness, whereas the other blends had lower toughness. Similar behavior was observed for the tensile properties. Scanning electron microscopy studies showed the morphological variations in the blends. © 2005 Wiley Periodicals, Inc. J Appl Polym Sci 97: 1763–1770, 2005     

Synthesis and fluorescence properties of aromatic‐aliphatic copolyamides

The aromatic‐aliphatic copolyamides were synthesized by condensation polymerization of aromatic diamine PPD (or APS, where PPD is p‐phenylene diamine and APS is aminophenyl sulfone), aliphatic diamine HDA (or EDA, where HDA is hexanediamine and EDA is ethylenediamine), and TPC (where TPC is terephthalyl chloride) with different molar ratios of aromatic diamine to aliphatic diamine. The steady‐state fluorescence of these condensed copolymers was investigated. These copolyamides exhibit strong blue‐to‐green fluorescence. © 2005 Wiley Periodicals, Inc. J Appl Polym Sci 98: 315–321, 2005     

Comparative study of the physical aging of the epoxy systems BADGE n = 0/m‐XDA and BADGE n = 0/m‐XDA/PEI

The physical aging of the epoxy network consisting of a diglycidyl ether of bisphenol A, m‐xylylenediamine, and polyetherimide was studied by differential scanning calorimetry. The glass transition temperature and the variation of the specific heat capacities have been calculated using the method, based on the intersection of both enthalpy–temperature lines for glassy and liquid states. The apparent activation energy (E_H) was calculated using a single method that involved separate temperature and excess enthalpy dependency. All calorimetric data were compared with those obtained for the epoxy network without thermoplastic. thermoplastic. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci 103: 3931–3935, 2006     

Preparation and self‐assembly of poly(diglycidyl maleate‐co‐stearyl methacrylate)

Poly(diglycidyl maleate‐co‐stearyl methacrylate) (P(DGMA‐co‐SMA)) with reactive epoxy groups was synthesized by reaction of poly(maleic anhydride‐co‐stearyl methacrylate) (P(MA‐co‐SMA)) and epichlorohydrin. The effect of precipitant on self‐assembly behaviors of the resultant copolymer was investigated. It was found that vesicles and nanotubule liked aggregates can be obtained through self‐assembly of P(DGMA‐co‐SMA) in THF solution using CH₃CH₂OH (EtOH) as precipitant while spheral aggregates can be obtained using H₂O as precipitant. The mechanism of the self‐assembly behavior was discussed. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci 2007     

Preparation and characterization of TiO2 and polymer nanocomposite films with high refractive index

Novel nanocomposite films of TiO₂ nanoparticles and hydrophobic polymers having polar groups, poly (bisphenol‐A and epichlorohydrin) or copolymer of styrene and maleic anhydride, with high refractive indices, high transparency, no color, solvent‐resistance, good thermal stability, and mechanical properties were prepared by incorporating surface‐modified TiO₂ nanoparticles into polymer matrices. In the process of preparing colloidal solution of TiO₂ nanoparticles, severe aggregation of particles can be reduced by surface modification using carboxylic acids and long‐chain alkyl amines. These TiO₂ nanoparticles dispersed in solvents were found not to aggregate after mixing with polymer solutions. Transparent colorless free‐standing films were obtained by drying a mixture of TiO₂ nanoparticles colloidal solution and polymer solutions in vacuum. Transmission electronic microscopic studies of the films suggest that the TiO₂ nanoparticles of 3–6 nm in diameter were dispersed in polymer matrices while maintaining their original size. Thermogravimetric analysis results indicate that the nanocomposite film has good thermal stability and the weight fraction of observed TiO₂ nanoparticles in the film is in good accordance with that of theoretical calculations. The refractive index of nanocomposite films of TiO₂ and poly(bisphenol‐A and epichlorohydrin) was in the range of 1.58–1.81 at 589 nm, which linearly increased with the content of TiO₂ nanoparticles from 0 to 80 wt %. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci 2007     

多传感器数据采集系统中的数据融合研究

针对多传感器数据采集系统的准确性与可靠性的要求,提出了单传感器分批估计融合与模糊理论中的相关性函数与加权自适应算法相结合的数据融合方法。首先,对每一只传感器进行分批估计融合,得到了较为可靠的局部决策值。然后,利用模糊理论中的相关性函数,计算出每只传感器与其它传感器的相关程度,并剔除掉那些相关程度较低的传感器的局部决策值。最后,在权的最优分配原则下,利用加权自适应算法对剩下的局部决策值进行数据融合。该方法能在数据先验知识未知的情况下,客观地反映各个传感器的可靠程度。数据分析结果表明:与同类融合方法相比,该方法具有更高的精度。     

Study of Hydrodynamics,Mixing and Gas‐Liquid Mass Transfer in a Split‐Rectangular Airlift Reactor

Global hydrodynamic characteristics, liquid mixing and gas‐liquid mass transfer for a 63 L split‐rectangular airlift reactor were studied. Correlations for gas holdup and overall liquid circulation velocity were derived for the air‐water system as a function of the specific power input; these were compared to data and correlations for reactor volumes between 4.7 L and 4600 L. A partial recirculation of small bubbles in the riser was observed when U_gr > 0.03 m/s, which was attributed to the use of a single‐orifice nozzle as the gas phase distributor. The dimensionless mixing time and the overall axial dispersion coefficient were nearly constant for the range of gas flow rates studied. However, values of K_L/d_B were greater than those reported in previous studies and this is caused by the partial recirculation of the gas phase in the riser. While scale effects remain slight, the use of a gas distributor favouring this partial recirculation seems adequate for mass transfer in split‐rectangular airlift reactors.     

Zeolite‐catalyzed isomerization of oleic acid to branched‐chain isomers

Branched‐chain (bc) saturated fatty acids (SFA) have potential as oleochemical intermediates since they have better oxidative stability than linear unsaturated fatty acids (UFA) and have better low‐temperature properties than linear SFA. Previous studies in converting UFA to bc‐FA using clay catalysts have resulted in only modest yields and conversions. Recent reports, however, have suggested that certain zeolites can be effective catalysts for converting UFA to bc‐FA in higher yields and conversions. In this work, we examined the scope and potential of the zeolite‐catalyzed synthesis of bc‐FA starting from readily available monounsaturated linear FA. Our results show that common UFA such as oleic acid can be converted to bc‐isomers using modified Ferrierite zeolite catalysts with high conversions (98%) and high selectivity (85%) and that the zeolite catalysts are reusable for at least three cycles. The positions of branching (methyl) on the FA chain were determined from the GC‐MS spectra of the picolinyl esters of the bc‐FA.     

Joint Determination of the State Dimension and Autoregressive Order for Models with Markov Regime Switching

Abstract. This paper is concerned with the problem of joint determination of the state dimension and autoregressive order of models with Markov‐switching parameters. A model selection procedure is proposed which is based on optimization of complexity‐penalized likelihood criteria. The efficacy of the procedure is evaluated by means of Monte Carlo experiments.