油田污水中咪唑啉缓蚀剂浓度检测技术研究

研究评价了油田污水中咪唑啉缓蚀剂浓度检测的七种方法 ,其中紫外光分析法和显色反应法适合于低浓度咪唑啉缓蚀剂检测 ,且方法简便、速度快、成本低 ,检测浓度范围 2～ 5 0mg/L。     

莲心中可溶性成分的有效提取

采用不同的原料处理,改变提取的流程和提取时间，测定不同条件下所得提取液的可见吸收光谱，以此反映各提取液的组分和浓度是否发生变化，并比较在最大吸收波长下各提取液的吸光度大小，从而确定将莲心捣碎后，加热回流时间为60min的提取方法效果最佳。     

SiGe／Si多量子阱中垂直方向红外吸收及共振色散效应

用垂直入射的中红外光束调制非掺杂SiGe/Si量子阱中光致子带间吸收，氩离子激光器作为子带间跃迁的光泵浦源在阱中产生载流子，红外调制光谱用步进式傅立叶变换光谱仪记录，实验中观察到明显的层间干涉效应与子带间跃迁有关的色散效应，理论和实验分析认为样品折射率变化造成的位相调制可以补偿吸收所造成的幅度调制。     

屏蔽人体模型对电磁波吸收的数值模拟研究

本文用时域有限差分法计算了三类电磁特性不同的材料屏蔽下三层无限长椭圆柱人体模型对电磁波的吸收。结果表明 ,功率密度相同 ,频率在 0 .2～ 6GHz之间的平面电磁波照射下 ,模型吸收的能量、能量在体内的分布及两者对入射电磁波频率的敏感程度严重地受到外加屏蔽的影响。考察了屏蔽材料的电磁特性与其屏蔽效能之间的关系。三类材料的比较显示 ,对人体电磁辐射防护 ,耗散材料优于非耗散材料 ,导电材料优于非导电材料。     

水对食品相变的影响

水是食品材料中最重要的成分。本文介绍了食品中水的性质以及水对食品相变的影响，并从水活性、水的吸附性以及水的增塑性三方面描述了水在食品相变中所起的作用。另外，还着重分析了水对食品冻结温度的影响。     

原子吸收次灵敏线法直接测定土壤中Fe、Mn

用原子吸收次灵敏线法塞曼效应扣除背景测定土壤中Fe、Mn,实验结果表明:此方法有较好的准确度,精密度,操作简单,适合一般土壤中Fe、Mn的测定。     

液晶光阀光电导层光吸收系数的研究

用化学气相沉积法制备了液晶光阀中光电导层———非晶硅薄膜,从实验中得出最佳制备工艺的参数取值。给出了用包络线法测量非晶硅薄膜光吸收系数的原理,测量了样品的光吸收系数随波长的变化规律。得到样品在最佳工艺条件下的光吸收系数高于1×103cm-1。     

The Simulation of Impact Loads on Beam-type Structures using a Pseudo-dynamic Procedure

Abstract:  This study proposes an alternate method for the analysis of beams with solid cross-section or built as a framed structure and subjected to transverse impact loads from an external striker. The procedure used in the analysis is a combination of two essential tools using pseudo-dynamic techniques. The method reported here involves only one degree of freedom for the structure modelling and assumes an elastic contact between an external striker and the beam structure, which in reality does not happen. As only one degree of freedom is considered in the analysis, some important limitations are inherent to the method proposed here. Essentially, there is the difficulty of modelling the displacement field associated with the transient structure behaviour accurately, as a consequence of fast-rate impact loads. Another difficulty faced by the method refers to a local structure behaviour associated with contact loads. The present method can deal with large displacements in transversely loaded beams associated to a collapse mechanism having a simple geometry and defined with precision from a single parameter. This ensures reasonable accuracy in the evaluation of the strain energy absorbing capacity of transversely impacted beam structures using a single degree of freedom model in a pseudo-dynamic procedure.     

核电反应堆用芯部材料的核物理性能

核物理性能是核电站反就堆芯部结构材料的首要技术条件。本文概述合金材料核物理的有关问题，以及核截面的计算方法。     

A comparative thermodynamic study of sorption systems: second law analysis

As a consequence of the phasing out of CFCs, sorption systems appear to be potential candidates to replace vapour compression systems. Amongst sorption systems there exists a choice between several systems, such as liquid absorption, solid adsorption and chemical reaction heat pumps. Nevertheless, few comparative studies between these systems have been undertaken so far. It is the aim of this paper to present such a study based on combined first and second law thermodynamical analysis of the different cycles. Simple entropy generation processes explain why the basic cycles for these systems yield performances much lower than the Carnot efficiency. The possibility of operating regenerative cycles with internal heat recovery and higher efficiencies has also been considered for typical common base conditions. Different entropy generation considerations have been visualised, such as thermal coupling (external/internal), non-uniform temperature component entropy production and other irreversible processes for the COP degradation in these systems. It is found that thermal coupling irreversibilities in solid sorption systems and other internal irreversibilities in liquid sorption systems with solution heat exchanger are dominant in the actual COP degradation with respect to the reversible Carnot COP.