Enthalpic relaxation in semi-crystalline PEEK

The effect of crystallisation on the glass transition temperature and enthalpic relaxation in poly(ether ether ketone) (PEEK) has been investigated. The increase in glass transition temperature and the activation enthalpy of ageing is explained in terms of the amorphous phase being constrained by the crystallites. The extent of enthalpic relaxation with time has been analysed in terms of the Cowie-Ferguson model and the β value was found to be dependent on both temperature and the crystalline morphology, changes in the co-operativity of the relaxations are used to explain this observation.     

聚乙烯醇膜的阻醇及导电性能(Ⅱ)戊二醛交联聚乙烯醇膜

为提高直接甲醇燃料电池(DMFC)用膜的阻醇性能，采用在渗透蒸发领域广泛使用且具有良好分离效果的聚乙烯醇(PVA)为主要材料，制备了戊二醛(GA)交联PVA膜，考察了此类膜的阻醇及质子导电能力。PVA(GA)膜的阻醇效果较目前在DMFC中广泛使用的Nation膜有显著提高，但其自身不具有质子导电能力，需外加电解质溶液以提高其电导率。     

PCC载体氧化剂的制备及应用研究

制备得到各种有代表性的氯铬酸吡啶(PCC)无机载体氧化试剂,以苯甲醇选择性氧化成苯甲醛为探针反应,考察了载体、反应条件对氧化反应效率的影响,控制各载体氧化剂中PCC的负载量均为1.8 mmol/g。室温下反应,搅拌时间为30 m in,苯甲醇的氧化反应产率为:分子筛65.8%,活性炭75.4%,氧化铝94.6%,硅胶96.9%,相同条件下PCC的产率为65.8%。硅胶是制备负载PCC的优良载体,在载体氧化剂对苯甲醇的氧化反应中,一定范围内增加反应时间和载体加入量都可以提高氧化产率。     

凝胶过滤色谱测定高分子量聚乙烯醇分子量和分子量分布

用凝胶过滤色谱对高分子量聚乙烯醇分子量、分子量分布进行剖析。采用Plaquagel-OH色谱柱,0.25mol/LNaNO3,0.01mol/L Na2HPO4-NaH2PO,pH=7的缓冲溶液流动相,流速1ml/min,示差折光检测器,柱温30℃,聚环氧乙烷作标准物。该方法能显著缩短分析时间,提高准确性,可用于对高聚合度聚乙烯醇进行研究和指导生产。     

Experimental and analytical study on the spray characteristics of dimethyl ether (DME) and diesel fuels within a common-rail injection system in a diesel engine

This paper investigates the effect of injection parameters on the characteristics of dimethyl ether (DME) as an alternative fuel in a diesel engine with experimental and analytical models based on empirical equations. In order to study macroscopic and microscopic characteristics of DME fuel, this work focuses on the atomization characteristics of DME and compares experimental and predicted results for spray development obtained by empirical models for diesel and DME fuel. Detailed comparisons of spray tip penetration from three different empirical correlations and from visualization experiments of diesel and DME fuels were conducted under various fuel injection conditions. In comparison with the results of different empirical equations for measured spray tip penetration, the experimental results of this study provide good agreement with the calculation results based on empirical equations, except during the earliest stage of the injected spray sequence. The results of atomization characteristics indicate that DME showed better spray characteristics than conventional diesel fuel. Also, the fuel injection delay and maximum injection rate of DME fuel are shorter and lower than those of diesel fuel at the same injection conditions, respectively.     

Viscoelastic properties of polyarylene ether nitriles/thermotropic liquid crystalline polymer blend

Polyarylene ether nitriles (PEN)/thermotropic liquid crystalline polymer (TLCP) blend was prepared via melt mixing. The immiscible phase morphologies, linear and nonlinear, as well as transient viscoelastic properties of the blend were studied using SEM, rheometer, and DMA. The linear dynamic viscoelastic behavior of the blend shows temperature dependence due to further evolution of the immiscible morphology and, as a result, the principle of time‐temperature superposition (TTS) is invalid. In the steady shear flow, the discrete TLCP phase is difficult to be broken up because of the high viscosity ratio of the blend systems, while is easy to be coarsened and followed by elongation, and finally, to form fibrous morphology at high TLCP content and high shear level. During this morphological evolution process, the transient stress response presents step increase and nonzero residual relaxation behavior, leading to increase of the dynamic viscoelastic responses after steady preshear. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

Structure and processability of iodinated poly(vinyl alcohol). IV. Drawability of the films iodinated at solution before casting

The drawability of iodinated at solution before casting (IBC) polyvinyl alcohol films prepared by casting aqueous solutions of 10 wt % PVA containing 15.2, 39.8, 83.2, 117.0, and 140.1% was examined with a tensile tester at 20–60°C. The tensile behavior of IBC films showed that the yield and breaking loads were much lower, and the breaking elongation was even higher than those of the unoriented iodinated after casting (IAC) films as well as the untreated PVA films. The maximum draw ratios of the films with the weight gain of 15.2, 39.8, 83.2, 117, and 140.1% were 4.5, 5.5, 8.5, 8.0, and 7.5, respectively, which were achieved at 20°C in all. The crystallinity of all films increased by the maximum draw, regardless of crystallinity before drawing. The crystalline structure was recovered to the original PVA crystalline lattice by deiodination. Amorphous orientation and initial moduli increased with the maximum draw ratio, while the orientation of crystals was constant. The orientation and moduli increased up to the weight gain of 83.2%, whose highest draw ratio and initial modulus were 8.5 and of 7.1 GPa, respectively, and then decreased. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci 2008     

Effects and properties of poly(arylene ether benzonitrile)s of various molecular weights blended with sulfonated poly(ether ether ketone)

Poly(arylene ether benzonitrile) (PAEBN) was synthesized with 2,6‐dichlorobenzonitrile and biphenol. PAEBNs with various molecular weights (MWs), 1,640,000 and 185,000 g/mol, were synthesized by control of the stoichiometry of the monomers and were blended with sulfonated poly(ether ether ketone) (SPEEK). The effects of MW on the water uptake, swelling, methanol permeability, and proton conductivity of the SPEEK/PAEBN blend membranes were investigated. The molecular mobility of the SPEEK/PAEBN blends was also examined in this study. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

Individuation, peers, and adolescent alcohol use: A latent growth analysis.

The study used latent growth modeling to investigate longitudinal relationships between individuation, peer alcohol use, and adolescent alcohol use among African American, Mexican American, and non-Hispanic White adolescents (N=6,048) from 7th, 8th, and 9th grades over a 3-year period. Initial levels of peer alcohol use were significantly related to changes in adolescents' alcohol use, whereas initial adolescent alcohol use also significantly related to changes in peers' alcohol use, suggesting a bidirectional relationship. Higher levels of intergenerational individuation were related to smaller increases in adolescent alcohol use and higher levels of separation were related to larger increases in youth drinking. The findings were similar across ethnic groups. Implications for development of prevention and intervention programs are discussed. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

��չ����Ȼ��Ϊԭ�ϵ�ȼ�ϵ������

研究燃料汽车及其氢源系统是当今国内外能源工业与汽车工业的共同课题，而优选制氢能源则是这一课题的关键。章介绍了利用能源、经济、环境(EEE)——生命周期评估(LCA)这一综合评估方法，针对以天然气、煤或石油作为制氢能源的多种燃料电池氢源供应方式以及配套的燃料电池汽车系统，从经济性、能源利用效率和环境影响三个方面进行了生命周期清单分析和EEE综合评价。结果显示：天然气作为发展燃料电池汽车氢源的一次能源，具有氢制取技术路线多样化、经济上竞争力强、能源利用效率高和环境效益好等诸多优势，应为燃料电池汽车的首选制氢能源。对这一评估模型的敏感性分析显示，即使在天然气价格波动较大时，天然气制甲醇--甲醇车载重整车和天然气制氢--纯氢车这两个方案仍然最具优势。