氢化物原子荧光光谱法测定酱油中微量铅的方法研究

建立了一种快速、高效的QuEChERS-高效液相色谱-质谱联用法（QuEChERS-HPLC-MS/MS）测定谷类杂粮制品中脱氧雪腐镰刀菌烯醇（DON）、3-乙酰脱氧雪腐镰刀菌烯醇（3-ADON）、15-乙酰脱氧雪腐镰刀菌烯醇（15-ADON）和玉米赤霉烯酮（ZON）共4种真菌毒素。样品前处理采用乙腈-水溶剂提取，经Florisil+C18+无水硫酸镁净化后检测。以0.10%甲酸-乙腈作为流动相，在质谱检测器的多反应监测模式下进行分析。结果表明，4种真菌毒素在各自的线性范围内线性关系良好，相关系数R2均大于0.999，回收率在85.1%～102.0%，相对标准偏差（RSD）为2.11%～6.22%。该方法具有前处理简单、净化效果好、灵敏度高和检测速度快的优点，适用于谷类杂粮制品中DON、3-ADON、15-ADON 和ZON的分析和定量检测。     

Real-time organic aerosol chemical speciation in the indoor environment using extractive electrospray ionization mass spectrometry

Understanding the sources and composition of organic aerosol (OA) in indoor environments requires rapid measurements, since many emissions and processes have short timescales. However, real-time molecular-level OA measurements have not been reported indoors. Here, we present quantitative measurements, at a time resolution of five seconds, of molecular ions corresponding to diverse aerosol-phase species, by applying extractive electrospray ionization mass spectrometry (EESI-MS) to indoor air analysis for the first time, as part of the highly instrumented HOMEChem field study. We demonstrate how the complex spectra of EESI-MS are screened in order to extract chemical information and investigate the possibility of interference from gas-phase semivolatile species. During experiments that simulated the Thanksgiving US holiday meal preparation, EESI-MS quantified multiple species, including fatty acids, carbohydrates, siloxanes, and phthalates. Intercomparisons with Aerosol Mass Spectrometer (AMS) and Scanning Mobility Particle Sizer suggest that EESI-MS quantified a large fraction of OA. Comparisons with FIGAERO-CIMS shows similar signal levels and good correlation, with a range of 100 for the relative sensitivities. Comparisons with SV-TAG for phthalates and with SV-TAG and AMS for total siloxanes also show strong correlation. EESI-MS observations can be used with gas-phase measurements to identify co-emitted gas- and aerosol-phase species, and this is demonstrated using complementary gas-phase PTR-MS observations.     

芳烃联合装置节能降耗方法探讨

结合芳烃联合装置的发展形势，通过对国内某4套典型芳烃联合装置运行能耗的构成进行分析，确定该类装置的主要能耗在于燃料、电和蒸汽的消耗。总结了目前国内外常用的芳烃联合装置节能降耗方法，利用实际经验和调研结果，从采用新型吸附剂、采用单台吸附塔新工艺、采用轻质解吸剂替代对二乙苯（PDEB）、优化吸附塔运行参数、加热炉节能优化和选用高效节能设备等角度探讨芳烃联合装置的节能降耗方法。芳烃联合装置节能降耗应该由设计单位和生产单位紧密结合，在设计阶段就应充分考虑生产过程面临的问题，充分优化工艺路线、方案和设备设计，尽可能降低装置的能耗。同样，装置运行过程中，生产部门应标准化、精细化管理，优化日常操作，从而进一步降低装置的操作能耗。     

三光子吸收效应对孤子对传输的影响

用分步傅里叶变换法求解含三光子吸收效应的光孤子NLS方程，研究了三光子吸收效应对孤子对在传输中相互作用的影响。研究发现，在特定条件下，三光子吸收效应能使孤子对无离合地平行传输。     

油气吸收回收系统的研究及工业应用——(Ⅰ)中型试验及结果分析

在蒸发油气吸收回收技术小试研究的基础上，开发出常温常压吸收法油气回收中试装置，并利用已开发的吸收剂AbsFOV-97进行了中试试验。结果表明，当系统进料气、吸收剂AbsFOV-97、汽油的体积流量比为10．0：1．0：0．5、真空泵解吸压力小于13．3kPa时，系统回收率高达97％以上，高于设计指标，且回收汽油的质量满足使用要求。统计数据表明，油气回收系统进料气、尾气中平均油气摩尔质量分别为65．51、48．97g／mol，该值可为油品蒸发损耗及其控制技术的评价提供参考。     

Vapor absorption by LiBr aqueous solution in vertical smooth tubes

Heat and mass transfer in a falling film vertical in-tube absorber was studied experimentally with LiBr aqueous solution. The presented results include the effect of solution flow rate, solution subcooling and cooling water temperature on the absorption in a smooth copper tube 16.05 mm I.D. and 400 mm long. The experimental data in the previous report for a 1200-mm-long tube was also re-examined and compared. It was demonstrated by the observation of the flow in the tube that the break down of the liquid film into rivulets leads to deterioration of heat and mass transfer at lower film Reynolds number or in longer tubes. An attempt to evaluate physically acceptable heat and mass transfer coefficients that are defined with estimated temperature and concentration at the vapor–liquid interface was also presented.     

复合材料管状结构的能量吸收性能

复合材料结构作为防撞结构的能量吸收元件,已经逐步得到工程领域的广泛认同。复合材料结构的能量吸收能力是一种特殊要求的力学性能,它的研究目标和研究手段有其独特之处。综述了近年来复合材料管状结构能量吸收性能研究的最新进展,以及有待进一步研究的问题。     

硫化氢吸收液的电化学分解条件研究

理想的脱硫工艺应满足体积小、费用低、净化度高、无二次污染等要求。在碱性溶液吸收微量硫化氢时同步进行电解，可有效减小设备体积，并将硫化氢转变为氢气和硫磺，不产生恶性气味。为此，实验研究了温度、浓度、电流密度、pH值等因素对电解阳极过程的影响，确定了适宜的电解条件，并在该条件下进行了吸收实验。结果表明，在最佳电解条件下，硫化钠溶液能充分吸收天然气中经变压吸附提浓的硫化氢（800 mg/m³），吸收率大于99.9％。     

MOCVD生长薄膜材料制作半导体可饱和吸收镜

介绍了当前国际上流行的用半导体可饱和吸收镜来对固体激光器、光纤激光器和半导体激光器进行被动锁模的方法,阐述了半导体可饱和吸收镜用来作为被动锁模吸收体的原理,并介绍了如何利用金属有机气相淀积(MOCVD)技术生长各种波长激光器所需要的半导体可饱和吸收镜.     

Oxidation of doped europium in BaMgAl10O17 by annealing studied by x‐ray‐absorption fine‐structure measurements

Abstract— We studied the influence of annealing in air on doped europium in BaMgAl₁₀O₁₇ by performing x‐ray absorption fine‐structure measurements. We determined the oxidation of doped divalent europium by annealing in air at over 500°C. The interatomic distance between the europium and the surrounding oxygen atoms was compressed by oxidation. It also appears that the oxidation process of europium is determined by the diffusion of oxygen into BaMgAl₁₀O₁₇.