Energy Value of Resistant Starch

Resistant starch was evaluated for energy value using fine silica and normal starch as controls and young rats as a test model. The net increase in rats' carcass energy due to the test materials fed over a 3-wk period formed the basis for assessing energy value. Rats fed normal starch deposited about twice as much fat and significantly more protein in the carcass than those fed either resistant starch or silica. Rats fed resistant starch or silica showed similar growth responses and increases in components of body composition and carcass energy content. This suggested that resistant starch provided, like silica, no energy.     

Storage Stability of Antioxidant-Washed Myofibrils From Chicken White and Red Muscle

Oxidation and gel-forming ability of chicken white (breast) and red (leg) muscle myofibrillar proteins during storage at 0°C were examined. Breast myofibril gels exhibited greater shear moduli than leg myofibril gels throughout 8 days storage. Shear moduli of both breast and leg gels in the intermediate temperature zone (45–55°C) decreased during storage, but at >55°C, they either increased or remained unchanged. Lipid oxidation was inhibited by washing myofibrils with antioxidants propyl gal-late, ascorbate, and tripolyphosphate. However, these antioxidants did not affect the content of protein carbonyls, and only slightly decreased the amine content during storage. Storage affected the kinetic process of myofibril gelation independently of antioxidant treatments.     

纸张背衬不同衬底时的光反射率的研究

从理论上研究了纸张背衬不同衬底的光反射率，得出下列表达式：Ｒｂ＝Ｒｏ＋（Ｒ∞－Ｒｏ）×（１／Ｒ∞－Ｒｏ）／（１／Ｂ－Ｒｏ）（Ｂ为衬底的光反射率），该式简单实用且物理意义明确。利用上述公式，可将Ｔａｐｐｉ标准列出的Ｔａｐｐｉ不透明度Ｃ０．８９的换算公式简化，并可从理论上定性地讨论纸张不透明度与印刷透印性的关系。     

强度调制／直接检测（IM／DD）光纤通信系统色散限制的研究

通过引入归一化脉宽Ｐ和相对脉冲展宽因子ｑ，提出了一个适用于ＩＭ／ＤＤ系统中各种眼图恶化量ｘ和归一化脉宽Ｐ的色散限制改进公式。通过与其它理论的比较、计算机仿真和对实验数据的分析，验证了该公式的正确性，并给出了其它结果的限制条件。研究表明：当眼图恶化量ｘ为１ｄＢ左右时，对２．５Ｇｂ／；外调制信号（α＝０）而言，非色散位移光纤ＩＭ／ＤＤ系统的色散因子γ约等于０．７９，所对应的系统再生中继距离约为９００余公里。     

The mechanics of compressive kinking in unidirectional fiber reinforced ductile matrix composites

Three distinct stages of kink band formation and propagation exist in ductile matrix composites subjected to compressive loading. These stages are called incipient kinking, transient kinking and kink band broadening. Each stage involves a different deformation mode. The mechanics governing each stage are discussed. Incipient kinking, where the peak load is attained, and kink band broadening, where the load attains a steady-state, are important in structural design. Two design philosophies are presented. References to pertinent literature are made throughout.     

Use of TNSAC in phosphate adsorption studies and relationships. Isotherm relationships and utility in the field

There is a need for developing low cost, easily and abundantly available, yet efficient, adsorbents for the removal of phosphates during the tertiary treatment of wastewaters. The tamarind nut shell activated carbon (TNSAC) prepared on a laboratory scale has been used to evaluate its performance for phosphate adsorption. This paper describes the laboratory production of this adsorbent material in its various forms, and discusses the effects of the TNSAC process variables (the unrinsed and rinsed forms of the TNSAC and the impregnation ratio) on its performance in adsorbing phosphate. The material has been shown to be a good alternative adsorbent. As much as 95% phosphate removal by the unrinsed TNSAC is possible in about 30 min under the test conditions. The phosphate adsorbing capacity is about two times higher for the unrinsed TNSAC in comparison to the rinsed TNSAC. The adsorption rates, however, transit to extremely low rates towards the end when equilibrium conditions could be attained in about 2 h contact time. The phosphate removal mechanics are adsorption and precipitation/ion exchange when unrinsed TNSAC is used, and adsorption alone for the rinsed TNSAC. The maximum phosphate removal is found to take place at an impregnation ratio of 1.0 for both forms of the TNSAC.     

G.652光纤上的2.5Gbit／s色散受限系统

本文根据色散受限中继段长度的计算，对实际工程中１５５０ｎｍ波长２．５Ｇｂｉｔ／ｓ系统进行计算比较得出啁啾声引起的色散不容忽视，它使２．５Ｇｂｉｔ／ｓ成为色散受限系统。对１３１０ｎｍ波长６２２Ｍｂｉｔ／ｓ系统，当使用多纵模激光器时，往往也会成为色散受限系统。     

钢纤维混凝土在南钢大道工程中的应用

钢纤维混凝土是一种性能优良的新型复合材料，与普通混凝土相比，其抗拉、抗弯、抗裂及耐磨、耐冲击、耐疲劳等性能都有显著提高，它不仅可使路面厚度减薄，工程缝间距加大，改善路面的使用性能，延长路面使用寿命，而且还可节省工程造价，缩短施工工期。文中结合南钢大道路面工程实际，主要介绍了钢纤维混凝土的施工及质量控制要点。     

柔性纤维混凝土的疲劳特性研究

将柔性纤维掺入水泥混凝土可以大幅度提高混凝土的弯曲疲劳等路用性能,并通过试验建立了柔性纤维混凝土的疲劳方程.结果表明,柔性纤维不但能使混凝土的强度提高,更主要的是可以在重交通条件下,可成倍地提高混凝土的弯曲疲劳寿命.