Bubble Formation at a Rotating Cylindrical Surface in Cross‐Flowing Liquid

A novel method of gas sparging from a rotating cylinder is proposed, which prevents against formation of large attached gas cavities in cross‐flowing liquids including those flowing downwards. Experimental and theoretical results regarding critical rotation speed necessary to remove the attached cavity, bubble formation process and size distribution of the produced bubbles in a low viscosity system (air‐water) are presented in this study.     

Stochastic defect diffusion model for relaxation effects in crystalline polyethylene

It is suggested that some relaxation processes observed in crystalline polyethylene are consequences of the diffusive motion of a particular defect called a point dislocation or twist dispiration loop along the polyethylene stems in lamellar crystals. The motion of the defect, characterized by a diffusion coefficient and a mobility, is described by solutions of the Smoluchowski diffusion equation with boundary conditions that constrain the defect to move along routes that produce experimentally observable results. The fact that passage of the defect causes both a 180° rotation of the chain and moves an extra CH₂ group in the direction of the chain axis is important to the interpretation of the data according to this model. The diffusion coefficient for a defect is estimated to be around 2 × 10^?9 cm² s^?1 at 70°C. This value is shown to be reasonable both from the viewpoint of detailed computer modelling of defect motion and contemporary ideas about scaling.     

Interpretation of quasi-elastic light scattering data for flexible chains: model dependence

The autocorrelation functions and corresponding relaxation times obtained from the forward depolarized quasi-elastic light scattering experiment are exhibited for two quite similar models of flexible polymer chains in solution. A very small change in the chain dynamics is found to be sufficient to change the relaxation time from a relatively short time independent of chain length, with an autocorrelation function suggestive of an unweighted sum of contributions from all the relaxation times in the spectrum of chain motion, to a long time with an autocorrelation function identical with that for the end-to-end vector, strongly dependent upon chain length and dominated by the longest relaxation time in the spectrum. These results raise the question whether widely-used models in which information about short-range chain structure and motion is deliberately omitted can be expected to be appropriate for the interpretation of depolarized scattering experiments.     

引汉济渭椒溪河隧洞施工通风数值模拟研究

引汉济渭工程是陕西省为缓解关中渭河沿线城市和工业缺水问题,而提出的由汉江调水到渭河流域的大型水利工程。椒溪河段工程为穿河段,地形地质相对复杂,隧洞施工期的通风问题也相对比较严重。采用CFD(Computational Fluid Dynamics)数值模拟方法对带有支洞隧洞的通风过程进行模拟,研究几种典型工况下隧洞内的流场和浓度场在施工期时随时间的变化规律,分析掌子面以及支洞内涡流对气流及有害气体分布的影响。在气流排散通道不顺畅时,掌子面附近的涡流区域内涡流的大小和位置呈现周期性的变化,并随通风时间的增加影响范围逐渐降低。隧道爆破产生的有害气体和烟尘会随着气流的流动发生移动和扩散过程,并逐渐排向洞外。通过对隧洞主洞与支洞内气流和有害气体排散过程的研究,得出隧洞爆破后在通风作用下隧洞的掌子面附近和支洞与主洞的交叉位置处形成涡流区,涡流的产生和变化不断的消耗通风的机械能,降低通风效率,对有害气体的排散造成一定的阻滞作用,隧洞内有害气体的排散过程包括移动和扩散两方面,移动过程将CO排向洞外,扩散过程不断的降低洞内CO峰值,总结出了不同工况下隧洞内达到安全浓度的时间,对隧洞施工进度给出一定的参考意见。     

Low frequency ac conduction and dielectric relaxation behavior of solution grown and uniaxially stretched poly(vinylidene fluoride) films

The measurements of ac conductivity [σ_m(ω)], dielectric constant [?′(ω)] and loss [?″(ω)] have been performed on solution grown (thickness ∼85 μm) and uniaxially stretched (thickness ∼25, 45 and 80 μm) films of poly(vinylidene fluoride) (PVDF) in the frequency range 0.1 kHz-10 MHz and in the temperature range 77-400 K. The σ_m(ω) can be described by the relation σ(ω) = Aω^s, where s is close to unity and decreases with increase in temperature. Three relaxations, observed in the present investigation, have been designated as the α_c-, the α_a- and the β-relaxations appearing from high temperature side to the low temperature side. The α_c-relaxation could not be observed in the case of uniaxially stretched poly(vinylidene fluoride) films. The α_c- and α_a-relaxations are associated with the molecular motions in the crystalline regions and micro-Brownian motion in the amorphous regions of the main polymer chain, respectively, whereas the β-relaxation is attributed to the rotation of side group dipoles or to the local oscillations of the frozen main polymer chain.     

PET/纳米TiO2复合材料松弛行为的研究

以PET/纳米TiO2复合材料为对象,采用TMA、DMTA等手段,从分子运动的角度对该复合体系的松弛行为进行了研究.结果表明,纳米粒子在聚合物基体中与分子链通过物理或化学作用限制分子链的运动与松弛.体现在复合体系的温度-形变谱图中,随纳米TiO2含量的增加,玻璃化转变提前,橡胶平台降低,黏流温度升高.在温度黏弹谱中,与纯PET相比PET/纳米TiO2复合体系的嶙a变提前,储能模量增加,低温下损耗模量也有所增加.     

Tensile Stress Relaxation of Alumina at High Temperature

The development of a tensile testing methodology for ceramics which enables a stress vs strain-rate response to be measured at high temperature is described. The test involves a carefully controled stress relaxation test at constant total strain using an experimental procedure and phenomenological analysis previously developed for metallic materials. It is demonstrated here with preliminary tests on alumina at 1050° and 1150°C. This offers, with further development, the possibility of establishing design stresses associated with low strain-rate behavior for structural applications. The results demonstrate that data covering four decades of strain rate may be generated in tests lasting a few hours. The inelastic strain consists of substantial anelastic recoverable strain in addition to a permanent creep strain.     

原子磁强计检测光闭环稳定系统设计

SERF态原子磁强计已实现人类历史上最高的0.16fT/Hz1/2的灵敏度。其检测方法主要是法拉第调制法。但法拉第调制法中光电流摄动或环境温度变化等干扰导致的检测光强的起伏会造成检测结果的不准确。为抑制检测光强起伏,设计了闭环原子磁强计检测光稳定系统。在法拉第调制法的基础上,增加了光路子系统和控制子系统对检测光强进行闭环稳定控制。通过对随机干扰进行闭环控制仿真与实验,验证本系统可以有效抑制各种干扰引起的光强起伏,使系统抗干扰能力提高1.2%,从而提高原子磁强计的检测精度。     

Comparative study of the physical aging of the epoxy systems BADGE n = 0/m‐XDA and BADGE n = 0/m‐XDA/PEI

The physical aging of the epoxy network consisting of a diglycidyl ether of bisphenol A, m‐xylylenediamine, and polyetherimide was studied by differential scanning calorimetry. The glass transition temperature and the variation of the specific heat capacities have been calculated using the method, based on the intersection of both enthalpy–temperature lines for glassy and liquid states. The apparent activation energy (E_H) was calculated using a single method that involved separate temperature and excess enthalpy dependency. All calorimetric data were compared with those obtained for the epoxy network without thermoplastic. thermoplastic. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci 103: 3931–3935, 2006     

基于虚拟仪器技术的地下水探测系统研究

为了整合磁共振测深(MRS)地下水探测系统的测量与反演功能,结合LabVIEW软件在测量与信号处理方面的优势,利用虚拟仪器技术开发了地下水探测系统的上位机系统软件,实现了对探测系统整个操作流程的管理。根据已知探测地区的拉莫尔频率产生激发信号,送至发射/接收线圈,利用快速关断技术实现了发射与接收的快速切换。将采集的弛豫衰减信号送至反演解释算法模块,采用改进的量子遗传算法与截断奇异值分解(TSVD)的联合方法,反演解释了地下含水层的水文地质参数。野外试验表明,该探测系统的工作稳定性好,验证了反演结果的准确性。