二元气体等温吸附-解吸中气分的变化规律

进行了CH4—CO2和CH4-N2二元混合气体的等温解吸实验，分析了二元气体在解吸过程中各组分浓度的变化规律．结果表明，在CH4-N2二元气体的解吸过程中，吸附相中CH4组分的相对浓度逐渐增加，N2组分的相对浓度逐渐减少．在CO2-CH4二元气体的解吸过程中，吸附相中CO2组分的相对浓度逐渐增加，CH4组分的相对浓度逐渐减少．实验结果还证实了CO2在与CH4的竞争吸附中占据优势，而N2在与CH4的竞争吸附中处于劣势．注入CO2比注入N2可以更有效地置换或驱替煤层甲烷，提高煤层甲烷的采收率．     

垃圾填埋场矿化垃圾对废水中磷的吸附特性研究

采用恒温培养方法研究了矿化垃圾对磷的吸附和解吸特性．同时与三种不同水稻土的磷吸附特性进行对比实验。结果表明．矿化垃圾对废水中磷的等温吸附曲线与Langmuir、Freundlich及Termkin。等温吸附方程的拟合度均达到显著水平。与水稻土相比，矿化垃圾磷吸附容量大，吸附态磷的解吸速率与水稻土非常接近。     

Atmospheric effects of friction,friction noise and wear with silicon and diamond. Part II. SEM tribometry of silicon in vacuum and hydrogen

Scanning electron microscope (SEM) tribometric data on polycrystalline silicon (poly-Si) vs. poly-Si, Si(100) vs. Si(100) and Si(111) vs. Si(111) interfaces, obtained in Torr and in 0.2 Torr partial pressure of hydrogen gas ( ) from room temperature to 850^°C, were performed under standard and much slower thermal ramping rates. The friction data were analyzed per the methodology described in part I of this paper series. The results indicate a highly beneficial friction- and wear-reducing regime within a relatively narrow thermal region. This desirable region coincides with some chemisorption of excited species of molecular hydrogen just before the mass thermal desorption of surface hydrides. These data represent the tribochemical equivalent of a method routinely used in electronics, whereby deep electron traps (dangling Si bonds) are passivated by baking in molecular hydrogen. The also exerts a moderating influence on the size of the friction noise at all test temperatures. However, the general level of friction beyond the beneficial thermal region is high. In parallel, the general wear rate of Si representative of the entire range of standard thermal ramping in both atmospheric environments is in the extremely high 10^-12m³/(N m) range. Operating strictly in the beneficial, low-friction thermal regime resulted in a several orders-of-magnitude reduction in the wear rate over those measured under standard thermal ramping conditions. Although the results confirm previous findings that Si is not a good material of construction for miniaturized moving mechanical assemblies (e.g., microbearings and gears), there seems to be some limited possibility of gas-phase lubrication of Si micromechanisms with rarefied hydrogen at surface temperatures between 100 and 300^°C. This revised version was published online in July 2006 with corrections to the Cover Date.     

The Effect of Drying Temperature on Physical Properties of Thin Gelatin Films

The molecular morphology of thin gelatin films, controlled through the casting temperature, was monitored by wide angle X-ray diffraction (WAXD) and differential scanning calorimetry (DSC). Gelatin films dried at lower temperatures had a markedly higher crystalline or helical structure with a slightly higher T_g and lower ΔC_p compared with hot dried films, which had a more coiled structure. The relationship between molecular morphology and gelatin-water interaction in terms of hydration behavior and water diffusivity was assessed using dynamic vapor sorption (DVS). The sorption capacity increased and the level of hysteresis decreased with increasing the degree of crystallinity. The difference in the aging behavior of the films was explained in terms of the difference between the glass transition and aging temperatures, (Tg – Ta).     

Selective elution of tea catechins and caffeine from polyvinylpolypyrrolidone

Desorption of catechins and caffeine from polyvinylpolypyrrolidone (PVPP) was comprehensively investigated. The result showed that caffeine could easily be desorbed from PVPP by the tested solvents except n‐hexane, while catechins could only be thoroughly done by dimethyl sulphoxide (DMSO) and N, N‐dimethylformamide (DMF). Excellent desorption efficiency of DMSO and DMF might be attributed to their high dipole moments and H‐bond potentials. Addition of ethanol was recommended considering the elution efficiency and fluidity, but ethanol volume should be <40% (v/v) for DMSO or 20% (v/v) for DMF. Desorption would get to equilibrium within 1 h and followed the pseudo‐second‐order model. Caffeine and catechins could be separately desorbed through two‐stage elution procedure, that is, water or 20% aqueous ethanol for desorbing caffeine and part of nongalloylated catechins and DMSO/ethanol (8/2, v/v) for eluting the remaining catechins. Highly purified catechins (~95%) with high level (~70%) galloylated catechins would be achieved when the desorption procedure was applied in column chromatograph.     

MALDI Q-TOF CID MS for Diagnostic Ion Screening of Human Milk Oligosaccharide Samples

Human milk oligosaccharides (HMO) represent the bioactive components of human milk, influencing the infant’s gastrointestinal microflora and immune system. Structurally, they represent a highly complex class of analyte, where the main core oligosaccharide structures are built from galactose and N-acetylglucosamine, linked by 1–3 or 1–4 glycosidic linkages and potentially modified with fucose and sialic acid residues. The core structures can be linear or branched. Additional structural complexity in samples can be induced by endogenous exoglycosidase activity or chemical procedures during the sample preparation. Here, we show that using matrix-assisted laser desorption/ionization (MALDI) quadrupole-time-of-flight (Q-TOF) collision-induced dissociation (CID) as a fast screening method, diagnostic structural information about single oligosaccharide components present in a complex mixture can be obtained. According to sequencing data on 14 out of 22 parent ions detected in a single high molecular weight oligosaccharide chromatographic fraction, 20 different oligosaccharide structure types, corresponding to over 30 isomeric oligosaccharide structures and over 100 possible HMO isomers when biosynthetic linkage variations were taken into account, were postulated. For MS/MS data analysis, we used the de novo sequencing approach using diagnostic ion analysis on reduced oligosaccharides by following known biosynthetic rules. Using this approach, de novo characterization has been achieved also for the structures, which could not have been predicted.     

Recovery of rare earth metals through biosorption： An overview

Rare earth metals (REMs) are a series of 17 elements that have widespread and unique applications in high technology, power generation, communications, and defense industries. These resources are also ...     

Aerosol laser time-of-flight mass spectrometer for the on-line measurement of secondary organic aerosol in smog chamber

An aerosol laser time of flight mass spectrometer (ALTOFMS) that can be used for real-time measurement of the size and composition of individual aerosol particles has been designed and utilized to provide on-line measurement of secondary organic aerosol (SOA) particles resulted from Cl-initiated oxidation of toluene in smog chamber. Both the size and chemical compositions of individual aerosol particles were obtained in real-time. According to a large number of single aerosol diameters and mass spectra, the size distribution and chemical composition of aerosol were determined statistically. Experimental results indicate that aerosol particles produced from Cl-initiated oxidation of toluene were predominantly in the form of PM 2.5 particles, and nine positive laser desorption/ionization mass spectra peaks: m/z 18, 29, 30, 44, 46, 52, 65, 77, and 94 may come from the fragment ions of the products of the SOA: aromatic aldehydes, aromatic acids, phenolic compounds, and nitrogenated organic compounds. These results were in good agreement with those ones from previous Cl-initiated oxidation of toluene. These were demonstrated that ALTOFMS is a useful tool to reveal the formation and transformation processes of SOA particles in smog chamber.     

顺酐溶剂吸收装置的关键控制工艺分析

吐哈石化厂通过引进意大利CONSER公司的溶剂吸收工艺,对原有水吸收工艺进行改造。通过对CONSER溶剂吸收工艺的研究,分别对溶剂吸收装置中的溶剂吸收系统、溶剂解析系统和溶剂洗涤系统操作过程中的关键控制工艺进行分析,提出了可行的生产控制指导建议。