High-temperature,high-pressure thermophysical measurements on liquid zinc

Wire-shaped zinc samples were resistively volume heated as part of a fast-capacitor discharge circuit. Time-resolved measurements with submicrosecond resolution of the current through the specimen, the voltage drop across it, and the thermal expansion of the specimen as a function of time allow determination of the enthalpy, electrical resistivity, and density at different temperatures up to superheated liquid states of zinc far above the normal boiling point. High static pressures, up to 3800 bar of the ambient medium water, were used. An estimate of the critical pressure for zinc is given by investigations of the stability of the sample with a framing CCD camera, taking pictures of different samples varying the ambient static pressure. The critical volume and the critical temperature are obtained by means of an extrapolation of measured data at different pressures.Paper presented at the Fourth International Workshop on Subsecond Thermophysics, June 27–29, 1995, Köln, Germany.     

提高铌钽标准液显色反应能力并延长其有效贮存期的分光光度法研究

铌，钽的酒石酸，柠檬酸，草酸铵标准液的显色反应能力及有效贮存期，同铌，钽的原始标准溶液ｐＨ有很大关系，铌酒石酸标准液（原始溶液ｐＨ１．４），其显色反应能力仅在８０％～５０％之间（视放置时间长短而异），但如何采用ｐＨ４．５～５．０的铌酒石酸标准液，其显色反应能力达１００％，即使贮存４４０ｄ后，仍能保持原有的显色反应能力，铌柠檬酸标准液（原始溶液ｐＨ１．２），无论用本法（Ｎｂ－ＢＰＲ－ＣＰＢ法）还是用     

约束放电激励千瓦级基模CO2激光器

本文研究了约束放电激励千瓦级基模CO2激光器。约束放电激励的思想核心是:利用正交或基本正交的电场或者电磁场在阴极位降区附近形成对带电粒子的捕集阱,由此产生对放电过程中从阴极发出的带电粒子的约束作用从而影响整个气体放电激励过程。     

铯原子激光共振电离

用Ｎｄ：ＹＡＧ及其泵浦的染料激光进行铯原子三步共振电离。求解了非饱和共振过程速率方程，计算出基态和激发态共振吸收截面，给出电离效率分别与激发电离速率以及作用时间的变化关系，得到饱和激发电离的流量条件和通量条件。     

Relaxation phenomena caused by equilibration of point defects

Relaxation phenomena due to equilibration of point defects in metals are reviewed. The relaxation effect in specific heat observed in tungsten and platinum confirms that in both cases the nonlinear increase in the high-temperature specific heat has to be attributed to point-defect formation. Relaxation phenomena observed by measurements of electrical resistivity and positron annihilation are also considered. The comparison of the data seems to be favorable for the conclusion that all the phenomena are of one origin.     

Carbon fibre cloth as an electrode material: electrical conductivity and mass transfer

The paper deals with carbon fibre cloth electrodes, employed in the fabrication of composite materials. The electrical conductivity of single bundles, groups of bundles and cloth is studied. Ohm's law applies to the electrical conduction in the direction of the fibre length, but bundle conductivity decreases with the number of fibres in the bundle. Electrochemical mass transfer between a flowing electrolyte and a cloth arranged as a flow-through or a flow-by porous electrode indicates the existence of double porosity in the material. Due to double porosity, only the external surface of the cloth works as an electrode. This finding shows that the material is not suitable for such an application.     

激光器绝热啁啾对光纤通信系统传输特性的影响

通过理论分析、实验和计算机模拟得到：进行直接强度调制时，体块型DFB激光器的总微分量子效率（与多量子阱DFB激光器相比）过低，从而导致其绝热啁啾占激光器啁啾的主要部分；用于无再生中继距离较大的强度调制／直接检测（IM／DD）光纤通信系统时，色散效应将导致信号脉冲上升沿压缩，使系统误码率增加。据此建议：在无再生中继距离大于100～120km的常规单模光纤IM／DD系统中，应采用多量子阱激光器。     

低空间频率银盐明胶全息图的浮雕特性研究及其应用

通过实验研究表明，对低空间频率的振幅型银盐全息图形表面已形成浮雕，经漂白，浮雕深度成倍加深；浮雕深度随空间频率而变化，并且可用不同曝光量进行调制。选择适当条件，可降低零级光强，提高全息图的一级衍射效率。     

本征吸除硅片特性研究

本文描述硅本征吸杂片的特性参数,如吸除区宽度、洁净度,氧沉淀密度、MOS电容寿命,介绍了表面态密度及残余间隙氧浓度的检测方法和工艺对参数的影响及参数之间的内在联系,文章还实验论证了不同参数水平对器件成品率的影响,建立了以MOS电容寿命为主导的参数控制方法,利用本文提供的控制参数,可使CCD-512器件成品率达60％,以上优品率≥85％。     

可燃性粉尘环境用电气设备标准介绍

章着重对可燃性粉尘环境用电气设备新标准（GB12476．1－2000和GB12476．2－2XXX）的主要内容进行了介绍，并对粉尘的爆炸机理，国内外粉尘标准体系等进行了阐述。