裂齿矩形翅片板翅式换热器优化设计的分析

对裂齿矩形翅片板翅式换热器中的裂齿矩形翅片的传热效率作了分析,并以单位质量材耗的换热能力最大为目标函数,分析研究了在不同雷诺数(Re)的操作条件下裂齿矩形翅片间角度、翅片厚、长度、宽度及极厚之间的关系。结果表明:在气体换热的场合下,当Re在某一范围时翅片可有效地起到强化传热的作用。当板厚为5mm,翅片厚为3mm,翅片间夹角为45°～70°,Re为2×10~3～8×10~3,最佳翅片纵向间距与翅片长度和翅片厚度乘积的平方根的比为1.5～2.5,最佳翅片尺寸系数为3～5时,传热强化效果较好。     

Experience, Context, and the Visual Perception of Human Movement.

Why are human observers particularly sensitive to human movement? Seven experiments examined the roles of visual experience and motor processes in human movement perception by comparing visual sensitivities to point-light displays of familiar, unusual, and impossible gaits across gait-speed and identity discrimination tasks. In both tasks, visual sensitivity to physically possible gaits was superior to visual sensitivity to physically impossible gaits, supporting perception-action coupling theories of human movement perception. Visual experience influenced walker-identity perception but not gait-speed discrimination. Thus, both motor experience and visual experience define visual sensitivity to human movement. An ecological perspective can be used to define the conditions necessary for experience-dependent sensitivity to human movement. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

会计政策选择的效率性分析

会计政策选择类型在理论上大体可分为机会主义型和效率(或有效契约)型。会计政策选择具有效率性,但也为经理人员的机会主义行为打开了大门。在我国,由于企业缺乏一系列有效的激励约束机制,会计政策选择的机会主义仍然严重。为此,必须建立适合我国企业有效的激励约束机制。     

氧化铝熟料单筒冷却机节能技术改造

本对影响氧化铝熟料单筒冷却机冷却效率的因素进行了分析，并提出了相应的节能技术改造措施，取得了明显的节能效益。     

河北冶金实验厂8MN快锻液压机电控系统选择

着重阐述了河北冶金实验厂８ＭＮ快锻液压机电控系统的选择过程。经过反复考察，论证，对比，最终所选的压机电控系统为目前国产快锻液压机中自动化水平最高的锻造设备。     

AHMED experiments on hygroscopic and inert aerosol behaviour in LWR containment conditions: experimental results

Hygroscopic NaOH, CsI, CsOH and inert Ag aerosol behaviour at different temperatures and relative humidities (RH) has been studied in a well instrumented and controlled vessel of 1.81 m³ total free volume. Homogeneous thermal-hydraulic conditions for aerosol measurement in the vessel were achieved. The aerosol number and mass concentration were measured continuously during the experiments using a Condensation Nucleus Counter and a Tapered Element Oscillating Microbalance. The particle size distribution and chemical composition in the test conditions were measured by Berner low pressure impactors. In the case of NaOH the half life of the aerosol mass concentration was more than four times longer at low RH (22%) as compared to high RH (96%). The half lives of the CsOH and CsI aerosols were only twice as long at low RH as compared to high RH. Thus at high RH (96–97%) the half lives of CsOH and CsI were twice as long as the half life for the NaOH aerosol. The faster decay of the NaOH aerosol is due to the smaller density decrease of NaOH during water condensation. CsOH particles grew rapidly to their equilibrium size at all humidities. The measured equilibrium size for CsOH aerosol agree well with the calculated particle size at different RHs. Experimental results were also compared with calculations obtained by severe accident computer codes. These calculated results will be presented in a later paper.     

预测水驱油田开发动态的一种方法

水驱曲线法和数学模型法都是油藏工程中的重要方法，前者主要用于在一定的经济含水条件下预测水驱油田的可采储量和采收率，后者主要用于预测不同类型油田的产量、累积产量和一定经济极限产量下的可采储量。然而，前者与时间序列无关，后者与含水率序列无关，都有局限性。提出丙型水驱曲线公式与ＨＣＺ数学模型公式联解预测法，不但可以预测水驱油田产量、累积产量、含水率随时间的变化，还可预测可采储量、可动油储量和水驱波及体积系数的变化。图３表１参１２（陈志宏摘）     

Some factors affecting the electrical properties of carbon-black-loaded butyl rubber during vulcanization

Butyl rubber mixtures loaded with 70 phr general purpose furnace black (GPF) and tetramethyl thiuram disulphide (TMTD)/S as vulcanizing system were prepared. The kinetics of their electrical conductivity development during the vulcanization process were followed by using an especially devised system. It was found that the increase in the electrical conductivity during vulcanization obeys an exponential growth function with time constant τ, which markedly decreases with increasing vulcanization temperature as well as with the efficiency of the vulcanizing system. After completion of the vulcanization process, about 80 min, the samples obtained possess reasonable stability and reproducibility of electrical conductivity.     

直流电动机参数测定

根据直流电机的可逆原理并利用常规的实验仪表，可以简便、准确地测出直流电动机的主要参数－电磁转矩、输出转矩和效率．