Introduction to geothermal exploration on ascension island, South Atlantic Ocean

The exploration for a geothermal resource on Ascension Island utilized a strategy that initially employed geologic mapping. On the basis of this, subsurface faults were mapped using an aeromagnetic survey. The faults were then explored using electrical resistivity surveys to define areas of potential hydrothermal fluid up-welling. The results of all of these techniques were used to site temperature gradient holes. A deep geothermal exploration well was then drilled in the area with highest heat flow adjacent to a rhyolite-to-trachyte volcanic complex.     

低温粉碎系统中旋风分离器设计

旋风分离器是一种应用离心力进行粉体分离的设备。低温粉碎系统应用它分离粉体并起集粉作用。它的效率决定了物质回收率。本文从离心加速度与重力加速度的比值，筒体的高低，筒体直径，进口速度叙述对分离器效率的影响。着重叙述筒体直径确定方法，以及我们设计造长筒形旋风分离器的具体结构和令人满意的试验结果。     

碱性氰化物防渗碳光亮镀铜工艺的研究

本文介绍了一种高效率，高韧性，防渗碳底铜工艺，可以大辐度提高镀层的沉积速度，降低铜层孔隙率，提高产品合格率，具有显著的经济效益和社会效益。     

太钢4号高炉喷煤站应用MFD—Ⅲ型布袋除尘器的实践

太钢４号高炉喷煤站从１９９０年起采用ＭＦＤ－Ⅲ型脉动反吹式布袋除尘器。这种除尘器采用脉动式反吹清灰设施，合理布置布袋间距，布袋支撑骨架及选用针呢材质的布袋，过滤面积大，反吹清灰效果好，设备运行平稳，除尘效率高达９９．８％，排放浓度小于１０ｍｇ／ｍ＾３，故障率低。     

LaCrMnNiO系热敏陶瓷的微观结构控制

通过对不同配方、工艺下的ＬａＣｒＭｎＮｉＯ系热敏陶瓷的微观结构研究，指出材料的相组成对其宏观电性能的影响，并提出了通过复合工艺利用“过渡相”的形成，对材料的“最终相”加以控制的方法。文中列出了使用ＸＲＤ及ＸＰＳ手段对材料微观结构的分析结果及有关电性能的测试数据。     

发展我国电动汽车的对策

本文根据目前国内外的最新资料，论述了电动汽车的优缺点，介绍了我国电动汽车发展状况，文章从当前电动汽车已达到的技术水平和我国环境污染、能源短缺的实际需要出发，提出了发展我国电动汽车的对策．     

一种双光束自动测试光栅绝对与相对光谱衍射效率的原理性方案

提出了一种快速自动测试光栅光谱衍射效率的新方法。重点推导了测试平面光栅绝对光谱衍射效率与相对光谱衍射效率公式，介绍了双光束高精度自动测试光栅光谱衍射效率曲线的基本原理、方案与方法，并分析了测试精度。研究表明，本方案的测试速度和精度均比一般测试方法提高一倍，并能有效地消除光源波动对测量结果的影响，测量误差小于５×１０－３。     

GIC－4117／HC1．7MV Tandetron上的MeV离子注入系统

利用通用离子公司（ＧＩＣ）的４１１７型１．７ＭＶＴａｎｄｅｔｒｏｎ离子束分析设备进行ＭｅＶ级离子注入。所注入的离子能量范围由５００ｋｅＶ到１０ＭｅＶ，离子的质量在２４０ｕ以下，某些元素的负离子束流强度在１５０μＡ以上。双向机械扫描技术可将离子均匀地注入样片。     

F级高云母含量云母带的研制及应用

本文介绍了一种F级高云母含量云母带，它的主要特点是云母含量高达48％以上，具有良好的长时间耐电热老化性能，适用于高压电机主绝缘多胶模压工艺要求，该云母带的应用对提高电机绝缘水平和延长电机使用寿命具有重要意义。     

Comparison of mass transfer efficiency in horizontal rotating packed beds and rotating biological contactors

In this study, the mass transfer efficiencies of a novel horizontal rotating packed (h‐RPB) bed and the conventional disc‐type rotating biological contactor (RBC) were studied at four speeds and seven submergences. Pall rings of two different sizes (25, 38 mm), superintalox saddles and a wiremesh spiral bundle were used as packings in the h‐RPB. Volumetric gas–liquid mass transfer coefficients were determined by unsteady state absorption of atmospheric oxygen in de‐aerated water. Power consumption per unit liquid volume has been found for all geometries tested. The oxygen transfer efficiency values for the h‐RPB were found to be 2–5 kg kWh^?1 and for the disc RBC were found to be 1–2 kg kWh^?1. The performance of the h‐RPB was also compared with other gas–liquid contactors such as surface aerators. The study proves that the h‐RPB is a energy efficient alternative to conventional contactors. Copyright © 2005 Society of Chemical Industry