GMA接枝SEBS及其对PA 6的改性及增容

用双螺杆反应挤出法将甲基丙烯酸缩水甘油酯(GMA)接枝到氢化苯乙烯-丁二烯-苯乙烯嵌段共聚物(SEBS)上(即SEBS-g-GMA)，研究引发剂过氧化二异丙苯用量、活性单体GMA用量对接枝率的影响；通过双螺杆挤出、共混，制备聚酰胺(PA)6／SEBS-g-GMA、PA 6／SEBS-g-GMA／SEBS合金，研究SEBS-g-GMA对合金体系的相容性影响及增韧作用，探讨了合金体系的形态结构和力学性能。     

核壳型含氟丙烯酸酯共聚乳液

以十二烷基硫酸钠（SDS）和壬基酚聚氧乙烯基醚（OP-10）为复合乳化剂，甲基丙烯酸十二氟庚酯（Actyflon-God）、甲基丙烯酸甲酯（MMA）、丙烯酸丁酯（BA）为原料制备了壳层含氟的核壳型丙烯酸酯共聚物乳液。用红外光谱（FT—IR）表征乳胶膜化学组成，用透射电子显微镜（TEM）观察了乳胶粒的微观形态结构，并用X射线光电子能谱（XPS）进行了表面分析。发现氟有向空气与膜面迁徙的现象。通过吸水率表征含氟丙烯酸酯共聚物乳胶膜的表面性能，结果表明含氟量增加使乳胶膜吸水率大大降低。     

聚甲基丙烯酸甲酯／纳米SiO2复合粒子的制备与表征

采用甲基丙烯酸-3-甲氧基硅丙酯（MPs）对分散于甲基丙烯酸甲酯（MMA）中的纳米SiO2粒子进行偶联改性，得到了表面改性的纳米SiO2单体分散液，用原位悬浮聚合方法制备了不同SiO2含量的PMMA／纳米SiO2复合粒子。通过红外光谱、透射电镜、差示扫描量热分析和热重分析等方法对制备的纳米复合粒子进行了表征，结果表明，纳米SiO2粒子在PMMA中分散良好；MMA可通过与MPS的共聚而有效地接枝到SiO2粒子表面，当SiO2含量为6．6％（质量分数，下同）、MPS用量为0．06g／gSiO2时，其接枝率可达73．8％；同时，纳米SiO2的引入可提高PMMA的耐热性能，当Si02含量为14.7％时，其玻璃化转变温度和最大热分解速率时的温度分别提高了11．8℃和18．8℃。     

DSC and synchrotron-radiation X-ray diffraction studies on crystallization and polymorphic behavior of palm stearin in bulk and oil-in-water emulsion states

The crystallization and polymorphic behavior of palm stearin (PS) in a bulk state and in oil-in-water (O/W) emulsion droplets (average diameter, 1.7±0.3 μm) was observed by using DSC, optical microscopy, and in situ X-ray diffraction with synchrotron radiation (SR-XRD). For the bulk sample the DSC measurements revealed three main exothermic peaks at approximately 31 (large), 21 (small) and 3°C (medium) on cooling, and broad endothermic peaks at approximate −3 (small), 8, 15 to 25 (medium), and 37 and 53°C upon heating. The SR-XRD patterns taken during cooling from 60 to −5°C clarified that the DSC exothermic peaks around 31 and 3°C corresponded to crystallization of the α form of high-melting and low-melting fractions, respectively, and that the occurrence of β′ corresponded to the small exothermic peak around 21°C. The XR-XRD patterns taken during heating from −5 to 60°C demonstrated that the DSC endothermic peaks corresponded to the following transformation processes: melting of α of the low-melting fraction (−3°C), melt-mediated transformation from α to ∇′ (15–25°C), melting of β′ (36°C), and melting of β (53°C) of the high-melting fraction. As for the O/W emulsion sample, the DSC and SR-XRD measurements during the cooling and heating processes exhibited basically the same behavior as that of PS in the bulk state, except that β′ did not crystallize during the cooling process, and the temperatures of crystallization of α, melt-mediated α→β′→β transformation, and melting of β were lower in the emulsion droplets than in the bulk state.     

AC/MMA接枝改性天然胶乳的制备及性能研究

以丙烯基氯（AC）和甲基丙烯酸甲酯（MMA）接技改性天然胶乳，采用正交试验方法研究引发剂用量，反应温度，单体配比，胶乳浓度等对接枝聚合反应中单体转化率和接枝率的影响，测试了改性天然胶乳的粘度，粘接性能及其硫化胶膜的力学性能，耐溶剂性和阻燃性，结果表明，适宜的接枝聚合反应条件为：引发剂异丙苯过氧化氢（CHP）和四乙烯五胺（TEP）的质量分数分别为0．58％和0．36％－0．72％（占橡胶质量的百分率）、反应温度为30℃、单体体积配比v（MMA）：v(AC）＝1．5：1、胶乳质量分数为53．3％，所得接枝胶乳粘度较高，粘结性能较好，耐溶剂性能剂，且有较好阻燃性。     

Immobilization of a cyclodextrin glucanotransferase (CGTase) onto polyethylene film with a carboxylic acid group and production of cyclodextrins from corn starch using CGTase‐immobilized PE film

Carboxylic acid groups were introduced onto polyethylene (PE) film by radiation‐induced graft copolymerization. Subsequently, the clodextrin glucanotransferase (CGTase) was immobilized on the PE film with a carboxylic acid group. The activity of the immobilized CGTase on PE film was in the range of 0.40–1.04 U/cm² per min. The production of cyclodextrins (CDs) from corn starch was examined using the CGTase‐immobilized PE film. The production ratios of CDs using CGTase‐immobilized PE film was in the following order: α–CD > β–CD > γ–CD. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 85: 2451–2457, 2002     

醋酸乙烯-丙烯酸无皂乳液共聚的研究

以醋酸乙烯(VAc)为主单体,丙烯酸(AA)为改性功能单体,以半连续加料方式进行无皂乳液共聚过程,得到了稳定且固含量为30%左右的乳液。探讨了功能单体AA含量、反应温度等对共聚的影响。采用FT-IR、粒径分析等方法对共聚物的组成、乳胶粒子的尺寸及分布进行了分析表征。结果表明:在(65±2)℃下聚合,所得乳液稳定性好、转化率高、反应完全,且随着功能单体AA含量的增加,乳液黏度上升、单体转化率下降、乳胶粒粒径变小且粒径呈单分散性。     

丙烯酸酯乳液的改性研究

制备了丙烯酸酯乳液,探讨了丙烯酸、N-羟甲基丙烯酰胺、二乙烯基苯、丙烯腈和三聚氰胺等不同改性剂对乳液性能的影响,在此基础上通过互穿网络聚合、化学共聚及物理共混等方法对乳液的性能进行了改性研究。     

改性聚醋酸乙烯酯乳液胶粘剂的研究进展

综述了国内外改性聚醋酸乙烯酯乳液胶粘剂的研究进展,并对聚醋酸乙烯酯乳液胶粘剂的改性研究提出了一些建议和展望。     

纳米TiO2的分散及在水性涂料中的应用研究

研究了各因素对纳米TiO2水悬浮液稳定性的影响,通过正交试验筛选出了最佳的分散工艺,解决了纳米TiO2在水性介质中的团聚问题.将分散后的纳米TiO2浆料加入到普通的水性苯丙乳液涂料中,加入各种助剂配制出了性能优异的水性纳米TiO2涂料,并对涂料的性能进行了测试.