Effects of ion group content and polyol molecular weight on physical properties of HTPB‐based waterborne poly(urethane‐urea)s

A series of waterborne poly(urethane‐urea)s, WPUUs, based on using nonpolar hydroxyl‐terminated polybutadiene (HTPB) as the soft segment, were successfully synthesized in this article. The effects of the COOH group content and soft‐segment molecular weight (Mn_s) on the dispersion, morphology, and physical properties were investigated. Variations of the particle size, viscosity, and zeta potential were first governed by the hydrophilicity of the polymer chain, and then by the swelling derived from water. Fourier transfer infrared spectroscopy (FTIR) and differential scanning calorimetry (DSC) indicated that the degree of phase separation decreased as the COOH group content increased or as Mn_s decreased. However, the hydrogen bonding between the soft and hard segments and the two‐phase mixing could not occur in this nonpolar HTPB‐based WPUU system, indicating that the hard segments tended to form smaller domains and to pack more loosely. It was attributed to the fact that the presence of bulky ionic salt groups destroyed the ordered arrangement of the hard segments. In this case, the increases of the interface area between the soft and hard phases resulted in that the present behaviors were similar to the phase mixing. In tensile properties, HTPB‐based WPUUs exhibited higher tensile stress, elongation at break, and modulus as the COOH group content decreased or as Mn_s decreased. In thermal degradation, the introduction of HTPB polyol improved the thermal stability of WPUU. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci, 2007     

炭黑填充硬聚氯乙烯的改性

为使聚氯乙烯具有抗静电性能,采用加入具有导电性填料的方法,但加入大量的填料,会使硬聚氯乙烯的冲击性能降低,加工性能变差。本文是在以炭黑为填料的基础上,研究不同的改性剂和加工助剂改进硬聚氯乙烯的效果,结果表明,加入冲击改性剂和加工助剂后,大大增加了硬聚氯乙烯的冲击强度,且加工性能也得到改善,同时由于炭黑具有补强效果,其拉伸强度和弯曲强度在加入改性剂后也能满足使用要求。     

Gas Hold‐Up in Stirred Tank Reactors in the Presence of Inorganic Electrolytes

Gas hold‐up (?_G) in air‐aqueous electrolyte solutions in stirred tank reactors (STR) is correlated using a relative gas dispersion parameter, N/N_cd and a surface tension factor (STF), (c/z)(dδ/dc)². For electrolyte concentration below transition concentration (c_t) a single correlation in the form of ?_G = f(N/N_cd, vvm, STF) shows good agreement with gas hold‐up data over a wide range of system and operating conditions. Above ct no effect of STF on gas hold‐up is observed and the correlation obtained is of the form ?_G = f(N/N_cd, vvm). Data available in the literature on large STR show good fit with the proposed correlation.     

Ultrasonic Dispersion of Ceramic Powders

Ultrasonication is very effective in dispersing alumina and barium titanate slurries. When optimum conditions are used, very short durations (2 to 3 min) are enough to achieve well-dispersed, stable suspensions.     

Self-emulsifiable soybean oil phosphate ester polyols for low-VOC corrosion resistant coatings

A series of soybean oil phosphate ester polyols (SOPEP) was prepared by reaction of fully epoxidized soybean oil with phosphoric acid and simultanoeous hydrolysis in the presence of a polar solvent. The polyols were characterized by determination of acid value, oxirane number, hydroxyl value, molecular weight (GPC), and FTIR spectra. These polyols with varying amounts of acid phosphate groups could be self-emulsified to form aqueous dispersions after neutralization with organic base. These aqueous dispersion showed varying degrees of stability and their appearance ranged from opaque dispersions to translucent to clear solutions. Waterborne coating compositions were prepared using these aqueous dispersions as principal components and their thermally cured film properties were studied. it was found that by careful selection and formulation, SOPEPs can be successfully used for low-VOC waterborne coating formulations. SOPEPs with 3.5% phosphate ester content showed visibly superior corrosion resistance properties.     

Étude expérimentale du mélange réactif au sein d'un réacteur torique ondulé (RTO)

Reactive mixing in a wavy torus reactor (WTR) has been examined experimentally. Its performances are compared to these of two other reactors: a plane torus reactor (PTR) and a baffled stirred tank reactor (BSTR). hydrodynamics of mixing has been studied using a plug flow model with axial dispersion for the WTR and PTR. The effect of axial dispersion on the kinetic of a chemical reaction was then analysed for the WTR, PTR and BSTR. Mixing times were slightly longer for the WTR due to a weaker axial dispersion. We also noticed an improvement of the convertion rate for low dissipated power.     

工业聚合反应装置—Ⅶ.悬浮聚合反应器（下）

讨论了悬浮聚合反应器的放大问题及计算机控制技术，介绍了具有预分散器的悬浮聚合反应器和连续悬浮聚合反应器。     

An XPS study of dispersion and valence state of TiO2 supported vanadium oxide catalysts

Monolayer vanadium species are mainly in the V(V) valence state, but with XPS a small fraction of V⁴⁺ species are identified. Prolonged analysis treatment increases the V⁴⁺ concentration. With increasing vanadium concentration, a monolayer coverage corresponding to 1 mg V₂O₅ per m² develops, and it contains additional layers with a thickness of about 250 Å at 4 mg V₂O₅ per m², covering 3% of its surface area.     

环氧胶粘纳米涂层冲蚀磨损性能研究

向环氧树脂胶粘涂层中分别加入粉煤灰、纳米SiO2,通过改变磨料的粒度和含量,冲蚀的转角和转速,研究其耐冲蚀磨损性能。通过实验推荐了具有较好耐冲蚀能力的环氧树脂的最佳配方。     

汽车修补涂料色母用分散剂的选用

通过对树脂、颜料、分散剂和混合溶剂的选择和定量,合成了通用色母。用指研法检验色母的分散稳定性,用倾流法或指擦法检验颜料的流动性,介绍了影响色母分散稳定性和颜料流动性的因素和原理,着重讨论了汽车修补涂料色母的单色浆微脂技术中分散剂的复配分散。