WQ—10型煤气平焰烧嘴的半工业性试验研究

对ＷＱ－１０型煤气平焰烧嘴进行半工业性试验，得到了该烧嘴较长时间运行下的一些性能。结果表明，该烧嘴平火焰稳定，炉顶温度分布均匀，燃烧烟气中ＣＯ、ＮＯ含量达到了ＹＢ／Ｔ０６２－９４标准的要求。     

济钢350m^3高炉高富氧生产技术

分析了济钢350m^3高炉高富氧对产量,理论燃烧温度,炉况顺行状况,焦比和生产效益的影响,高富氧可提高产量,但升高焦比和高炉理论燃烧温度,一定程度上影响高炉顺行,存在富氧效益最大化的适宜富氧率.高炉生产应低富氧高喷煤,根据钢目前的情况,富氧率经2%-3%为宜.     

Flame retardant and the degradation mechanism of high impact polystyrene/Fe-montmorillonite nanocomposites

High impact polystyrene/Fe-montmorillonite (HIPS/Fe-MMT) nanocomposites were successfully prepared by melting intercalation. The nanostructures of HIPS/Fe-MMT were testified by X-ray diffraction (XRD) and transmission electron microscope (TEM). Corresponding to pure HIPS, the thermal stability of HIPS/Fe-MMT nanocomposites was notably improved. The peaks of heat release rate (PHRR) and the mass loss rate (MLR) were significantly reduced after the formation of the HIPS/Fe-MMT nanocomposites from cone calorimetry. And nanocomposites PHRR was further lower with the increase of Fe-MMT content in the range of 1 to 5 wt%. The degradation mechanism of HIPS and HIPS/Fe-MMT nanocomposites was conducted by pyrolysis gas chromatography mass spectrometry (Py-GC-MS). And the reason of the enhancement of thermal stability maybe is that structural iron is the operative site for radical trapping in the Fe-MMT and the nanostructure enhances the interaction of the chains of the HIPS.     

New fire‐protective intumescent coatings for wood

Polyurethane coatings are highly flammable, and because of their widespread applications on different substrates (wood, steel, and building materials), there is a need to increase their fire‐safety properties. Intumescent additives sharply suppress the flammability properties of polyurethane coatings. Two problems accompany intumescent additives: their high loading percentage and incompatibility with polyurethane coatings. In this research, we succeeded in increasing the compatibility by mixing intumescent additives with a butyl acrylate polymer and in lowering the flame‐retardant additive loading (up to 20%) by incorporating newly modified montmorillonite. The flammability properties of the new intumescent coatings were characterized with a cone calorimeter. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

导数火焰原子吸收法对调味品中锌的测定

将微量脉冲进样技术和导数火焰原子吸收法结合，建立了测定调味品中锌含量的新方法。该方法的检出限为0．013μg／mL，精密度4．46％，回收率96．67～113．33。     

有机纤维材料用软膜乳液阻燃剂的制备

采用甲醛、尿素、三聚氰胺、脒基脲磷酸盐为原料,以硼砂、硼酸、氨水为pH调节剂合成了保护胶;在保护胶存在下,以预乳化的丙烯酸酯混合单体于82-88℃共聚合成乳液,将其涂布于有机纤维材料,干燥后得软膜透明阻燃涂层。用其处理的涤棉布阻燃性能为:损毁长度68mm、续燃时间1s、阴燃时间3s、氧指数62、吸附干量287g/kg,处理的纸板的阻燃性能为:平均炭化长度77mm、平均续焰时间2s、平均续灼燃时间32s、吸附干量283g/kg。     

基于北斗卫星的森林火灾监控终端设计

针对传统森林火灾监控方式存在的受地形限制,导致火灾发现不及时和定位难的缺陷,设计了基于北斗卫星的森林火灾监控系统,实现了火灾智能识别和预警,并且可以对火源、火场进行快速定位和信息通报;终端包括烟采集处理模块、图像采集模块、DSP处理模块、ARM主控模块和北斗卫星通信模块五部分,从烟和火焰两个方面对森林实时进行监控,分别采用离子烟雾传感器和DSP火焰识别混合算法,提取火焰图像差值和火焰图像边界参数的方法,提高了识别的准确率;试验证明,系统具有结构简单、使用方便和识别智能化的特点。     

Al/Cu管异种材料火焰钎焊连接

采用火焰钎焊技术，实现了Al/Cu管异种材料的中温钎焊连接。所采用的改进型的CsF-AlF3钎剂Si粉含量在1％时，钎焊接头的抗裂性能最好。本试验所采用的钎剂具有熔点低、免清洗、无腐蚀、钎剂活性佳和接头抗裂性能好等优点，该技术达到了国内领先水平。     

磷氮阻燃腈纶结构性能及阻燃机理研究

研究了含磷酸二氢铵和脲复合阻燃剂的共混阻燃腈纶的结构和性能。研究表明，在纤维成形加工过程中，部分阻燃剂聚合生成聚磷酸铵和聚脲，阻燃剂以微粒状均匀分散并包埋在纤维内部；阻燃剂的加入使纤维高序区大分子间等距离排列的规整性和片状结构单元等距离平行排列的程度降低，热稳定性亦略有下降；但纤维的宏形态结构及物理机械性能没有明显变化；磷氮阻燃腈纶具有良好的阻燃性和阻燃耐久性，经碱洗２０次、水洗３０次后，阻燃剂的磷和氮的保留率分别高达８２．９％和８９．５％，纤维的ＬＯＩ值仍在２６％以上。     

Unsteady extinction mechanism of nonpremixed flame interacting with a vortex

The extinction mechanism of a CH₄/N₂-air counterflow nonpremixed flame interacting with a single vortex was numerically studied. An augmented reduced mechanism was used to treat the CH₄ oxidation reactions. The contribution of each term in the energy and the OH species equations were evaluated to investigate the unsteady extinction mechanism of nonpremixed flame. The flame temperature began to decrease due to the convection heat loss when the flame interacted with a vortex. The investigation of the radical behavior during the flame-vortex interaction process also provided useful information on the unsteady extinction mechanism. The OH radical concentration could be used as a good tracer of the state of the unsteady extinction of nonpremixed flame. The reduction mechanism of OH concentration was confirmed by analyzing the contribution of each term in the OH species equation. At initial stage of flame-vortex interaction, the OH production and consumption rates increased gradually, while the OH concentration was kept nearly constant. Near the extinction limit, the OH production rate decreased rapidly due to the low flame temperature, and the balance between the OH production and OH consumption by diffusion could not be maintained. The unsteady nonpremixed flame interacting with a vortex under the conditions of regime (V) shown in the spectral combustion diagram [Thévenin, D., Renard, P.H., Fiechtner, G.J., Gord, J.R., Rolon, J.C., 2000. Regimes of non-premixed flame-vortex interactions. Proceedings of the Combustion Institute 28, 2101-2108.] was finally extinguished due to low reactivity, which was induced by the low flame temperature.