紫杉醇母核全合成的初步思想实验

紫杉醇的全合成困难，许多工作还只能停留在实验室的模型化合物上。作者以思想实验方法提出了：先以Ｄ－Ａ反应形成Ａ环和Ｃ环，然后用两步形成Ｂ环，最后形成Ｄ环，以此完成紫杉醇母核的全合成。     

Monitoring water quality in reservoirs with IRS-1A-LISS-I

An attempt has been made to quantify the relationship between the variation in IRS-IA-LISS-I (Indian Remote Sensing Satellite-1A Linear Imaging Self-Scanning System) radiance data and field measured change in secchi disc depth. Secchi disc depth was measured for 47 predetermined sampling locations on reservoir surface water. At extinction depth (secchi depth), water samples were collected from all the sampling locations. Suspended sediments of eight locations representing various reaches of the reservoir were selected for mineralogical, particle size and optical properties analysis. The LISS-I radiance value in band 1 (0.45–0.52µm) band 2 (0-52–0.59 µm) and band 3 (0.62–0.68 µm) were used in a regression analysis. The absorption infrared band 4 (0.77–0.86 µm) was not included in the analysis. In these, the dependable variable was secchi depth (SD) and the LISS-I-radiance data was the estimator variable. Forty-seven data sets of 20 October 1988 from Tawa reservoir surface water were used to obtain an estimator equation for SD. The verification of the estimator equation was tested by applying it to a data set of 21 measurements of 28 September 1988 for this reservoir. The coefficient of correlation between observed and estimated values for the 28 September 1988 data set wasr=0.92 for SD, indicating that the equation could accurately predict the water clarity (SD) for this reservoir on new occasions from IRS-IA-LISS-I spectral data. It is shown that mineral composition and optical properties of suspended sediments influence the reflected radiance of water quality. It is concluded that IRS-IA-LISS-I data provide a useful means of mapping water quality in reservoir.     

房地产开发企业会计核算问题探讨

本文就房地产开发企业会计核算的现状及特点进行了分析,并提出了完善房地产开发企业会计核算规范的对策。     

适用于LED显示屏或照明工程的异步控制卡DS2000-M1

DS2000-M1是高性能、开放式的LED控制系统,本文从软硬件两方面简述其设计原理。     

Distributed architecture for energy management D-structure

Electric power systems are expanding in size and complexity, and the requirement for the energy management system (EMS) is becoming more important. In this computer control system, a single control computer is used mainly as the primary computer and its software is very complicated because of its hugh number of small, quick tasks to obtain high response speed. Therefore, much effort is needed to develop and modify the programs, and the responsiveness of this centralized architecture varies greatly when many faults occur in the power system. This paper describes a new distributed architecture for the EMS. Distributed processors execute the functions cooperatively with periodic access to the common bulletin board database in which information about the power system exist. This architecture facilitates the software development and maintenance, and it also enhances the performance by the parallel processing of the distributed functions.     

陶瓷材料的冷加工与热处理

综述评述最近发展起来的陶瓷材料的烧结后冷加工热处理法“控制破碎成形加工法”，着重介绍该方法的由业，阐明其理论与实验基础，同时，介绍其应用并讨论其发展前景。     

Analysis of a homologous series of non-reducing oligosaccharides from Arnica montana L. Roots

The oligosaccharide component compositions of a series of non-reducing oligosaccharides extracted from the roots of Arnica montana L. has been determined by gel permeation chromatography (g.p.c.). The range of oligosaccharides present was found to extend beyond the octasaccharide previously reported. with 16% to 19% of the oligosaccharides having a degree of polymerisation of between 11 and 19 and almost 3% having a degree of polymerisation greater than 20. The chromatographic behaviour of this series of oligosaccharides is compared with that observed for series of D-gluco-oligosaccharides.     

Drying of Chestnuts (Castanea sativa Mill.) after Osmotic Dehydration with Sucrose and Glucose Solutions

Chestnuts were dehydrated by using a combined method of osmotic dehydration followed by air drying. Samples were osmotically pretreated with sucrose (60% w/w) and glucose (56% w/w) for 8 h, air-dried at temperatures of 45, 55, and 65°C, at a relative humidity of 30% and at a velocity of 2.7 m·s^-1 and the experimental data of the drying kinetics were obtained. Whole samples were dried with different peelings: (a) removal of endocarp and pericarp (peeled) and (b) additionally the internal rough surface (cut). In all cases, cut chestnuts show greater drying rates than peeled samples, indicating that a significant mass transfer resistance in the layer nearest to the surface takes place. Peeled samples pretreated with sucrose solutions behave in a similar way to untreated samples. For the rest of the samples, the cut samples osmotically treated with sucrose solutions and all the samples treated with the glucose solution, the drying rates decrease during drying. Drying kinetics are successfully modeled by employing a diffusional model that takes the shrinkage into account. The effective coefficient of water diffusion was evaluated and correlated with temperature. The quality of the final product was monitored by color change. In spite of the fact that the total color difference is not modified by the osmotic treatment, the L*, a*, and b* color coordinates of cut samples treated with sucrose and glucose solutions do undergo changes; the L* and a* coordinates change less than the b*.     

Single-sided ventilation — Part II. further considerations

This paper extends an earlier report of measurements and computer predictions of flows in a cubical cavity exposed on one side to the scavenging effect of an external stream. Further measurements and photographs are presented; they are consistent with each other and with the predictions of the computational model. Specifically, comparisons are made between measured and predicted mean velocities and turbulent shear stresses, and photographs are used to elucidate features of the shear layers generated by accelerating and decelerating external flows. The computer model is used to deduce approximate relations between internal turbulent activity (measured by mean velocity, turbulence energy and shear stress) and external velocity, percentage ‘window’ opening and relative position of the plane walls upstream and downstream of the cavity.     

BINELOCA 程序与广东岭澳核电站大破口失水事故分析

ＢＩＮＥＬＯＣＡ程序是在吸收国外先进大破口失水事故分析计算机程序的基础上，针对我国现有大破口失水事故分析程序的不足和工程应用方面的问题，采用了一些成熟的、新型的和当今国际公认的瞬态热工水力数学物理模型以及水和蒸汽性质参数计算公式改编而成的大破口失水事故分析程序。通过对广东岭澳核电站大破口失水事故的计算表明，ＢＩＮＥＬＯＣＡ程序计算的结果与法国计算的结果是一致的。