裂齿矩形翅片板翅式换热器优化设计的分析

对裂齿矩形翅片板翅式换热器中的裂齿矩形翅片的传热效率作了分析,并以单位质量材耗的换热能力最大为目标函数,分析研究了在不同雷诺数(Re)的操作条件下裂齿矩形翅片间角度、翅片厚、长度、宽度及极厚之间的关系。结果表明:在气体换热的场合下,当Re在某一范围时翅片可有效地起到强化传热的作用。当板厚为5mm,翅片厚为3mm,翅片间夹角为45°～70°,Re为2×10~3～8×10~3,最佳翅片纵向间距与翅片长度和翅片厚度乘积的平方根的比为1.5～2.5,最佳翅片尺寸系数为3～5时,传热强化效果较好。     

Research on Marine Boiler＇s Pressurized Combustion and Heat Transfer

The effect of pressure on combustion and heat transfer is analyzed. The research is based on the basic combustion and heat transfer theorem. A correction for the heat calculation method for pressurized furnace is made on the basis of the normal pressure case. The correction takes the effect of pressurizing into account. The results show that the correction is reasonable and the method is applicable to combustion and heat transfer of the marine supercharged boiler.     

长距离温泉输水管道设计

福州市首次把城市外围的温泉水引入市区,本文简要介绍长距离温泉输水管道设计中一些做法。     

镍氢电池负极用低成本储氢合金的研究

研究了ABS型储氢合金在低Co含量条件下，随B组元替代元素Co，Al，Si等含量的变化对合金电化学性能的影响规律，同时研究了A组元中不同La／Ce比对合金电化学性能的影响情况。结果表明，随合金中Co含量的降低，合金的活化性能和放电容量得以改善，但合金的循环寿命下降也比较明显；在试验范围内，随Al元素的加入，合金的循环寿命得以改善，但材料的放电容量和活化性能均有所下降；随合金La／Ce比的降低，合金的放电容量略有下降，但其循环寿命和放电电压平台有较大提高。     

RMT1-250转换开关用电接触材料

铜铬锆合金是一种形变热处理材料，兼具了铜铬合金和铜锆合金的各种优良性能，经过时效处理的铜铬锆合金，与铜相比，高温强度有很大的改善，而且具有较高的导电率。所以铜铬锆合金广泛应用于电焊机、低压电器等行业。根据对铜铬锆成分的适当调整，可用作为电焊机电极，低压电器触桥、短路环等各种电接触材料。铜铬锆合金用于RMT1－250转换开关，接近于触桥材料的应用，但使用的条件更苛刻一些，要承受部分电弧的侵蚀和由此产生的高温，因此对材料要求具有良好的导电导热性和更高的高温强度。     

偏高岭土的研究现状及展望

简要介绍了偏高岭土的反应机理和在国内外的研究现状。同时对偏高岭土的研究进行了展望 ,提出因麦特林水泥原料丰富 ,污染小 ,加工简单 ,性能优越 ,其应用前景广阔 ,应对其加强研究。     

Hardware system of the Earth Simulator

The Earth Simulator (ES), developed under the Japanese government’s initiative “Earth Simulator project”, is a highly parallel vector supercomputer system. In this paper, an overview of ES, its architectural features, hardware technology and the result of performance evaluation are described.

In May 2002, the ES was acknowledged to be the most powerful computer in the world: 35.86 teraflop/s for the LINPACK HPC benchmark and 26.58 teraflop/s for an atmospheric general circulation code (AFES). Such a remarkable performance may be attributed to the following three architectural features; vector processor, shared-memory and high-bandwidth non-blocking interconnection crossbar network.

The ES consists of 640 processor nodes (PN) and an interconnection network (IN), which are housed in 320 PN cabinets and 65 IN cabinets. The ES is installed in a specially designed building, 65 m long, 50 m wide and 17 m high. In order to accomplish this advanced system, many kinds of hardware technologies have been developed, such as a high-density and high-frequency LSI, a high-frequency signal transmission, a high-density packaging, and a high-efficiency cooling and power supply system with low noise so as to reduce whole volume of the ES and total power consumption.

For highly parallel processing, a special synchronization means connecting all nodes, Global Barrier Counter (GBC), has been introduced.     

Critical heat flux on a flat plate heater located at the middle of a duct in forced flow of pressurized He II

Critical heat fluxes (CHFs) were measured for two types of rectangular ducts containing horizontal flat plate heaters. One has the flat plate heater of 6 mm wide and 20 mm long located on the inner lower wall at 50 mm from the inlet. The other duct has two horizontal flat plates of 6 mm wide and 20 mm long on inner upper and lower walls at 50 mm from the inlet. The equation of CHF for the forced convection containing a new nondimensional-parameter m introduced in order to calculate cross-sectionally averaged liquid temperature at the center of the duct was derived based on two fluid model, ordinary convection theorem and experimental results. It was confirmed that this correlation can describe not only the author's data on the duct but also other worker's data for channels with different shapes and sizes.     

The Difference in Turbulent Diffusion between the Active and Passive Scalars in a Thermally Stably Stratified Medium

The difference in the turbulent diffusion between the active (heat) and passive (mass) scalars in a thermally stably stratified medium is investigated. The axisymmetric problem is treated on the formation of a turbulent circulation flow above a heated disk and on the turbulent diffusion of a passive scalar (impurity) from a continuous surface source in a stably stratified medium. The results indicate that the thermal stratification causes appreciable differences in the coefficients of turbulent transfer between the active (heat) and passive (mass) scalars. This means that the assumption of the identity of the coefficient of turbulent diffusion of heat and mass, employed in conventional models of turbulence, produces significant errors in estimating the heat and mass transfer in a thermally stably stratified medium.     

Evaluating dynamic performance: The influence of salient Gestalt characteristics on performance ratings.

It is well recognized that performance changes over time. However, the effect of these changes on overall assessments of performance is largely unknown. In a laboratory experiment, we examined the influence of salient Gestalt characteristics of a dynamic performance profile on supervisory ratings. We manipulated performance trend (flat, linear-improving, linear-deteriorating, U-shaped, and ∩-shaped), performance variation (small, large), and performance mean (negative, zero, positive) within subjects and display format (graphic, tabular) between subjects. Participants received and evaluated information about the weekly performance of different employees over a simulated 26-week period. Results showed strong main effects on performance ratings of both performance mean and performance trend, as well as interactions with display format. Theoretical and practical implications of the results are discussed. (PsycINFO Database Record (c) 2010 APA, all rights reserved)