硼酸镁晶须的合成研究

报道了硼酸镁晶须的合成研究结果。硼酸镁晶须是一种性能价格比高的晶须产品，利用熔盐法合成出长10—50μm、直径0．5—2μm的硼酸镁晶须。还就硼酸镁晶须增强复合材料的研究和硼酸镁晶须工业化的前景作了展望。     

Electrochemical studies of pyrite oxidation and reduction using freshly-fractured electrodes and rotating ring-disc electrodes

Oxidation and reduction processes on coal- and mineral-pyrite surfaces have been investigated to better understand the reactions that control the hydrophobicity and flotation behavior of pyrite. The incipient oxidation and reduction reactions were studied using fresh surfaces of pyrite that were created by in situ fracturing electrodes potentiostated at a predetermined potential. Chronoamperometry immediately after fracture and subsequent cyclic voltammetry have established that fresh fracture surfaces of pyrite instantaneously assume a unique potential (referred to as the “stable” potential) at which neither oxidation nor reduction takes place. For Peruvian and Chinese pyrites, the stable potential is −0.28 V (standard hydrogen electrode, SHE) at pH 9.2 and 0 V at pH 4.6. The initial oxidation of pyrite begins at potentials slightly positive of the stable potential and is believed to produce a hydrophobic sulfur-rich species, most likely a polysulfide or metal-deficient sulfide. A rotating ring-disc electrode (RRDE) was employed to study the kinetics and mechanisms of surface reactions on pyrite over moderate potential ranges. Two distinct soluble reduction products (ferrous hydroxide and HS⁻) and one distinct soluble oxidation product (ferrous hydroxide) were observed on pyrite in alkaline solutions. It is concluded that the initial oxidation of pyrite and the oxidation of ferrous to ferric hydroxide occur in a similar potential range. When the electrode is oxidized, e.g. by polishing, prior to experiments, the initial oxidation of pyrite is masked by the oxidation of ferrous hydroxide, making it difficult to study the oxidation of pyrite itself.     

新型无机抗菌剂碱式次氯酸镁的研制与应用

本文研究了国内尚属空白的碱式次氯酸镁（BMH）的制备方法，并对BMH的理化性质和杀菌效果进行了初步研究。     

磷矿中氧化钙,氧化镁测定方法的研究

用硝酸铋分离磷酸根离子，在滤液中用ＥＧＴＡ－ＥＤＴＡ分别测定氧化钙，氧化镁较之传统方法简便效果好。     

纳米级氢氧化镍制备及电化学性能研究

介绍了一种通过合成草酸镍,进而生成β型纳米氢氧化镍的新的合成路线,从而达到大幅度提高镍氢电池正极放电容量的目的。使用X射线衍射（XRD）分析产品的晶型结构。从产品谱图中可以得知：由于特征衍射峰的出现可以判定该产品为β型,且由于（001）峰的宽化可以初步判定其为纳米级。通过透射电镜（TEM）可以看出产品粒径和形貌的具体特征,即产品为针状,长度为100～200 nm,直径为10～20 nm。将纳米级氢氧化镍制成电极,经过充放电测试可以发现电容量约为400 mA.h/g,远远高于球形微米级氢氧化镍的放电容量。     

提高镁回收率的途径及效益分析：白云石碳酸化法生产轻质碳酸镁新工艺研究

本文提出了白云石碳酸化法生产轻质碳酸镁，二次碳酸化法新工艺的理论依据、实验结果及技术经济分析。     

表面原位化学组合改性Al（OH）3／PVC复合材料的制备与性能

基于Al(OH)_3粉体与PVC基体的界面设计和调控,采用表面原位化学组合改性方法,在Al(OH)_3表面依次化学键合烷基酚醛树脂、丁腈橡胶等几种大分子改性剂,形成极性逐渐过渡的梯度界面层。当改性Al(OH)_3在PVC复合材料中的用量为80份时,材料的缺口冲击强度达到最大值,分别为添加等量偶联剂改性Al(OH)_3、未改性Al (OH)_3复合材料的2．5和2．7倍,是基体树脂的1．5倍,获得了具有高阻燃消烟性能,同时改善了力学和加工性能的综合性能良好的高填充复合材料。通过扫描电镜分析表明,Al(OH)_3粒子经过表面原位化学组合方法处理,在PVC中分散均匀,与塑料基体结合良好,并形成了以Al(OH)_3粒子为核、以多层大分子改性剂为壳的软壳硬核结构。     

Selective conversion of propane to propene by the catalytic oxidative dehydrogenation over cobalt and magnesium molybdates

Catalytic performances of various metal molybdates were tested in the oxidative dehydrogenation of propane to propene with molecular oxygen under an atmospheric pressure. Most of the molybdates tested promoted the selective oxidative conversion of propane to propene and among them cobalt and magnesium molybdates were found highest in the activity and selectivity. It was also found that their catalytic activities were highly sensitive to the catalyst composition, and it turned out that Co_0.95MoO _x and Mg_0.95MoO _x catalysts which have slightly excess molybdenum showed the highest activity in the oxidative dehydrogenation of propane. Under the optimized reaction conditions, higher reaction temperatures and lower partial pressures of oxygen, these catalysts gave 60% selectivity to propene at 20% conversion of propane. Since the molybdates having the surface enriched with molybdenum oxide tended to show high activity for the propane oxidation, surface molybdenum oxide clusters supported on metal molybdate matrix seem to be the active sites for the selective oxidative dehydrogenation of propane.     

铝系阻燃剂阻燃PP的力学性能研究

将用偶联剂处理的碱式碳酸铝镁加入到聚丙烯中，通过对体系阻燃性、力学性能等研究得出：碱式碳酸铝镁能够对聚丙烯起到良好的阻燃效果，碱式碳酸铝镁的加入提高了聚丙烯的冲击强度，当碱式碳酸铝镁质量分数为23％时，体系的冲击强度最高。研究了偶联荆的用量对体系力学性能的影响，结果表明，随偶联荆用量的增加，体系的拉伸强度降低，冲击强度先升高后降低，当偶联荆质量分数为1．0％时，体系的冲击强度最高。     

马来酸酐接枝聚乙烯对无卤阻燃PE-HD护套料的改性研究

研究了马来酸酐接枝聚乙烯对无卤抑烟阻燃PE-HD护套料的改性效果，并进行了增韧机理上的探讨。采用扫描电镜对复合材料进行了断面观察，并测试了材料的力学性能、流变性能、耐热性能和氧指数。结果表明，马来酸酐接枝聚乙烯能够极大地提高复合材料的界面相容性，增强材料的界面相互作用，提高阻燃剂微粒在树脂基体中的分散效果，同时形成了一个可塑性界面层，所以能够提高材料的韧性。