Silver Electrodeposition from Photographic Processing Solutions

This paper describes the parameters that are important in the industrial practice of silver removal from photographic fixers. The experiments were performed under potentiostatic control using synthetic solutions. The current efficiency was analysed as a function of the cathodic potential taking into account the deposit quality. A cathodic potential of ?0.5 V against a saturated calomel electrode is recommended. The conditions to prevent the darkening of the electrodeposit were investigated. The determination of silver concentration in the solution was made by direct potentiometry. The results obtained with synthetic fixers were corroborated by making the silver deposition from commercial fixers in an electrochemical reactor with rotating cylinder electrode intercalated in an electrolytic flow circuit in order to simulate practical conditions.     

Spontaneous emulsification aspect of enhanced oil recovery

Recent studies have suggested the possibility of spontaneous emulsification as a mechanism for enhanced oil recovery (EOR). The discussions have, however, remained essentially qualitative. A study was therefore undertaken to estimate quantitatively the contribution of spontaneous emulsification as an EOR mechanism. The tests were conducted on several bulk liquid/liquid systems as well as by displacement experiments in unconsolidated synthetic sand packs. Spontaneous emulsification was found to be a mechanism for EOR: the estimated extra contribution to EOR due to this mechanism was found to be significant in laboratory scale displacement experiments. Tertiary recovery was always greater when spontaneous emulsification was evident than otherwise. Results of tests on bulk liquid/liquid systems indicate that the occurrence or absence of spontaneous emulsification can be correlated with the values of ‘partition parameter’. It may be concluded that higher oil recoveries may be achieved in chemical EOR processes where interface mass transfer (and the accompanying spontaneous emulsification) occurs. The evaluation of efficiency of residual oil mobilisation through the capillary number theory (with and without spontaneous emulsification) is also discussed. Displacement tests with spontaneously emulsifying systems showed that residual oil left behind a conventional waterflood was mobilised in a range of capillary numbers much less than that which applies to low-tension waterfloods.     

Studies on chitin 3—effect of coagulants and annealing on the preparation and the properties of chitin membrane

Chitin membrane was prepared by casting a N,N-dimethyl acetamide, N-methyl 2-pyrrolidone and lithium chloride (DMA-NMP-LiCl)solution of chitin and coagulating with several media. The effect of the coagulants on membrane formation was studied. 2-Propanol was found to be more favourable than methanol, ethanol, acetone and mixtures of 2-propanol and water. The membrane obtained in 2-propanol was subjected to annealing. Annealing made the membrane dense and strong. The tensile strength of the membrane annealed at 145°C for 2hr was about twice that of an unannealed membrane. The solute permeability of the annealed membranes was lower than that of the original one. These phenomena could be clearly interpreted in terms of crystallinity.     

确定异常高压气藏地质储量和可采储量的新方法

基于文献[1]的定容，封闭，异常高压气藏的物质平衡方程式，提出了确定异常高压气藏原始地质储量，可采储量和采收率的新方法，通过实例的应用和对比表明，提供的新方法是适用的有效的。     

Evaluation of influence of external magnetic disturbance on superconducting magnet taking conservation of linkage flux into account

External magnetic disturbance influences the quality of the image obtained with a magnetic resonance imaging (MRI) system because it causes magnetic resonance frequency drift. When a superconducting magnet in persistent current mode operation is exposed to external magnetic disturbance coil current varies to keep linkage flux constant. Conventional analysis is usually formulated with constant current and does not provide correct evaluation of drift of magnetic field in the magnet. This paper proposes a method of numerical analysis of magnetic field considering conservation of linkage flux in a superconducting magnet under a persistent current mode operation. This method is applied to evaluate drift of the magnetic field in a superconducting magnet for magnetic resonance imaging due to external magnetic disturbance. Analysis results show good agreement with the experimental results.     

TRVs and fault clearing stresses in extra-high-voltage radial networks

To cope with the high rate of increase of power demand in the main industrialized districts in Japan, 550-kV transmission systems covering the districts have been reinforced, with most of the main power plants connected directly to these systems. Through 550-/300-kV substations, the majority of power to the districts is supplied by 300-kV systems. To limit the excess short-circuit capacity in the 300-kV systems, they tend to be reconstructed as so-called radial networks. In radial networks with high short-circuit capacity and relatively small number of transmission lines connected to the substation busbars, the rate of rise of TRV can be far higher than standard value. This paper analyzes the transient recovery voltages (TRV) in such extra-high-voltage radial networks in Japan, together with the relevant stresses to circuit-breakers during fault clearings. Future system conditions have also been introduced. As the typical rate of rise of the TRV values, more than twice that of today's standard ones are probable.     

Extraction of penicillin G from simulated media by an emulsion liquid membrane process

The extraction of penicillin G from simulated media was performed by water/oil/water (w/o/w) emulsion liquid membranes (ELMs) and studied under various operational conditions in a batch system. The degree of extraction achieved was between 80% and 95% under specific conditions. A concentration of greater than nine times the initial concentration of penicillin G in the external phase was obtained in the internal phase. The pH of the internal aqueous solution, containing a basic salt, was theoretically calculated on the basis of the amount of penicillin G transported into the internal phase. The calculated results agreed with the experimental data well and were used to select a suitable type and concentration of a basic salt in the internal phase to give a pH within the range 5 to 8 where penicillin G was stable after the termination of extraction. The extraction of penicillin G was successfully performed by the ELM process with sodium carbonate in the internal phase.     

Biosorption of heavy metals by Saccharomyces cerevisiae: Effects of nutrient conditions

Studies took place to investigate the effects of different nutrient conditions on the biosorption ability and selectivity of heavy metals by Saccharomyces cerevisiae. After having grown in media supplemented with additional glucose, ammonium, phosphate or cysteine, the yeast was exposed to an equimolar solution of lead, cadmium, zinc and copper. Lead removal from a mixed solution was significantly higher than that of copper, followed by zinc and cadmium. Generally, yeasts from cysteine-rich media showed greatest sorption capacity whereas phosphate addition influenced zinc selectivity. In addition, glucose, fructose and sucrose as carbon sources were examined. Cultures grown in glucose had a better uptake than those cultivated with fructose at an incubation time of 30 min.     

Effects of growth with ethanol on fermentation and membrane fluidity of Saccharomyces cerevisiae

Saccharomyces cerevisiae HSc was grown with ethanol at concentrations up to 10% (v/v). The immediate effects of additions of externally added ethanol on CO₂ production and O₂ consumption of washed organisms were studied by stopped-flow membrane inlet quadrupole mass spectrometry. Fermentative activities of organisms grown with ethanol (0–5% v/v) showed similar sensitivities to inhibition by ethanol, whereas those grown with 10% (v/v) ethanol had become protected and were markedly less sensitive. The fluidity of subcellular membrane fractions was measured by determination of the temperature dependence of the rotational order parameter of the spin label 5-doxyl stearic acid (free radical) by electron spin resonance. Mitochondria prepared from yeasts grown with 0, 7 and 9% (v/v) ethanol showed similar overall fluidity, although differences in temperature-dependent behaviour indicate altered lipid composition or lateral phase separations. On the other hand the microsomal fraction from organisms grown with 9% ethanol showed a remarkable increase in fluidity. These data suggest that the protective effects of growth with ethanol near the limit of tolerance on fermentative activities may arise from altered plasma membrane fluidity properties.     

Trifluoromethanesulphonic acid catalysed transalkylation between tetrabromobisphenol-a and toluene for the production of 2,6-dibromophenol

The preparation of 2,6-dibromophenol is described. This compound, useful as raw material for brominated poly(phenyleneoxide) and pyrogallol or derived pharmaceuticals/pesticides, was prepared in 80% (isolated) yield by a transalkylation reaction between tetrabromobisphenol-A and toluene. The catalyst, trifluoromethanesulphonic acid, can be simply recovered and recycled. Perfluorinated resin sulphonic acid (NAFION-H®, DuPont) did not effectively catalyse this transalkylation.