宽带线性调频信号产主技术研究

本文介绍了采用数字基带产生结合倍频链扩展带宽的方法设计与实现了大带宽线性调频信号产生系统。详细分析研究了实现系统的三项关键技术，给出并分析了相应环节的输出信号。对系统进行了预失真补偿处理，成功实现了ＶＨＦ／ＵＨＦ波段、带宽达３００ＭＨｚ线性调频信号的产生。经脉冲压缩处理，主瓣旁瓣比（ＰＳ１Ｒ）在－３７ｄＢ以下。     

A novel compact circuit for 4-PAM energy-efficient high speed interconnect data transmission and reception

Transmission of signals, whether on-chip or off-chip, places severe constraints on timing and extracts a large price in energy. New silicon device technologies, such as back-plane CMOS, provide a programmable and adaptable threshold voltage as an additional tool that can be used for low power design. We show that one particularly desirable use of this freedom is energy-efficient high-speed transmission across long interconnects using multi-valued encoding. Our multi-valued CMOS circuits take advantage of the threshold voltage control of the transistors, by using the signal-voltage-to-threshold-voltage span, in order to make area-efficient implementations of 4-PAM (pulse amplitude modulation) transceivers operating at high speed. In a comparison of a variety of published technologies, for signal transmission with interconnects of 10-15 mm length, we show up to 50% improvement in energy for on-chip signal transmission over binary encoding together with higher limits for operating speeds without a penalty in circuit noise margin.     

Extending boosting for large scale spoken language understanding

We propose three methods for extending the Boosting family of classifiers motivated by the real-life problems we have encountered. First, we propose a semisupervised learning method for exploiting the unlabeled data in Boosting. We then present a novel classification model adaptation method. The goal of adaptation is optimizing an existing model for a new target application, which is similar to the previous one but may have different classes or class distributions. Finally, we present an efficient and effective cost-sensitive classification method that extends Boosting to allow for weighted classes. We evaluated these methods for call classification in the AT&;T VoiceTone^® spoken language understanding system. Our results indicate that it is possible to obtain the same classification performance by using 30% less labeled data when the unlabeled data is utilized through semisupervised learning. Using model adaptation we can achieve the same classification accuracy using less than half of the labeled data from the new application. Finally, we present significant improvements in the “important” (i.e., higher weighted) classes without a significant loss in overall performance using the proposed cost-sensitive classification method.     

Finite sample properties of estimators of spatial autoregressive models with autoregressive disturbances

The article investigates the finite sample properties of estimators for spatial autoregressive models where the disturbance terms may follow a spatial autoregressive process. In particular we investigate the finite sample behavior of the feasible generalized spatial two-stage least squares (FGS2SLS) estimator introduced by Kelejian and Prucha (1998), the maximum likelihood (ML) estimator, as well as that of several other estimators. We find that the FGS2SLS estimator is virtually as efficient as the ML estimator. This is important because the ML estimator is computationally burdensome, and may even be forbidding in large samples, while the FGS2SLS estimator remains computationally feasible in large samples. Received: 20 January 2001 / Accepted: 31 August 2001     

Characteristics of origin-destination pair traffic in Funet

In this paper we analyze measurements gathered from a 2.5~Gbps link in the Finnish university network (Funet) in 2004. The traffic is broken down into origin-destination (OD) pair components based on source and destination IP address. We study the traffic characteristics of these components, and identify four typical representative OD pairs. For these pairs we investigate the validity of a moving IID Gaussian model. We find that the statistical properties of these OD pairs differ significantly from each other, with only some of them close to Gaussian. The OD pairs are also found to have some cross-correlation between each other, contradicting an often made assumption about OD pair independence. Furthermore, the existence of a mean-variance relation between the OD pairs is studied. We find that there is a relation between mean and variance, but for some periods of time it is rather weak.     

TFM调制及其改进技术的研究

通过对TFM调制技术的研究,修正了其中预调制滤波器冲击响应波形g(f)在时间轴上的位置及其频谱G(w)的表达式.然后将TFM基带信号进行近似,即对TFM的相位路径进行进一步的控制,得到一个改进的TFM调制技术.改进后的TFM调制技术和原TFM调制技术相比,频带压缩能力提高了一倍,误码性能不变,但会出现3 dB的寄生调幅,需要提高发射机的发射功率.     

信道粒度可变的分块自适应OFDM传输系统

满足不同服务质量(QoS)业务是Beyond 3G系统必须考虑的一个问题。本文提出一种可变信道粒度的分块自适应OFDM系统。系统能够根据不同用户多样化的速率需求，自适应地改变分块的大小，并且在每个分块上进行自适应调制，在满足用户速率要求的基础上降低了对子载波分配信息(SAI)和自适应调制信息(AMI)的需求。仿真结果表明，本文提出的系统在系统容量和频谱效率上比固定分块自适应OFDM系统有更好的性能。     

基于聚类算法实现信号盲分类

本文解决了信号处理、工业控制等领域存在的非平稳信号盲分类问题。在聚类中广泛应用的K-Means算法及其它基于中心的聚类算法有两个共同的缺陷-需要预先确定类数目且随机初始化中心引起性能不稳定。本文提出的算法较好地解决了这两个问题，提高了算法稳定性，实现了非平稳信号盲分类。提取非平稳信号的小波系数作为聚类的样本空间，分析聚类结果的统计偏差以估计类的数目，采用调和均值准则进行分类。最后给出的仿真结果表明本文提出的方法较传统的K-Means算法明显降低分类错误率。     

Full Complex Amplitude Digital Holograms： Design, Fabrication and Optical Characterization

Diffractive optical elements have a large number of industrial applications, such as beam shaping and optical filtering. Traditionally, these elements modulate the phase of the incoming light or its amplitude, but not both. To overcome this limitation, full complex-amplitude modulation diffractive optical elements were developed. Well-established integrated circuit fabrication steps were employed to fabricate the devices with high precision. Using this approach, the new element‘s optical performances are improved also for near field operations. With this device it is possible to obtain 100% efficient spatial filtering and low noise reconstructed images.     

裂缝性油气藏采收率：100个裂缝性油气田实例的经验总结

通过对世界上100个裂缝性油气藏的综合评价，研究储集层及流体本身的性质(包括孔隙度、渗透率、黏度、可动油比例、含水饱和度、润湿性及裂缝分布特征等)和驱动机制及油藏管理战略(优化日产量和采用不同类型的提高采收率技术)对其最终采收率的影响。将裂缝性油气藏分为4类：I类的基质几乎没有孔隙度和渗透率，裂缝是储存空间和流体流动的通道；Ⅱ类的基质有较低的孔隙度和渗透率，基质提供储存空间，裂缝提供流动通道；Ⅲ类(微孔隙)的基质具有高孔隙度和低渗透率，基质提供储存空间，裂缝提供流动通道；Ⅳ类(大孔隙)的基质具有高的孔隙度和渗透率，基质提供储存空间和流动通道，裂缝仅增加渗透率。对26个Ⅱ类油气藏和20个Ⅲ类油气藏的开采历史的研究表明：Ⅱ类油气藏的采收率受水驱强度和最优日产量控制，日产量过高会很容易破坏Ⅱ类油气藏，一些Ⅱ类油气藏如果管理得当，采收率可以很高，不需要二次或三次采油；Ⅲ类油气藏的采收率主要受岩石和流体本身性质的影响，特别是基质渗透率、流体重度、润湿性以及裂缝强度等，不进行二次或三次采油不可能完全开采，往往需要采用一些提高采收率的专门技术。以往将Ⅱ类和Ⅲ类裂缝性油气藏归为一类，认识它们的区别将有助于选择更好的开发策略。