A Finite Element Computational Method for Gas Hydrate. Part I: Theory

A finite element scheme is presented to model the dissociation of gas hydrates in porous media by hot water injection. We show a complete derivation of the finite element formulation, including the associated mass and energy conservation equations capable of performing transient analysis of both conductive and convective heat transfer for gas and liquid flow in porous media. The scheme also includes the latent heat effect to accommodate the change of phase due to melting of hydrate. In the companion paper, Part II, this method is successfully applied to hydrate reservoirs.     

Mixing Center of a Channel

For longitudinally uniform stretches of waterways there is a mixing center for the across-channel location of a steady point source in steady flow, such that complete mixing is achieved as soon as possible and there is no concentration overshoot at either of the two shorelines. A mathematical definition of the mixing center is the zero of the first oscillatory cross-channel diffusion mode. With the shorelines plus four interior data points across the channel, the starting estimate for the mixing center suffices to keep peak shoreline concentrations to within 6% of optimal. For comparison, a source at mid flow gives 18% shoreline concentration overshoot in the test case. Should very high precision be required, the Appendix gives an iterative construction that converges to the first oscillatory diffusion mode.     

地下水运动数值模拟过程中边界条件问题探讨

本文对地下水运动数值模拟过程中边界条件的涵义 和处理方法进行了分析和讨论。阐述了边界条件所包含的双重意义。指出随着人类活动影响 强度的日益增大，边界条件的处理要面临一些新的更为复杂的问题。在模型预报之前必须首 先对边界条件做出预报。边界条件的预报既要考虑自然因素的作用，同时也要考虑人类活动 (人工开采和人工补给)的影响及由于邻区水流条件变化而产生的耦合效应。之后，给出了两 个应用实例。     

An investigation of the unstable region for dense phase conveying in sliding bed flow

For fine powdered materials, capable of being conveyed in dense phase, a conveying region exists in which instability in flow and pipeline blockage can occur if the pressure gradient available is insufficient to maintain a minimum value of solids loading ratio. A reduction in material flow rate can also lead to pipeline blockage in this region. Conveying trials under-taken with cement are used to illustrate the nature of the problem.     

双层堤基的井涌破坏与无害管涌

双层堤基水文地质结构特殊，堤基承压水常具独特的“渗而不流”特征。在“不流”条件下，堤后盖层薄弱处受超高承压水头顶裂破坏，产生的局部冒水孔实属承压自流井，由此形成的管涌实质为井涌。底部进水的承压井流影响范围不大，井涌的破坏范围更小，据此可区分出有害管涌与无害管涌。前者局限于堤脚附近，小范围压渗为首选方案；对后者，既无需专门防治，更不必追求根治。     

安塞低渗油田孔隙结构对渗流特征曲线的影响

渗流曲线的测定是认识油藏流体渗流规律的基础。实验发现安塞油田储集层岩心渗流曲线在低有效净围压下近似表现为两段直线，通过压汞实验和毛管压力曲线数据分析，认为这种特征与储集层孔隙结构有关。在分析渗流特征时应综合考虑孔隙结核特征、流体与孔隙介质的相互作用等因素。     

青海省桥头电厂河子沟灰场拦洪坝粘滞流模型试验分析

本文采用粘滞流模型试验对青海桥头电厂河子沟灰场拦洪坝设计方案进行了论证，分析了多种防渗条件下的渗流场特点，提出了满足工程运作的既经济又合理的建议。     

FLOW OF NEWTONIAN FLUIDS THROUGH SINUSOID ALLY CONSTRICTED TUBES. NUMERICAL AND EXPERIMENTAL RESULTS

Numerical and experimental predictions of pressure drops in the flow of Newtonian fluids through sinusoidally constricted tubes (SCT) are carried out. The numerical evaluations analyzed in this work are obtained from the following methods: Geometric Iteration (GJM), Geometric Iteration with First and Second Upwinds (GIM1, GIM2), Successive Over Relaxation by Line (SORBLM), Global Galerkin Spectral Method (GGSM), Collocation (CM) and Dufort-Frankel (DFM). The GIM1, GIM2 and SORBLM are applied to SCT and explained in this work. The other methods have been previously reported in the literature with the same purpose. Experiments are accomplished for constrictions of approximately 40,60 and 80% of the average tube diameter and results compare well with numerical predictions of the steady flow. It is concluded that special attention should be given to evaluations of the friction factor ƒ for Reynolds numbers Re between the onsets of flow separation and turbulence due to flow instability. Finally, the SCT as a model for porous media (PM) is discussed.     

调节阀流量特性控制分析

介绍了调节阀的流量基本知识，从控制理论的角度，分析了调节阀的理想流量特性、工作流量特性和系统稳定性，指出了在热工领域内应用调节阀时的一些注意事项。