包钢氟污染治理成效及对策

本文介绍了包钢历年来氟污染治理成效以及控制外排氟总量达标的具体措施.     

在役加氢反应器试验板脆化和氢损伤的测定与研究

充分利用了带主焊缝的役后试板，在国内首次开展回火脆化、氢介质下断裂韧性与疲劳扩展的研究，结果表明，加氢反应器焊缝有明显的脆化表现。同时，核查了反应器开停车升温速度和降温速度规定，以及确定了裂纹允许尺寸的参考数据，为今后安全运行提供了充分的依据。     

Φ76mm自动轧管机组穿孔机顶杆小车的改进

通过校核Φ７６ｍｍ自动轧管机组穿孔机顶杆小车的轴承寿命，提出了顶杆小车的改进措施，如重新选配合适的轴承型号，修改有关装配尺寸等。改进后，顶杆小车的使用效果良好。     

强度型光纤传感器的信号检测系统

本文阐述了一种可提高强度型光纤传感器测量精度的检测系统。该系统利用同一检测电路交替检测信号、参考通道的输出信号，并将信号、参考两通道的检测结果相除，从而消除了因发光二极管光源波动及检测电路系统不稳定所带来的误差。采用同步相关技术抑制了噪声，提高了输出信噪比。实验证明，当时间常数ＲＣ为０．０５Ｓ时，采用该检测系统可获得优于千分之一的零点稳定性和优于２×１０３的输出信噪比。     

Influence of two-step process and of different stoichiometric ratios on morphologies generated in castor oil epoxy resins

Phase separation during polymerization was studied in a model system consisting of a diepoxide based on diglycidyl ether of bisphenol A (DGEBA), variable amounts of ethylenediamine (EDA) and the mass of castor oil (CO) necessary to obtain a mass fraction equal to 0-15 in a final system where the stoichiometric ratio of amine to epoxy equivalents, r, was equal to 1. A two-step polymerization process was performed by curing first a system with r = 0-5, during variable times before phase separation, and then carrying the system to r = 1. Thermodynamic analysis of samples with different r values led to a linear relationship between the Flory-Huggins interaction parameter and r. The concentration (P) and average size (D?) of dispersed-phase particles followed opposite trends, i.e. P increased while D? decreased, when either r was increased or the time of curing in the first step of a two-step process was decreased. This was explained by assuming that the competition between nucleation and growth was determined by the viscosity at the cloud point, η_cp. Low values of η_cp favoured growth over nucleation and led to fewer but larger particles.     

挟沙水流中沙粒对底壁湍流猝发的影响

本文在常规的边界层方程中保留了法向压力梯度项和增加了固粒对流体的使用项，结合Ｂａｔｃｈｅｏｌｒ对交界面提供的分析方法和小扰动稳定性理论，由理论分析和计算得到了包括沙粒之类的悬浮体的尺寸，比重，流动Ｒｅ数，两相速度差以及扰动波数与水流底壁湍流猝发角的关系，计算结果与Ｒａｓｈｉｄｉ等的实验结果相符。文中所得结果有助于进一步了解江河底部水流的流动特性以及泥沙的沉积和输运机理。     

汛期采金船的缆绳牵拉

本文介绍了采金船渡汛时的停泊方向及采金船在洪水中可能产生拖曳力的估算方法，为了防止采金船汛期发生溜船事故，建议采用缆绳牵拉固船的措施，以保障采金船的汛期安全。     

Relaxation phenomena caused by equilibration of point defects

Relaxation phenomena due to equilibration of point defects in metals are reviewed. The relaxation effect in specific heat observed in tungsten and platinum confirms that in both cases the nonlinear increase in the high-temperature specific heat has to be attributed to point-defect formation. Relaxation phenomena observed by measurements of electrical resistivity and positron annihilation are also considered. The comparison of the data seems to be favorable for the conclusion that all the phenomena are of one origin.     

复合脱氧剂对纯净钢生产的影响

论述复合脱氧剂的一般化学特性，并以碳化硅和硅铝铁两种复合脱氧剂为例，讨论其对改善钢的质量，进行纯净钢生产的影响。     

Preparation of core–shell type nanoparticles of diblock copolymers of poly(L‐lactide)/poly(ethylene glycol) and their characterization in vitro

Core–shell type nanoparticles of poly(L ‐lactide)/poly(ethylene glycol) (LE) diblock copolymer were prepared by a dialysis technique. Their size was confirmed as 40–70 nm using photon correlation spectroscopy. The ¹H‐NMR analysis confirmed the formation of core–shell type nanoparticles and drug loading. The particle size, drug loading, and drug release rate of the LE nanoparticles were slightly changed by the initial solvents that were used. The drug release behavior of LE core–shell type nanoparticles showed an initial burst during the first 12 h and then a sustained release until 100 h. The degradation behavior of LE block copolymer nanoparticles was divided into three phases: the initial rapid degradation phase, the stationary phase, and the rapid degradation phase until complete degradation. It was suggested that lidocaine release kinetics were predominantly governed by the diffusion mechanism in the initial burst phase and after that by both of the diffusion and degradation mechanisms. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 85: 2625–2634, 2002