基于TiNi合金的超弹性对其相关磨损机制的FEM研究

本文在重点考虑TiNi合金高弹性变形量的前提下，采用等向强化模型，对不锈钢和超弹TiNi合金在法向接触载荷作用下的六种模型进行了有限元(FEM)分析。结果表明：在相同载荷条件下，超弹TiNi合金产生的von Mises弹性应变要高于不锈钢，但其von Mises应力和塑性应变却恰恰相反，在同一载荷下该合金发生塑性变形的区域要小于不锈钢；此外，超弹TiNi合金发生塑性变形要比不锈钢困难，所需的临界载荷值随其最大弹性变形量(屈服点处的应变值)的增加而增加。最后，基于本文的有限元计算结果对超弹TiNi合金的蘑粒磨损和疲劳磨损机制进行了讨论。     

Interstate forensic psychology consultations: A call for reform and proposal of a model rule.

Forensic psychology has made important gains in professional recognition and stature in the courts, resulting in increasing demands for mobility of expertise. Current regulations regarding the interjurisdictional temporary forensic practice of psychology, however, are characterized by variability of regulations, ambiguity and inaccessibility, and continuing total barriers. A uniform, well-reasoned policy is needed. A conceptual basis for such a policy is provided by a discussion of licensing rationales and the application of these to forensic practice. Uniformity, public and professional protection, and practicability are identified as fundamental regulatory criteria. A Model Rule Regarding the Temporary Forensic Practice of Psychology is proposed for adoption by state licensing boards on a nationwide basis. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Sorption of Acid Green 25 on chitosan: Influence of experimental parameters on uptake kinetics and sorption isotherms

Acid Green 25, which is a diazoic dye bearing two sulfonic groups, is efficiently sorbed on chitosan. The protonation of chitosan may explain the electrostatic attraction of this anionic dye and that its optimum pH is close to 3. Preliminary protonation of amine groups (obtained by contact with a sulfuric acid solution) reduced the variation of solution pH following sorbent addition but significantly reduced sorption performance: the maximum sorption capacity of raw chitosan, 525 mg dye/g (0.84 mmol dye/g), was halved by acidic preconditioning. The acidic conditioning also reduced the kinetic rate—the time necessary to reach equilibrium increased up to threefold depending on the experimental conditions. The size of sorbent particles influenced sorption kinetics and equilibrium because of resistance to intraparticle diffusion, but the sorption appeared to occur not only at the surface of the sorbent but also in the intraparticle network of the polymer. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 90: 1073–1080, 2003     

针刺机针板及刺针对产品的影响

通过对针刺机针板不同布针形式及刺针规格和型号选用的对比分析，介绍和说明了其对针刺非织造布产品的影响，提出了相应的选择依据。     

生物膜法处理2,3-二甲基苯胺废水试验研究

采用缺氧折流板生物膜和循环移动载体生物膜反应器处理2，3－二甲基苯胺废水，结果表明，缺氧折流板反应器具有厌氧滤池和厌氧折流板反应器的优点，当水力停留时间为10．5h(缺氧5．5h，好氧5h)时，系统去除率可达89．7％。     

纯镁对碳化硼颗粒的常压浸渗

本文研究了纯镁对不同致密度的碳化硼(B₄C)颗粒基片的常压浸渗性;讨论了镁液对B₄C颗粒聚集体常压浸渗的影响因素;提出了浸渗模型。研究表明,纯镁在氩气保护下,800～850℃温度范围保温30min即可浸渗B₄C颗粒聚集体。浸渗深度和宽度随加热温度升高和保温时间延长而增加;常压浸渗的B₄C_P/Mg复合材料具有很高的硬度,B₄C颗粒在基体中分布较均匀。     

钼精矿结球机理及对策研究

钼精矿产品质量的提高、粒度变细,干燥过程中结球现象严重。在氧化钼的焙烧过程中MoS2残留量较高。本文针对这一现象,分析了其结球机理,提出了相应对策及解决办法。     

Bi3+对纳米MnO2水热合成的影响研究

在中性和酸性条件下，以MnO2作为锰源，通过水热合成了纳米MnO2，通过XRD和TEM对产物进行的观察表明，在酸性条件下，向溶液中添加一定量的Bi^3 ，产物的晶型由α型向γ型转化，产物形貌由针状、丝状向颗粒状转变。     

基于米氏散射及夫朗和费衍射的FAM激光测粒仪

提出了综合运用夫朗和费衍射和米氏散射，即在大粒径范围内采用夫朗和费衍射理论，而在小粒径范围内采用米氏散射理论，来改善小粒径范围内的测量精度，保证激光测粒仪在整个粒径范围内的测量精度。