Interaction of inositol phosphate with calcite

The interaction of myo-inositol hexaphosphate with calcite was studied to evaluate the adsorption mechanisms and the electrochemical modifications induced by interaction of a molecule at such a high-charge density. In addition to quantitative information through the construction of adsorption isotherms, FT-IR and Laser Doppler Velocimetry - Photon Correlation Spectroscopy (LDV-PCS) were employed to investigate the nature of the adsorbent-adsorbate bonds and to determine the electrophoretic mobility and size of the particles before and after sorption. The experiments were also run with orthophosphate (Pi) for comparison. The amount of sorbed P increased to reach a plateau at 17.8 mol m^-2 for inositol hexaphosphate (IHP) while for Pi rose 1.4 mol m^-2 but at C_e > 610^-4 M it had a sharp increase reaching 155 mol m^-2. As expected, for Pi, adsorption predominated up Ce 610^-4 M by covering about 20% of total surface. The adsorption occurred at sites that behaved as nucleus of formation of the clustering of Ca- and PO₄-ions with the ending formation of calcium phosphate precipitates at C_e higher than 610^-4 M. The reaction of inositol hexaphosphate with calcite involves, besides adsorption, precipitation of Ca salts and hence calcite dissolution also at the lowest added IHP concentrations, accounting for the large amount retained by calcite. Sorption of IHP on calcite caused aggregation of particles at low concentrations followed by an increase of their negative charge and hence re-dispersion at higher concentrations. These results indicate a great IHP-fixing capacity of calcite that can affect its accumulation in soils and P bioavailability, and a considerable change of calcite electrochemical properties and particle size distribution that can modify aggregate stability.     

流动注射分析法对复合肥中五氧化二磷的分析

在复合肥的生产过程中，用流动注射分析测定磷矿，磷石膏，磷酸中的五氧化二磷，该方法制样简单，分析速度快，结果准确。     

ZnO-P2O5-H2O反应体系磷酸锌颜料的防锈活性研究

采用X—ray、FT—IR、TEM硬化学分析等手段测定了ZnO—P2O5-H2O反应体系制备的磷酸锌防锈颜料的组成、结晶水、粒度分布、颗粒形貌、溶解性、润湿角、比表面积，及其在醇酸树脂中的分散性，研究其化学物理性质。结果表明：该法生产的磷酸锌含有16％未反应的氧化锌，颗粒粗大呈砖形，大部分分布在15～45μm之间；其比表面积较小，在水中溶解度小，离解程度低，在中性介质中表现为一种惰性颜料；磷酸锌在水和有机溶剂中均可润湿，但很快发生沉淀，分散性欠理想。     

壳聚糖/磷钙杂化膜的制备与性能研究

将壳聚糖/钙盐复合膜浸泡在磷酸二氢钾溶液中制备了壳聚糖/磷钙杂化膜.用电子扫描电镜观察杂化膜和膜内磷钙微粒的形貌,研究了杂化膜的力学性能、溶胀率、吸光度及热稳定性.结果表明,杂化膜内磷钙晶体为柱状和层状结构,磷钙被包裹在杂化膜内,并与壳聚糖膜形成紧密的连续结构.随着膜中磷钙的质量分数从2.1%增加到8.0%,膜的溶胀率从102%增加到144%,其在200～800 nm波长范围的吸光度也逐渐增加.当磷钙的质量分数为7.0%时,杂化膜的力学性能最佳,其拉伸强度为54.42 MPa、弹性模量为4045.72 MPa、断裂伸长率为4.85%.杂化膜的热分解温度为299℃,高于壳聚糖膜的分解温度290℃.这种具有层状磷钙结构的杂化膜具有良好的生物相容性,可作为一种潜在的支架材料.     

不同品种磷肥在土壤中的退化研究

对钙镁磷肥（FMP）、过磷酸钙（SSP）和部分酸化磷肥（PAPR）在河南郑州西岗沙土和河南西华县潮土中的退化情况进行了研究。     

类球形低硫磷酸铁的制备技术研究

磷酸铁（FePO₄）是锂电池正极材料磷酸铁锂（LiFePO₄）的核心前驱体,FePO₄形貌及硫含量对合成的LiFePO₄材料性能有重要影响。为得到类球形低硫FePO₄产品,在传统液相沉淀法技术基础上做了改进优化,添加十六烷基三甲基溴化铵（CTAB）作为形貌助剂提高产品球形度,添加氨水作为配体形成磷酸铁铵配合物改善结晶过程,降低产品硫含量。结果表明：所制备的FePO₄产品硫质量分数低,达到2.6×10 ^-5,形貌为均一的微米类球形颗粒,D₅₀=11.4 μm,振实密度达到1.22 g/cm ³,有望成为制备高压实密度LiFePO₄材料的核心前驱体。     

复分解法制备磷酸二氢钾的研究

介绍了以工业氯化钾和工业磷酸为基本原料，采用复分解法，在氯化钾过量的情况下，加入氨水作为pH值调节剂，制备磷酸二氢钾（KH2PO4）的研究。产品含量大于92％，原料转化率（以磷酸计）大于85％，无三废产生。     

Reactive rock phosphate fertilizers and soil testing for phosphorus: The effect of particle size of the rock phosphate

North Carolina rock phosphate (NCRP) (highly carbonate—substituted apatite) was ground to produce three samples with different particle size distributions. The effectiveness of these fertilizers was compared with the effectiveness of superphosphate in a field experiment and three glasshouse experiments using lateritic soils from south-western Australia. Non-reactive Queensland rock phosphate (low carbonate-substituted apatite from the Duchess deposit) was also used in the pot experiments. Bicarbonate-soluble phosphorus extracted from the soil is widely used in Western Australia to predict plant yields from previously-applied fertilizer dressings. For both field and pot experiments bicarbonate-extractable phosphorus (soil test value) was measured and related to subsequent plant yields.As calculated from the initial slope of the relationship between yield and the level of P applied, finely powdered NCRP was about 5–32% as effective as freshly-applied superphosphate in the year of application and also for two years after application in the field experiment, and for two successive crops in the three pot experiments. For both field and pot experiments, finely powdered NCRP, was at best, 1.5–2.0 times as effective as granular NCRP. Relative to freshly-applied superphosphate, the effectiveness of rock phosphates usually decreased with increasing level of application.For each of the crops in the field experiment, the relationships between yield and phosphorus content of plants (i.e. internal efficiency curves) were similar for all fertilizers. Thus the low effectiveness of the rock phosphates relative to superphosphate was solely due to much less phosphorus being taken up by plants. By contrast, in the pot experiments internal efficiency curves differed for different fertilizers. This is attributed to differences in the rate of phosphorus uptake by plant roots during the early stages of plant growth.For both field and pot experiments, soil test calibrations (the relationship between yield and soil test value) differed for rock phosphates and superphosphate. For superphosphate, soil test calibrations also differed for the three different years after the initial application of this fertilizer in the field experiment. For the second crop in the pot experiment, soil test calibrations differed for superphosphate applied at different times (before the first and the second crop). These results point out the difficulty of applying soil testing procedures to soils that have experienced different histories of fertilizer application.     

无机抗菌磷酸盐玻璃及其性能的研究

采用高温熔融法,在磷酸盐玻璃的配合料中引入抗菌剂硝酸银,一次熔化制得抗菌玻璃材料。通过对磷酸盐玻璃的抗菌性能和缓释性能分析,结果表明:制备抗菌磷酸盐玻璃,合适的银含量为1.5%~2.0%(质量),处理温度在1200~1350℃,即可获得良好的抗菌效果和缓释性。     

305酯在船用PVC电缆料中应用研究

用305酯（双季戊四醇酯）增塑剂与其他添加剂配合使用，部分取代TOTM（偏苯三酸三辛酯）生产船用105℃PVC（聚氯乙烯）电线电缆料，并对其电性能，浸水后电性能等进行测试分析。结果表明，305酯为主增塑剂剂时，与4～5份的TCP（磷酸三甲酚酯）并用可以显著改善电缆料浸水电性能。在配方中应用二盐基性苯二甲酸铅和二盐基硬脂酸铅作稳定系统，更能保证电线电缆料浸水电性能的稳定。