某铁路医院加速器室大体积防射线混凝土施工

结合大同铁路分局中心医院直线加速器室工程实际，介绍了大体积防射线混凝土的特点及施工中应注意的事项，并阐述了具体的施工技术。     

Lattice structure on some fuzzy algebraic systems

In this paper, we study the lattice structure of some fuzzy algebraic systems such as (G-)fuzzy groups, some fuzzy ordered algebras and fuzzy hyperstructures. We prove that under suitable conditions, these structures form a distributive or modular lattice. This research partially is supported by the “ Fuzzy Systems and its Applications Center of Excelence, Shahid Bahonar University of Kerman, Iran”.     

Evaluation of passive microwave snow water equivalent algorithms in the depth hoar-dominated snowpack of the Kuparuk River Watershed, Alaska, USA

This research investigates the utility of passive microwave remote sensing instruments to accurately determine snow water equivalent (SWE) over large spatial extents. Three existing Special Sensor Microwave Imager (SSM/I) snow water equivalent algorithms produced by Chang, Tait and Goodison were evaluated for their ability to determine snow water equivalent in a snowpack containing substantial depth hoar, large faceted snow crystals. The Kuparuk River Watershed (8140 km²) test site on the North Slope of Alaska was chosen for its snowpack containing a think depth hoar layer and long history of ground truth data. A new regional snow water equivalent algorithm was developed to determine if it could produce better results than the existing algorithms in an area known to contain significant depth hoar. The four algorithms were tested to see how well they could determine snow water equivalent: (1) on a per pixel basis, (2) across swath-averaged spatial bands of approximately 850 km², and (3) on a watershed scale. The algorithms were evaluated to see if they captured the annual spatial distribution in snow water equivalent over the watershed. Results show that the algorithms developed by Chang and from this research are generally within 3 cm of the spatially averaged snow water equivalents over the entire watershed. The algorithms produced by Chang, Tait, and in this research were able to predict the basin-wide ground measured snow water equivalent value within a percent error range from −32.4% to 24.4% in the years with a typical snowpack. None of the algorithms produce accurate results on a pixel-by-pixel scale, with errors ranging from −26% to 308%.     

透反液晶显示器

兼有透射型和反射型液晶显示优点的透反液晶显示可工作于透射和反射两种显示模式，它将广泛应用于手机、PDA等通讯领域。透反液晶显示可分为单盒厚和双盒厚两大类。又可分为扭曲型和非扭曲型两种。为了研制出高性能透反液晶显示器，需解决透反两个显示区的响应时间、光效率、色饱和度的差异以及视角等问题。文中介绍了Sharp公司开发的2种基本的透反液晶显示。以及3种新近开发的高性能透反液晶显示。随着应用市场的扩大和技术的进步，透反液晶显示将会进一步得到发展。     

一种新的变步长ICA自适应算法

结合互信息极小的优化判据，基于估计函数期望平方准则、外点法和最速下降法的思想，本文导出了一种新的变步长独立分量分析(ICA)自适应算法。该算法克服了固定步长在分离矩阵推导过程中出现的稳态失调问题，比基于模拟退火步长的ICA算法有更快的仞始收敛速度和较高的分离精度。同时，该算法还具有较好的时变系统跟踪能力。理论分析和仿真计算结果证实了其可以有效地提高ICA的自适虚性，更准确地完成盲信号分离。     

Numerical analysis of two-dimensional steady-state and transient heat transfer in a parallel duct filled with pressurized He II

Analysis on steady-state and transient heat transfer on a flat plate at the middle of a parallel duct immersed in He II was performed for bath temperatures from 1.8 to 2.1 K at 101.3 kPa. Two-dimensional computer code named SUPER-2D developed by the authors based on the two-fluid model and the theory of mutual friction was used. Steady-state critical heat flux (CHF) and the time lag from the application of a step heat input to λ transition, that is called a lifetime, were obtained numerically for various step heat fluxes and for the channel gaps from 2 to 20 mm. Effect of the gap restriction on the CHF and the lifetime were clarified. The solutions were compared with the experimental data for the ducts with the same structures and the corresponding conditions. They agreed well with the experimental data. The heat transport mechanism in the parallel duct was clarified.     

The Difference in Turbulent Diffusion between the Active and Passive Scalars in a Thermally Stably Stratified Medium

The difference in the turbulent diffusion between the active (heat) and passive (mass) scalars in a thermally stably stratified medium is investigated. The axisymmetric problem is treated on the formation of a turbulent circulation flow above a heated disk and on the turbulent diffusion of a passive scalar (impurity) from a continuous surface source in a stably stratified medium. The results indicate that the thermal stratification causes appreciable differences in the coefficients of turbulent transfer between the active (heat) and passive (mass) scalars. This means that the assumption of the identity of the coefficient of turbulent diffusion of heat and mass, employed in conventional models of turbulence, produces significant errors in estimating the heat and mass transfer in a thermally stably stratified medium.     

Comparison of activities in selective catalytic reduction of NOx by C3H8 over Co/MFI, Fe/MFI, and H/MFI zeolite catalysts

The Co/MFI(SiO₂/Al₂O₃ = 30) were prepared by a precipitation method with NaOCl in alkali solutions exhibited high activities to N₂ at 250 °C for the selective catalytic reduction (SCR) of NO_x. These catalysts showed two UV–vis bands at 700 and 400 nm, indicating the presence of octahedral Co(III) as well as tetrahedral Co(II). The high SCR activity over such Co(III, II)/MFI(30) seems to come from Co(III)---O moieties. The Co(II)MFI(30) catalysts prepared from Co(II)Cl₂ exhibited low SCR activities due to the presence of tetrahedral Co(II) ions in MFI. Less CO formation occurred over Co/MFI catalysts. The Fe/MFI(30) catalyst exhibited high activity due to the presence of some Fe---O species in MFI but more amount of CO were produced during SCR. H/MFI(30) catalyst exhibited a good SCR activity. However, more amount of carbonaceous deposits were produced on it. The correlation between acid concentration and SCR activity was discussed over H/MFIs.     

（E）-2-壬烯酸合成方法的改进

(E)-2-壬烯酸是有机合成的一种重要中间体,我们利用Knoevenagel反应机理,改进了(E)-2-壬烯酸的合成工艺,在不使用脱水剂条件下,使用少量吡啶作催化剂,获得了83%的反应收率。     

Highly ordered microstructures of poly(styrene-b-isoprene) block copolymers induced by solution meniscus

Microstructures of hundreds of micron thick poly(styrene-block-isoprene) copolymer films solution-cast in a cylindrical tube with the solvent evaporation controlled were investigated by transmission electron microscope (TEM), small angle X-ray scattering (SAXS) and optical microscope (OM). In a block copolymer with cylindrical polyisoprene microdomains, the orientation of the cylinders was varied along radial direction of the cylindrical tube. Highly aligned hexagonal arrays of in-plane polyisoprene cylinders were formed with their cylindrical axis parallel to the circumference of the tube in the regimes close to the wall edge. In contrast randomly ordered microdomains were observed at the center of the tube. We have also found that the orientation depends on the solvent evaporation rate and an intermediate rate (∼2.3 nL/s) provides the best orientation. In the case of a block copolymer with a bicontinuous double gyroid structure, we obtained a globally ordered microstructure where [111] crystallographic direction was parallel to the circumference of the tube. For both block copolymers, the area of highly ordered arrays of nanoscopic domains is over 1 mm². Development of the orientation was explained by coupling two orthogonal fields: (1) The flow of a solution induced by strong capillary force at a meniscus between the cylindrical tube wall and the block copolymer solution and (2) the solvent evaporation.