Leaching of complex sulphide concentrate in acidic cupric chloride solutions

The chemical analysis of a complex sulphide concentrate by emission spectrometry and X-ray diffraction shows that it contains essentially copper, lead, zinc and iron in the form of chalcopyrite, sphalerite and galena. A small amount of pyrite is also present in the ore but does not be detected with X-ray diffraction. The cupric chloride leaching of the sulphide concentrate at various durations and solid/liquid ratios at 100 ℃ shows that the rate of dissolution of the ore is the fastest in the first several hours, and after 12 h it does not evolve significantly. If oxygen is excluded from the aqueous cupric chloride solution during the leaching experiment at 100 ℃, the pyrite in the ore will not be leached. The determination of principal dissolved metals in the leaching liquor by flame atomic absorption spectrometry, and the chemical analysis of solid residues by emission spectrometry and X-ray diffraction allow to conclude that the rate of dissolution of the minerals contained in the complex sulphide concentrate are in the order of galena 〉 sphalerite 〉 chalcopyrite.     

Increasing silver leaching rate from leaching-resistant zinc residues by thiourea leaching method with pressurized preoxidation process

1　ＩＮＴＲＯＤＵＣＴＩＯＮＡｔｐｒｅｓｅｎｔ ,ｚｉｎｃｉｓｐｒｏｄｕｃｅｄｂｙｔｈｅｈｙｄｒｏｍｅｔａｌｌｕｒｇｙ ｅｌｅｃｔｒｏａｎａｌｙｓｉｓｍｅｔｈｏｄｉｎｍｏｓｔｚｉｎｃｓｍｅｌｔｉｎｇｐｌａｎｔｓ .Ｅａｃｈｙｅａｒ,ｍｉｌｌｉｏｎｓｔｏｎｓｏｆｈｙｄｒｏｍｅｔａｌｌｕｒｇｉｃａｌｚｉｎｃｒｅｓｉｄｕｅｓａｒｅｄｉｓｃｈａｒｇｅｄｆｒｏｍＣｈｉｎｅｓｅｓｍｅｌｔｉｎｇｐｌａｎｔｓ ,ｗｈｉｃｈａｒｅｈｉｇｈｌｙａｃｉｄｉｃａｎｄｃｏｎｓｉｓｔｏｆｇｒｅａｔｄｅａｌｏｆｓｉｌｖｅｒａｎｄｏｔ…     

α－淀粉对合脂砂的改性作用及生产实践

针对合脂砂的缺点，尝试用α－淀粉对其改性，并成功应用于大批量生产。生产实践证明，α－淀粉是合脂砂较理想的改性材料。     

环Fp uFp vFp uvFp上的二次剩余码

针对环Fp+ uFp+ vFp+ uvFp上的二次剩余码进行了研究,其中u2=u,v2=v,uv=vu,p是一个奇素数.首先引入了环Fp+ uFp+vFp+ uvFp上长为n的循环码的相关知识,用幂等元的形式定义了环Fp+ uFp+vFp+uvFp上的二次剩余码,给出了其定义和性质,并讨论了它们与其扩展码之间的关系和对偶性质.最后,给出了环F3+uF3+vF3+uvF3上长为11的二次剩余码的幂等生成元的具体形式.     

多特征融合的蛋白质相互作用位点预测

蛋白质相互作用位点预测为蛋白质功能和药物设计的理解提供重要线索。而蛋白质的各种特征为蛋白质相互作用位点预测提供了大量有用信息,特别是进化信息、残基序列邻近和空间邻近性。不同的蛋白质特征对蛋白质间的相互作用的贡献也不一样。通过提取蛋白质序列谱、保守性和残基熵,提出了特征融合技术对蛋白质相互作用位点进行研究,采用SVM构建三种预测器,分别对各种不同的特征加以验证,实验结果表明了基于特征融合方法的有效性和正确性。     

钢包钢渣清拆机无线遥控系统

为了提高工作效率、减轻劳动强度,设计了马钢固定式钢包钢渣清拆机无线遥控系统.无线遥控控制系统主要由无线控制器、无线接收器和PLC组成.控制器将按钮信号编码经调制后转换成电磁波信号发出,接收器将接收的电磁波信号滤波放大,经解码识别传送给PLC实现对被控目标的控制.采用远程遥控控制后,消除了以往由于视线不清、环境恶劣等因素造成的事故隐患,提高了工作效率,减轻了劳动强度.该文详细说明了系统的设计思路及设计方法.     

基于峰宽修正的玻璃药瓶内氧气残留浓度的检测研究

玻璃药瓶中的氧气残留对瓶中药品的无菌特性造成了严重的威胁。采用波长调制光谱（Wavelength Modulated Spectrum, WMS）技术解调得到的二次谐波信号峰高值作为氧浓度反演的基础。然而,在用二次谐波信号测量气体浓度时,由于调制深度的变化会导致二次谐波峰值的变化,这通常会给系统带来误差,进而降低浓度的反演精度。而调制深度受调制电流波动、温度和压强变化等因素的影响不能直接计算获得进而修正。针对这一问题,本文成功地将调制深度与二次谐波峰高的关系转换为二次谐波峰宽和峰高的关系。然后,利用峰宽校正后的谐波峰高对气体浓度进行反演。初步实验表明,利用峰宽校正后的谐波峰高对瓶内气体浓度进行预测的准确性提高了2.1%,且系统的整体鲁棒性也得以提升。本文提出的校正方法不需要系统参数信息与气体成分信息,可以直接从谐波信号本身出发对调制深度进行校正,十分适合于工业现场的在线氧气浓度预测。     

High speed decoding of the binary (47, 24, 11) quadratic residue code

An efficient table lookup decoding algorithm (TLDA) is presented to decode up to five possible errors in a binary systematic (47, 24, 11) quadratic residue (QR) code. The main idea of the TLDA is based on the weight of syndrome, the syndrome decoder together with a reduced-size lookup table (RSLT), and the shift-search method given by Reed et al. Thus, the size of the lookup table and computational complexity in a finite field can be significantly reduced. The memory size of the proposed condensed lookup table (CLT) consists of only 36.6 Kbytes and is only about 0.24% of the full lookup table (FLT) and 3.2% of the lookup up table given by Chen et al., respectively. These facts lead to significant reduction of computational time and the decoding complexity. A simulation result shows that the decoding speed of the proposed TLDA is much faster than all existing decoding algorithms. Moreover, it can be extended to decode all QR codes, including the class of the cyclic codes when the code length is moderate. The CLT makes this new decoding algorithm suitable for hardware or firmware implementations.     

Effects of soil composition and mineralogy on remote sensing of crop residue cover

The management of crop residues (non-photosynthetic vegetation) in agricultural fields influences soil erosion and soil carbon sequestration. Remote sensing methods can efficiently assess crop residue cover and related tillage intensity over many fields in a region. Although the reflectance spectra of soils and crop residues are often similar in the visible, near infrared, and the lower part of the shortwave infrared (400-1900 nm) wavelength region, specific diagnostic chemical absorption features are evident in the upper shortwave infrared (1900-2500 nm) region. Two reflectance band height indices used for estimating residue cover are the Cellulose Absorption Index (CAI) and the Lignin-Cellulose Absorption (LCA) index, both of which use reflectances in the upper shortwave infrared (SWIR). Soil mineralogy and composition will affect soil spectral properties and may limit the usefulness of these spectral indices in certain areas. Our objectives were to (1) identify minerals and soil components with absorption features in the 2000 nm to 2400 nm wavelength region that would affect CAI and LCA and (2) assess their potential impact on remote sensing estimates of crop residue cover. Most common soil minerals had CAI values ≤ 0.5, whereas crop residues were always > 0.5, allowing for good contrast between soils and residues. However, a number of common soil minerals had LCA values > 0.5, and, in some cases, the mineral LCA values were greater than those of the crop residues, which could limit the effectiveness of LCA for residue cover estimation. The LCA of some dry residues and live corn canopies were similar in value, unlike CAI. Thus, the Normalized Difference Vegetation Index (NDVI) or similar method should be used to separate out green vegetation pixels. Mineral groups, such as garnets and chlorites, often have wide ranges of CAI and LCA values, and thus, mineralogical analyses often do not identify individual mineral species required for precise CAI estimation. However, these methods are still useful for identifying mineral soils requiring additional scrutiny. Future advanced multi- and hyperspectral remote sensing platforms should include CAI bands to allow for crop residue cover estimation.     

On the decoding of binary cyclic codes with the Newton identities

We revisit in this paper the concept of decoding binary cyclic codes with Gröbner bases. These ideas were first introduced by Cooper, then Chen, Reed, Helleseth and Truong, and eventually by Orsini and Sala. We discuss here another way of putting the decoding problem into equations: the Newton identities. Although these identities have been extensively used for decoding, the work was done manually, to provide formulas for the coefficients of the locator polynomial. This was achieved by Reed, Chen, Truong and others in a long series of papers, for decoding quadratic residue codes, on a case-by-case basis. It is tempting to automate these computations, using elimination theory and Gröbner bases.Thus, we study in this paper the properties of the system defined by the Newton identities, for decoding binary cyclic codes. This is done in two steps, first we prove some facts about the variety associated with this system, then we prove that the ideal itself contains relevant equations for decoding, which lead to formulas.Then we consider the so-called online Gröbner basis decoding, where the work of computing a Gröbner basis is done for each received word. It is much more efficient for practical purposes than preprocessing and substituting into the formulas. Finally, we conclude with some computational results, for codes of interesting length (about one hundred).