GOR-C降烯烃催化剂的工业应用

大庆炼化公司林源生产指挥部催化裂化装置原料油为典型石蜡基原油的常压渣油，生产的催化汽油中的烯烃含量较高，为此试用长岭炼化公司催化剂厂生产的降烯烃催化剂GOR-C。结果表明，降烯烃效果明显，产品分布无明显变化，能满足现有生产要求，经济效益显著。     

Transient testing of soy methyl ester fuels in an indirect injection,compression ignition engine

An evaluation of the exhaust emissions from a compression ignition engine for fuels composed of 100 and 30% methyl esters of soy oil (SME) is described. These fuels were compared with a low-sulfur, petroleum #2 diesel fuel in a Caterpillar 3304, prechamber, 75 kW diesel engine, operated over heavy- and light-duty transient test cycles developed by the United States Bureau of Mines. More than 60 h of testing was performed on each fuel. The objective was to determine the influence of the fuels upon diesel particulate matter (DPM) and gaseous emissions. The effect of a modern diesel oxidation catalyst (DOC) also was determined in an effort to minimize emissions. Neat SME produced a higher volatile fraction of the DPM, but much less carbon soot fraction, leading to overall DPM reductions of 23 to 30% for the light- and heavy-duty transients. The DOC further reduced the volatile fraction and the total DPM. The SME fuel reduced gaseous emissions of CO by 23% and hydrocarbons by over 30% without increasing NO_x. The DOC further reduced CO and hydrocarbon levels. Mutagenicity of the SME exhaust was low. Results indicate that SME fuel, used with a proper DOC, may be a feasible emission reduction technology for underground mines. References to specific products do not imply endorsement by the U.S. Bureau of Mines, a now defunct agency.     

Ultrapyrolysis of automobile shredder residue

A fast pyrolysis (Ultrapyrolysis) process was employed to convert automobile shredder residue (ASR) into chemical products. Experiments were conducted at atmospheric pressure and temperatures between 700 and 850°C with residence times between 0.3 and 1.4 seconds. Pyrolysis products included 59 to 68 mass% solid residue, 13 to 23 mass% pyrolysis gas (dry) and 4 to 12 mass% pyrolytic water from a feed containing 39 mass% organic matter and 2 mass% moisture. No measurable amounts of liquid pyrolysis oil were produced. The five most abundant pyrolysis gases, in vol%, were CO (18–29), CO₂ (20–23), CH₄ (17–22), C₂H₄ (20–22) and C₃H₆ (1–11), accounting for more than 90% of the total volume. The use of a higher organic content ASR feed (58 mass%) resulted in less solid residue and more pyrolysis gas. However, no significant changes were noted in the composition of the pyrolysis gas.     

厌氧污泥处理含铬废物的研究

利用城市污水处理厂的厌氧污泥对含铬废物进行解毒研究,结果表明,在厌氧条件下,厌氧污泥对重铬酸钾溶液和铬渣进行解毒后,滤液中的Cr6+质量浓度极低,大大低于《污水综合排放标准》的0.5 mg/L。厌氧污泥的解毒效果与含铬物料的量、解毒时间等因素有关。     

Flaking and extrusion as mechanical treatments for enzyme-assisted aqueous extraction of oil from soybeans

Flaking and extruding dehulled soybeans were evaluated as a means of enhancing oil extraction efficiency during enzyme-assisted aqueous processing of soybeans. Cellulase, protease, and their combination were evaluated for effectiveness in achieving high oil extraction recovery from extruded flakes. Aqueous extraction of extruded full-fat soy flakes gave 68% recovery of the total available oil without using enzymes. A 0.5% wt/wt protease treatment after flaking and extruding dehulled soybeans increased oil extraction recovery to 88% of the total available oil. Flaking and extruding enhanced protease hydrolysis of proteins freeing more oil. Treating extruded flakes with cellulase, however, did not enhance oil extraction either alone or in combination with protease. Discrepancies in oil extraction recoveries were encountered when merely considering crude free fat because some oil became bound to denatured protein during extrusion and/or sample drying. Bound fat was unavailable for determination by using the hexane extraction method, but was accounted for by using the acid hydrolysis method for total oil determination. Oil extraction recovery from extruded soybean flakes was affected by oil determination methods, which was not the case for unextruded full-fat soy flour.     

用锌渣制备高纯氧化锌

介绍了利用锌渣为原料生产高纯氧化锌的方法。采用黄铁矾法除去大部分铁，通过控制ｐＨ值进一步除铁，用锌粉或锌屑还原除去重金属，用氨水为沉淀剂，最终可使氧化锌的含量达９９．８６％以上。     

用油溶性催化剂加氢裂化孤岛减压渣油的研究

介绍了抚顺石油化工研究院开发的油溶性金属催化剂。并以孤岛减压渣油为原料，采用该催化剂在高压釜上进行悬浮床加氢裂化反应试验，馏分油（<538 ℃）收率可达到70％以上。试验结果表明，油溶性金属催化剂具有较高的加氢活性和抑焦性能。     

测定医疗废水中总余氯方法的改进

对现场快速测定医疗废水中总余氯的方法进行了改进，该方法方便、容易掌握，现场测定总余氯能在较短时间内完成，对防止医疗废水的二次污染和交叉感染作用明显．     

Study on the formation of β-crystal during the crystallization process of polypropylene reactor granule

A notable amount of PP β-crystal (30%, by X-ray diffraction pattern) has been found in the PP samples as polymerized at normal static isothermal crystallization conditions without using any extra nucleating agents. Existence of catalyst residues in the sample is decisive, which slows down the crystallization rate facilitating the formation of β-form spherulites. Comparatively, high molecular weight PP favors the formation of β-form spherulites, deducting from no β-crystal detected in the degraded samples. Finally, high isotacticity is also required for obtaining qualitative β-form spherulites, demonstrated by increased β-crystal content after removal of weak crystalline fraction of the sample.     

Bauxite residue (red mud) increases phosphorus retention in sandy soil catchments in Western Australia

The Peel-Harvey estuary on the Swan Coastal Plain, Western Australia has become eutrophic partly because of the leaching of fertiliser phosphorus from sandy soils. The acid, coarse textured sandy soils are predominantly quartz, have a low iron and aluminium content and do not retain phosphorus. Red mud, derived from bauxite, is a by-product of the alumina industry and has the ability to retain phosphorus. Retention of phosphorus is enhanced when the red mud is neutralised with gypsum. Red mud has been suggested as a soil amendment to reduce phosphorus leaching.To investigate the reduction in the leaching of phosphorus from soils amended with red mud, weirs were constructed at the outlets from a pair of catchments to quantify the amount of phosphorus in the streamflow. Both catchments were deep grey Bassendean sand. One of the catchments was treated with 80 t/ha of red mud which had been neutralised with waste gypsum from the phosphate industry. The red mud was applied to the soil surface using conventional fertiliser spreading equipment. The other catchment was untreated.The red mud reduced phosphorus loss by 70% from 13.8 kg/ha on the untreated catchment, to 4.2 kg/ha on the treated catchment. Both catchments were treated with 20.4 kg/ha of phosphorus as superphosphate. The catchment treated with red mud also received a further 41.5 kg/ha of phosphorus from the phosphogypsum that was used to neutralise the red mud.Our results show that red mud reduces phosphorus leaching and is potentially a nutrient management option in sandy soils. Red mud has the potential to reduce the impact of agriculture on the estuarine environment and has implications for the continued expansion and intensification of agriculture in the Peel-Harvey catchment.