Non-destructive evaluation of residual stresses in thin films via x-ray diffraction topography methods

Quantitative x-ray diffraction topography techniques have been used to measure the residual strain magnitude and uniformity of deposition for Mo and W sputtered films on Si(100) substrates. High sensitivity rocking curve measurements were able to determine differential strains for films as thin as 2.5 nm; while Bragg angle contour mapping had similar sensitivity and was also able to assess coating uniformity and stress distribution over areas covering a whole wafer. Measurements of strain versus film thickness over a range of 2.5 nm to 80 nm showed that a critical thickness exists for maximum residual strain. Growth beyond this range produces stress relaxation. This non-destructive type of analysis could be employed on a wide range of film-substrate combinations.     

Modelling of a gas flow measurement: Application to nuclear containment vessels

The objective of this work is to simulate the gas flow across a concrete wall of a nuclear power plant internal enclosure. In the laboratory, permeability measurements are generally made on cylindrical samples (15 cm diameter×5 cm height: ∅ 15×5 cm) with a steady-state experiment. To be able to predict structural behaviour, we studied size effect and steady-state time with a modified CEMBUREAU permeability test. A statistical approach showed that there is no size effect on concrete permeability. Laboratory results found on cylindrical samples can be applied to tests in situ, where concrete specimens are thicker. A model based on the mass balance relation provided times to reach steady state and reproduced experimental flow kinetics for uniform water content across specimens.     

广播电视农村覆盖现状浅析

加强农村广播电视的发展,提高其覆盖率是关键,针对这一问题,阐述了解决农村广播电视覆盖的手段,对农村广播电视覆盖现状做了详细的分析,并提出建议和措施。     

全双极WTA模型的改进及其实现

提出了一种相似度的新定义，使双极ＷＡＴ模型的实现更加简洁明了。增加一个阈值使系统能判别非存储模式或因其信息量过低而无法鉴定的输入模式，阈值的大小与要求的容错能力有关。双极相似度及阈值通过光学方法实现。阈值的光学实现使系统仍具有照明不变性。通过电路实现取及ＷＴＡ网络的迭代运算。     

IPA模型对Hopfield模型神经网络的改进

考虑Ｈｏｐｆｉｅｌｄ模型中假态之间的布尔逻辑关系，提出利用ＩＰＡ模型对神经网络中的假态进行抑制，并和原网络的性能进行了比较，结果表明：改进后的网络性能比Ｈｏｐｆｉｅｌｄ模型和ＩＰＡ模型均有较大提高。     

DIGITAL PROCESSING OF THE POLARIZATION STATE OF GEOPHYSICAL ULF SIGNALS

In this paper, the evaluation by running window smoothing is used for the digital processing of the polarization of geophysical ULF signals. The observed signals are resolved into two orthogonal complex components so that it is no longer necessary to consider the phase and amplitude of the signals simultaneously.     

用稳态反饱和吸收法测量C_（60）的激发态吸收截面

用准连续激光实现了Ｃ６０的稳态反饱和吸收，通过实验和理论计算的拟合，确定了Ｃ６０的三重第一激发态吸收截面。     

内燃机车曲轴中频淬火过程的数值模拟

借助 ANSYS大型有限元分析软件 ,实现了 16 V2 4 0曲轴淬火过程的计算机模拟 ,模拟结果可直观地显示出任一时刻曲轴表面及内部的温度分布、冷却曲线以及淬火结束后的残余应力分布 ,并能预测淬硬层深度。同时对比了轴颈内圆角处进行淬火和不进行淬火两种工艺的效果 ,为现场提供了用虚拟现实方法详尽分析和研究淬火工艺的工具。     

全20CrMnTi表面激光重熔的组织与性能研究

本文对激光重熔20CrMnTi材料表明改性层显微组织分布特征、表面硬度分布规律以及残余应力状态作了研究,结果表明,表面改性层由熔融层、相变硬化层及过渡层组成,且材料表面显微硬度得到大幅度提高,表面硬度达到HV841,约提高4倍。硬化层深度约1mm。残余应力测试得出最大残余应力出现在熔凝带中心,表现为压应力。随着离中心距离的增大,残余应力逐步降低,到熔化带边缘,表现为低幅值压应力;而熔池的外边缘应力在热影响区则转变为拉应力状态。