工字梁的抗剪极限承载力

对工字梁腹板抗剪极限承载力的研究进行总结,对各种公式与文献中的试验结果进行对比,将拉力场理论和转向应力场理论的假定与ANSYS分析揭示的腹板应力发展变化规律进行对比,指出了假定和数值分析结果的不一致。提出了翼缘对腹板转动约束的合理参数,得到精度良好的考虑翼缘约束的腹板剪切屈曲系数。利用得到的屈曲系数,考虑翼缘抗弯承载力的贡献,提出新的工字梁抗剪极限承载力的计算公式。与现有试验数据和ANSYS非线性有限元分析结果的对比,证实建议方法离散性较小,适用范围广,尤其是对于通用高厚比较大的梁,较以往方法有了较大改进。     

软土地基水泥搅拌桩室内配合比试验分析

对广州南沙某工程软土地基搅拌桩室内不同配比的水泥土标准试件进行对比试验,研究软土地基搅拌桩施工中水泥、石膏等添加剂的最佳配比方案,对指导搅拌桩的现场施工有着重要的意义。     

The influence of nanoadhesives on the tensile properties and Mode-I fracture toughness of bonded joints

Nanoadhesives of epoxy resin are synthesized and evaluated. They are organically modified by multiwalled carbon nanotubes (MWCNT) (1% by weight) as reinforcement. Tensile tests are conducted on multiple identical unnotched and notched specimens to evaluate the overloading and fracture behavior of the nanoadhesives and are compared with the neat epoxy resin. In comparison with the neat epoxy, it is found that the 1% MWCNT reinforcement increased the ultimate and residual strength by about 29% and 56%, respectively. In comparison with the neat resin, there is a 265% increase in the fracture toughness of the MWCNT adhesive. Fracture surface analysis revealed the various mechanisms by which the MWCNT adhesives acquire their superior strength and toughness in comparison with the neat resin.     

Pb/Sn凸剪切性能研究

在实际使用条件下,Pb/Sn凸点会由于承受温度循环而产生剪切应力,剪切应力导致的主要失效方式是开裂.通过对倒装焊后Pb/Sn凸点剪切强度的测量及对剪切后断口的分析,发现破坏主要发生在凸点下金属(UBM)层内部或UBM与Al焊盘之间,平均剪切强度受凸点尺寸影响很小,范围在21～24MPa。     

Effect of fiber types on relevant properties of porous asphalt

The research was conducted to evaluate the effects of cellulose and polyester fibers on the properties of porous asphalt mixes, using the tests of draindown, abrasion, volumetric properties, rutting, and moisture damage. Images of scanning electron microscopy and X-ray computerized tomography were adopted to identify the microstructure of the fiber and inner stone skeleton of porous asphalt. The influence of rutting parameter （G＊/sin δ） of asphalt modified by different fibers on the rutting resistance of the mixes was investigated. Based upon MOHR-COULOMB theory, the cohesion and the angle of internal friction of the mixes were derived from both indirect tension and unconfined compression strength. The experimental results indicate that fibers mainly stabilize asphalt binder and thicken asphalt film around aggregates. Furthermore, they result in the improved mechanical strength of porous asphalt mixes at high temperature slightly. From comparison analysis, cellulose fibers appear to perform better than polyester fibers in porous asphalt mixes.     

Swelling behavior induced by alteration in granite and its implications on underground excavation

Granite is commonly recognized as an ideal medium for underground construction. However, in the site investigation for Heimifeng Pumped Storage Power Station project, it was found that there are swelling behaviors induced by alteration in granite and eventually causing slaking and disintegration of rock blocks. The study shows that hydrothermal alteration in granite is primarily due to the intrusion of multi-phase igneous magma. The clay minerals, such as montmorillonite, chlorite, kaolinite, are the main causes for the swelling behavior of granite. In the exploratory adits, alteration was observed to occur mainly along faults or fractures in the rock masses and resulted in roof caving if water is present. Some of the highly altered borehole cores swell and crack within 24 h in water and eventually disintegrate completely. From the testing results on the samples, the maximum axial free swelling strain is about 1.2%, while the maximum axial confined swelling strain is around 0.1% with swelling stress less than 25 kPa. Under free swelling tests, 80% of swelling is completed within 24 hours. Under confined swelling condition, swelling process is completed within 1 h for some samples, with 80% of maximum swelling strain finished within around 22 h for most of the samples. Contraction of samples occurs after swelling completed. The strength of granite, reflected by deformation and elastic moduli, shear strength, decreases due to alteration. The deformation and elastic moduli are even lower compared to highly weathered rock. The shear strength is between that for highly weathered and slightly weathered rocks. The swelling characteristics of the altered rock present great challenges for support or lining during construction and operation stages. Support or lining shall be in place immediately after excavation. Since the rock may swell when encountering water, the shotcrete shall be designed accordingly. During the construction of access tunnel and caverns, water shall be drained in time. Drainage directly from surface shall be avoided so as to prevent floor heave.     

浅谈天然彩棉织物的质量

从生产实践出发 ,阐述了彩棉纤维物理指标对彩棉纱的性能、织物的强力、色牢度及色泽的影响。     

西气东输工程用X70热轧板卷屈服强度检测值波动大的探讨

对西气东输工程用X70热轧板卷检验过程中出的屈服强度σ0.5波动大的情况进行了分析，认为拉伸试样弯曲是主要原因。这一问题可通过反复压平试样，确保试样的平直度以及适当提高钢的强度的方法加以解决。     

高强度钢板在汽车车身上的应用及问题对策

主要介绍高强度钢板使用量增加背景、已开发或正在开发的种类、高强度钢板在汽车车身上的应用以及高强度钢板使用中存在的主要问题及其对策等。