气管上段腺样囊性癌的临床病理

目的　探讨气管上段腺样囊性癌的临床病理特征及诊断和鉴别诊断要点。方法　收集2000年1月至2014年2月在北京协和医院确诊的4例气管上段腺样囊性癌病例，通过光镜、免疫组织化学及组织化学染色分析其临床病理特征、免疫组织化学特点、诊断及鉴别诊断要点。结果　4例气管上段腺样囊性癌患者中，男1例，女3例，平均年龄47岁(38~57岁）；既往均无腺样囊性癌病史，1例患者既往有结节性甲状腺肿手术史。镜下检查4例均为筛状/管状型腺样囊性癌，3例累及甲状腺组织，3例累及神经组织，未见淋巴结受累。免疫组织化学染色示4例P16、CD117、BCL2、P63、SMA均阳性，Ki67指数平均8%，TTF1和P53均阴性；4例中基底膜样物胶原Ⅳ阳性；组织化学染色示AB/PAS阳性。术后均接受总剂量为48~56 Gy的放疗，随访6~120个月，平均72.5个月，1例术后96个月复发，3例随访期间无复发及转移。结论　气管上段腺样囊性癌是罕见的原发于气管的低度恶性肿瘤，肿瘤生长缓慢，就诊时多数已侵及甲状腺组织，需要与原发于甲状腺的恶性肿瘤相鉴别，特别是在甲状腺穿刺及术中冰冻检查时。结合电子喉气管镜下表现、典型的形态学及免疫组织化学和组织化学染色有助于准确诊断。手术难以切除干净，术后放疗对延缓疾病复发有一定帮助。     

无失效数据机载多余度EWIS可靠性研究

针对高可靠度机载多余度EWIS各组成部分寿命服从指数分布但参数未知的情况，提出采用无失效数据可靠度分析方法评估EWIS的可靠度水平。通过Monte-Carlo仿真方法对连接形式为“先并联、后串联”EWIS各组成部分寿命进行抽样，利用“最小最大值”方法获得系统寿命的抽样值，用概率纸检验法初步判断EWIS寿命是否服从威布尔分布，再用Pearson拟合优度检验法判断EWIS寿命是否服从威布尔分布。结合无故障飞行时间的样本值与EWIS寿命服从威布尔分布的假设，采用无失效数据分析方法评估EWIS的可靠度水平。研究方法对机载多余度EWIS无失效数据可靠度分析有一定的贡献。     

Systematic optimization of corrosion,bioactivity, and biocompatibility behaviors of calcium-phosphate plasma electrolytic oxidation (PEO) coatings on titanium substrates

To optimize the corrosion, bioactivity, and biocompatibility behaviors of plasma electrolytic oxidation (PEO) coatings on titanium substrates, the effects of five process variables including frequency, current density, duty cycle, treatment time, and electrolyte Ca/P ratio were evaluated. In our systematic study, a Taguchi design of experimental based on an L16 orthogonal array was used. For this, the coatings characteristics such as the surface roughness, wettability, rutile to anatase and Ca/P ratios, and corrosion polarization resistance were investigated. After determining the optimum process variables for each response, the apatite forming ability in SBF (bioactivity behavior) and MG63 cell attachment and flattening (biocompatibility behavior) for two groups of coatings were examined. The first group was optimized based on the maximum corrosion polarization resistance and the variables were set as the frequency of 2000 Hz, the current density of 5 A/dm², the duty cycle of 30%, the treatment time of 5 min, and the Ca/P ratio of 0.65 at. % in the electrolyte. For the second group, the maximum surface roughness, greatest Ca/P ratio, and highest wettability as well as the minimum rutile to anatase ratio in coatings, could be obtained when the variables were set as the frequency of 10 Hz, the current density of 12.5 A/dm², the duty cycle of 50%, the treatment time of 12.5 min, and the Ca/P ratio of 1.70 at. % in the electrolyte. The results showed that while both groups of coatings indicated a significant apatite forming ability and can serve as bioactive coatings, a proper attachment and flattening of cells and consequently, the favorable biocompatibility properties were seen only in the first group.     

Recent activities in the field of Nuclear Operational Management and Nuclear Safety Engineering

Recent activities in the field of Nuclear Operational Management and Nuclear Safety Engineering, the studies related to risk analysis methodology, design, and operational management, physical phenomena, and emergency preparedness and nuclear security, have been progressed. Especially, ‘risk analysis methodology’ and ‘design and operational management’ are the main categories of the field, in which more than half of published articles on Journal of Nuclear Science and Technology are related to these categories.     

Flame characteristics of premixed H2-air mixtures explosion venting in a spherical container through a duct

The explosion venting duct can effectively reduce the hazard degree of a gas explosion and conduct the venting energy to the safe area. To investigate the flame quantitative propagation law of explosion venting with a duct, the effects of hydrogen fraction and explosion venting duct length on jet flame propagation characteristics of premixed H₂-air mixtures were analyzed through experiment and simulation. The experiment results under initial conditions of room temperature and 1 atm show that when hydrogen fraction was high enough, part of the unburned hydrogen was mixed with air again to reach an ignitable concentration, resulting in the secondary combustion was easier produced and the duration of the secondary flame increased. With the increase of venting duct length, the flame front distance and propagation velocity increased. Meanwhile, the spatial distribution of pressure field and temperature field, and the propagation process and mechanism of the flame venting with a duct were analyzed using FLUENT software. The variation of the pressure wave and the pressure reflection oscillation law in the explosion venting duct was captured. Therefore, in the industrial explosion venting design with a duct, the hazard caused by the coupling of venting pressure and venting flame under different fractions should be considered comprehensively.     

杭州湾南岸滩涂沉积物中HCHs与DDTs污染特征分析

摘 要：目的 了解六六六（hexachlorocyclohexanes,HCHs）与滴滴涕(dichloro diphenyl trichloroethanes,DDTs)在杭州湾南岸滩涂沉积物中的污染现状。方法 于2018年4月，采集杭州湾南岸地区4个采样点不同深度（0~80 cm）滩涂沉积物，利用气相色谱-串联质谱法（gas chromatography tandem mass spectrometry, GC-MS/MS）测定了该区域中HCHs与DDTs的含量，对其分布规律进行分析，使用共识沉积物质量基准法对其生态学风险进行了评估。结果 所有样品中均检出，HCHs与DDTs含量分别为4.20~6.24 μg/kg与3.37~4.73 μg/kg，主要以β-HCH、δ-HCH以及DDE为主，其污染主要来源于历史性工业品，整体污染处于较低水平；20.3%的沉积物样品中DDEs含量以及28.1%的样品DDTs总量介于阈值效应浓度(threshold concentration, TECs) 和可能效应浓度(probable effect concentration, PECs)之间。结论 杭州湾南岸沉积物中HCHs与DDTs的污染处于较低水平，具有较小的生态学风险。     

Design and synthesis of side-chain optimized poly(2,6-dimethyl-1,4-phenylene oxide)-g-poly(styrene sulfonic acid) as proton exchange membrane for fuel cell applications: Balancing the water-resistance and the sulfonation degree

Side-chain optimized poly (2,6-dimethyl-1,4-phenylene oxide)-g-poly (styrene sulfonic acid) (PPO-g-PSSA) is designed with balanced water-resistance and sulfonation degree. The PPO-g-PSSA is synthesized by controlled atom-transfer radical polymerization (ATRP) from brominated poly (2,6-dimethyl-1,4-phenylene oxide) (PPO-xBr) and ethyl styrene-4-sulfonate and followed by hydrolysis. A series of PPO-g-PSSA are prepared possessing different bromination degree (x) of PPO-xBr and polymerization degree (m) of the side-chains and the water-resistances of the fabricated membranes are investigated. The results show that a PPO-g-PSSA at relatively low x (x < 0.2) and high m (m > 4) exhibits good balance between the water-resistance and the sulfonation degree. Namely, it displays suitable proton conductivity with compromised water-resistance. Moreover, a maximum ion exchange capacity (IEC) of 3.24 mmol g^?1 is reached without the sacrifice of water-resistance. In addition, PPO-g-0.08PSSA-13 and PPO-g-0.14PSSA-4 are chosen characterized by thermogravimetric analysis, proton conductivities and mechanical properties. At 90% RH, the optimized PPO-g-0.08PPSA-13 possesses a proton conductivity of 37.9 mS cm^?1 at 40 °C and 45.5 mS cm^?1 at 95 °C, respectively.     

A New NTRU-Type Public-Key Cryptosystem over the Binary Field

As the development of cloud computing and the convenience of wireless sensor netowrks, smart devices are widely used in daily life, but the security issues of the smart devices have not been well resolved. In this paper, we present a new NTRU-type public-key cryptosystem over the binary field. Specifically, the security of our scheme relies on the computational intractability of an unbalanced sparse polynomial ratio problem (DUSPR). Through theoretical analysis, we prove the correctness of our proposed cryptosystem. Furthermore, we implement our scheme using the NTL library, and conduct a group of experiments to evaluate the capabilities and consuming time of encryption and decryption. Our experiments result demonstrates that the NTRU-type public-key cryptosystem over the binary field is relatively practical and effective.     

Biologically Inspired Design of Context-Aware Smart Products

The rapid development of information and communication technologies (ICTs) and cyber–physical systems (CPSs) has paved the way for the increasing popularity of smart products. Context-awareness is an important facet of product smartness. Unlike artifacts, various bio-systems are naturally characterized by their extraordinary context-awareness. Biologically inspired design (BID) is one of the most commonly employed design strategies. However, few studies have examined the BID of context-aware smart products to date. This paper presents a structured design framework to support the BID of context-aware smart products. The meaning of context-awareness is defined from the perspective of product design. The framework is developed based on the theoretical foundations of the situated function–behavior–structure ontology. A structured design process is prescribed to leverage various biological inspirations in order to support different conceptual design activities, such as problem formulation, structure reformulation, behavior reformulation, and function reformulation. Some existing design methods and emerging design tools are incorporated into the framework. A case study is presented to showcase how this framework can be followed to redesign a robot vacuum cleaner and make it more context-aware.