Effect of temperature on mechanical behavior of AZ31 magnesium alloy

Strain rate sensitivity and tension/compression asymmetry of AZ31 magnesium alloy at different temperatures and strainrates were investigated.Both of mechanical behaviors are temperature dependent.Strain rate sensitivity increases with increasingtemperature.Thermally activated slip is the source of strain rate sensitivity.At the temperature below or near 373 K,strain ratesensitivity is very little.Tension/compression asymmetry in yielding decreases with increasing temperature.Twinning is the reasonof tension/compression asymmetry.At the temperature above or near 573 K,the material shows little tension/compressionasymmetry of the flow stress.     

结晶法净化湿法磷酸生产磷酸二氢钾研究

研究了三聚氰胺结晶法净化湿法磷酸复分解生产精细磷酸二氢钾工艺中磷酸三聚氰胺与氯化钾反应生产磷酸二氢钾的工艺条件。采用二次正交组合实验设计，对反应过程中反应温度，反应时间，搅拌速度，氯化钾用量，氯化钾初始浓度等诸因素的一次作用，二次作用及交互作用对五氧化二磷转化率的影响进行了研究，得到了适宜的工艺条件，所得磷酸二氢钾达到HG2321－91质量标准。     

Study of the copper leaching in the wet oxidation of phenol with CuO-based catalysts: Causes and effects

Catalytic wet oxidation of phenol as a model pollutant has been performed in a three phase fixed-bed reactor (FBR) by using a commercial catalyst based on copper oxide in order to analyze the variables affecting significantly the copper leaching. It has been found that temperature has an almost negligible influence in the range studied (70–160 °C). On the contrary, an important effect of the pH value was noticed. The copper leaching reduces when the pH of the solution fed to the reactor increases, being almost negligible at pH ≥ 5. Moreover, the composition of the reaction media also influences the leaching. Higher copper concentrations than those expected by the effect of the acid aqueous media have been measured in the reactor effluent when phenol, catechol, hydroquinone, p-benzoquinone and maleic acid are present in the reaction media. On the contrary, oxalic acid has a negative influence on the leaching, since it captures the copper in solution to form copper oxalate which precipitates on the catalyst surface. For a previously acidified medium, the acetic and formic acids do not have any other effect on the copper leaching. It has been also demonstrated that as copper in solution decreases, so does phenol conversion, because the homogeneous catalysis contributes significantly to the oxidation reactions even in fixed-bed reactors.     

PBX炸药细观损伤的实验研究

为研究PBX炸药在冲击作用下的物理损伤、化学损伤及成热的物理机制,采用炸药爆炸驱动隔板实验技术对PBX炸药进行了冲击压缩实验,回收炸药试样并对其不同位置处的断面形貌进行SEM分析.结果表明,随着冲击能量的增加,其温度效应的影响越来越显著,损伤模式从物理损伤向化学损伤过渡.这为XDT问题中的"热点"形成机制等研究提供了实验基础.     

高浓度难降解有机废水湿式氧化可行性研究

选择四种高浓度难降解有机废水,在2L高压间歇反应釜中,研究了湿式氧化效果与技术可行性。结果表明:从氧化的容易程度来看,乳化液废水>丙硫咪唑废水>甲胺磷废水>分散蓝废水;各废水湿式氧化后可生化性得到显著改善;Cu2+有不同程度的催化作用;甲胺磷废水和丙硫咪唑废水对不锈钢反应釜腐蚀严重,乳化液废水最适宜湿式氧化。反应温度显著影响废水湿式氧化效果,温度越高氧化率越高。     

漆酶改善分离木素和OCC纸浆特性的研究

应用漆酶处理纤维素酶分离酶解木素和OCC(Old corrugated containers)纸浆,结果表明:木素在漆酶处理过程中会发生降解,经漆酶处理后再经加热处理会使木素发生聚合,木素降解主要发生在高分子量木素部分,而聚合作用主要发生在低分子量木素之间;木素经漆酶处理后,酚羟基的含量略有增加,这是由于在漆酶处理木素的过程中,木素不但发生酚氧自由基的离域现象,而且还有高分子量的木素发生降解产生了新的酚羟基;经不同用量的漆酶处理的OCC纸浆手抄片的湿环压指数和湿抗指数与对照样相比均有明显提高,特别是漆酶用量为24 U/g时,湿环压指数达到4.1 N.m/g,提高了41%。经不同用量的漆酶处理的OCC纸浆干环压强度和干抗张强度与对照样相比略有提高,但提高的幅度不大。     

GRIP管混凝土组合结构压弯构件非线性全过程分析

本文应用细观力学、经典层板理论、平截面假定、FRP约束混凝土本构模型及数值积分对GFRP管混凝土组合结构压弯构件进行了非线性全过程分析。通过理论计算发现GFRP管混凝土组合结构能有效地提高构件的承载力，且构件具有良好的变形能力。FRP壳体参与承载且有效地约束混凝土的变形，显著提高核心混凝土强度和变形能力。文中讨论了轴压比、长细比、径厚比、混凝土强度等级、纵筋配筋率、铺层角变化对极限水平荷载和极限水平位移的影响，从而得到了一些有益的结论。     

混凝土冻融劣化后动态单轴抗压特性试验研究

为研究混凝土冻融循环后的动态力学性能,利用10 MN动静三轴仪对不同冻融劣化程度的混凝土在不同加载速率下进行单轴压缩试验,同时采集声发射数据分析试验过程中能量释放及损伤演化规律。最后,选用Weibull-Lognormal损伤本构模型,对试验数据进行拟合分析,并分析不同工况混凝土的损伤随应变的发展规律。研究结果表明:①相同冻融劣化程度时,随应变速率增加,峰值应力增大,峰值应变减小;冻融劣化程度会影响峰值应力的率敏感性;②在应变速率相同时,随冻融循环次数增加,峰值应力随之减小,峰值应变随之增大。③混凝土冻融劣化后应力应变关系峰前服从Weibull统计分布,峰后服从Lognormal统计分布。④在相同应变速率下,随着冻融循环次数的增加,混凝土的累计塑性应变整体呈增大趋势。     

湿法磷酸装置三废治理新进展

湿法磷酸装置排放的三废对环境危害较大 ,尤其是废水治理长期以来尚未得到全面控制。阐述了某新建的湿法磷酸装置从工艺流程上通盘考虑 ,采用多次串级利用 ,实现污水全封闭、零排放的流程 ,达到了由清到浊、由冷到热 ,多次利用、自身消化 ,实现平衡、避免污染的目的 ,并介绍了废气和废渣治理的新措施。指出应坚持精心操作和维护 ,巩固已取得的三废治理成果     

Composite sheets with biodegradable polymers and paper,the effect of paper strengthening agents on strength enhancement,and an evaluation of biodegradability

Composite sheets composed of biodegradable polymers (BP) and paper were prepared, and their physical and biodegradable properties were investigated. The paper sheets were soaked in BP emulsions and cured at 100°C for 20 min. The wet strength of composite sheets with the same basis weight increased significantly with increasing BP content, although dry strength increased only moderately. A 0.5% addition of a common wet paper‐strengthening agent, poly(amidoamine‐epichlorohydrin) (PAE) resin, enhanced the wet strength, which reached 9.3 MPa, of composite sheets consisting of a BP : paper ratio of 20 : 80. Further enhancement was achieved by the addition of polyvinylamines (PVAm). The wet tensile strength of composite sheets consisting of BP and paper (20 : 80) increased by 27% with the addition of 0.2% PVAm and 0.5% PAE, whereas it was enhanced by only 3–4% with the addition of 0.7% PAE. The biodegradability of the composite sheets was somewhat retarded by the addition of PAE and PVAm. However, a 90% weight loss was observed 60 days after placing composite sheet samples in soil. A similar weight loss was observed after 45 days for composites without additives and after 30 days for base paper alone. © 2005 Wiley Periodicals, Inc. J Appl Polym Sci 96: 861–866, 2005