氧化钨物理特征的测量

对铵钨青铜（ATB）、氢钨青铜（HTB），紫色氧化钨（TVO）和蓝色氧化钨（TBO）四种氧化钨粉的氮气吸附/脱附等温线数据的分析。可以得出其表面积，微孔体积，微孔分布，中孔体积，平均孔径和分数维数。吸附/脱附等温线数据的分析表明，TVO粉末具有最大的中孔体积，最小的微孔体积，最窄的孔径分布，最小的分数维数和最大的平均孔径，其有利于氢还原制取超细钨粉，而不利于掺杂工艺，HTB粉末具有最大的微孔体积，最宽的孔径分布，最高的分数维数和最小的平均孔径，对于掺杂工艺来说是有利的，ATB和ABO的上述参数界于TVO和HTB之间。结果表明，利用吸附/脱附等温线来研究氧化物的物理特征是一个很好的方法；在氧化钨用于氢还原工艺和掺杂工艺之前必须研究其物理特征。     

用菱锌矿制取轻质氧化锌的研究

介绍了以菱锌矿为原料生产轻质氧化锌的方法，论述了反应酸浓度，煅烧温度，溶液PH值对实验的影响，并对生产工艺条件进行了研究。其工艺流程是将粉碎后的菱锌矿进行循环酸浸，净化后再直接和碳化母液反应，经沉降后再煅烧分解为轻质氧化锌，产品质量符合国家标准，视比容大，活性强，成本低，经济效益显著。     

Study of Friction and Wear Performance of Zinc Dialkyldithiophosphate in the Presence of Trace Ketone

This study reports the influence of methyl isopropyl ketone on the tribological performance of zinc dialkyldithiophosphate. The lubricity and friction and wear tests of 500 SN neutral base stock oil containing zinc dialkyldithiophosphate with methyl isopropyl ketone were carried out by MQ-800 four-ball and MM-200 block-on-ring tribometers respectively. The experimental results show that methyl isopropyl ketone decreases the wear resistance and the load-carrying capacity of zinc dialkyldithiophosphate. The friction reduction of zinc dialkyldithiophosphate was lowered as well because of the addition of ketone. The friction and wear mechanism of zinc dialkyldithiophosphate with trace ketone was studied by optical microscopy IR, SEM, XPS and ferrography. The variations of the tribological performance of zinc dialkyldithiophosphate with ketone could be partly attributed to the decreases of active species, such as phosphorus and zinc, which are responsible for the formation of anti-wear films, on the rubbing surface due to the existence of ketone.     

The Synthesis of Sulfated Titanium Oxide Nanotubes

TiO₂ nanotubes can be prepared in gram quantities by treating anatase TiO₂ powder with concentrated NaOH solution. These TiO₂ nanotubes acquired strong acidity after being impregnated with sulfuric acid solution and calcined at 300 °C. The anatase TiO₂ powder used to prepare the nanotube did not catalyze the esterification between cyclohexanol and acetic acid, while sulfated TiO₂ nanotubes were very reactive toward the esterification reaction.     

Growth Stresses in the Oxide Scales on TiAl Alloys at 800 and 900°C

In the oxidation of TiAl alloys, the role of scale-growth stresses formed during oxidation has, thus far, been unknown. In the present paper the oxide-growth stresses were investigated by the deflection-test method in monofacial oxidation (DTMO) accompanied by acoustic-emission measurements. On unmodified surfaces the growth stresses are compressive and reach levels of around –100 MPa. At the same time, significant acoustic emission occurs indicating that even under isothermal conditions, stresses are relieved by a scale-cracking mechanism. For oxide scales on TiAl surfaces, which had been ion implanted with chlorine before oxidation, a very thin protective alumina layer is formed which, however, develops growth stresses in the range of several GPa, accompanied by intensive acoustic emission. In all stress–time curves, a dynamic situation is observed. This consists of phases of stress relief by scale microcracking and phases of stresses increase due to crack healing and further oxide growth. As a result, the level of stress as a function of oxidation time, is characterized by an oscillating course.     

C60辅助下ZnNiS光催化分解水制备氢气的研究

通过在光催化剂掺杂ZnS中加入球笼化合物富勒烯C60,提高了光催化水分解的效率.并采用气相色谱法跟踪反应,发现氢气释放量是未加C60时的4倍多.同时,对该催化反应的机理进行了初步的探讨.     

熔融碳酸盐燃料电池阴极材料的导电性

通过交流阻抗方法研究了熔融碳酸盐燃料电池阴极材料锂镍氧化物、锂钴氧化物和锂铁氧化物的导电性能。结果表明:锂镍氧化物电极的导电性最好,锂钴氧化物电极的导电性次之,锂铁氧化物电极的导电性最差;它们的导电性都随着温度的升高而按指数规律增加;在合成锂钴氧化物(或锂铁氧化物)的过程中,使Li2CO3轻微过量,可以提高锂钴氧化物(或锂铁氧化物)电极的导电性,而且在同一温度下,随着nLi∶nCo(或nLi∶nFe,摩尔比)值的增大,锂钴氧化物(或锂铁氧化物)电极的导电性显著增加。     

Relating catalyst structure and composition to the water–gas shift activity of Cu–Zn-based mixed-oxide catalysts

In order to investigate the effect of cerium oxide on Cu–Zn-based mixed-oxide catalysts four catalyst samples were characterized by means of XRD, in situ XANES and thermogravimetric analysis. The activity of the catalyst samples was tested for the forward water–gas shift reaction. Cerium oxide was found to increase the crystallinity of the ZnO phase indicating a segregation of the Cu and ZnO phases. The TOF of the water–gas shift reaction based on chemisorption data was found to be independent of composition and preparation conditions of the four catalyst samples. In contrast, the catalyst stability depends on composition and preparation conditions. Cerium oxide impregnated before calcination of the hydrotalcite-based Cu–Zn precursors leads to a more stable water–gas shift catalyst.     

介孔氧化铁对正辛醇乙氧基化反应的催化性能

以十二烷基磺酸钠为模板剂、乙二胺为碱性介质,将水热法合成的氧化铁/十二烷基磺酸钠复合中孔材料在550℃、空气气氛中煅烧10h,除去模板剂,得到介孔氧化铁。通过X射线衍射、氮气吸附-脱附方法对介孔氧化铁的晶体结构和表面物性进行表征。表征结果显示,煅烧后的介孔氧化铁具有典型的六方介孔的结构特征,平均孔径为5.4nm。将介孔氧化铁用于催化正辛醇乙氧基化反应,研究结果表明,升高反应温度和初始压力、增加催化剂用量,可加快环氧乙烷的反应速率,同时产物的相对分子质量分布较窄。当平均聚合度为6.5时,正辛醇聚氧乙烯醚相对分子质量分布的选择性系数达到21.1。     

Formation and electronic structure of interface

In the present work the formation of the interface between polycrystalline silver and thin films of titanium oxide was studied with photoelectron spectroscopy (XPS, UPS) and time-of-flight secondary ion mass spectrometry (TOF-SIMS). Titanium oxide was deposited stepwise on 100 nm thick silver films by reactive magnetron sputtering allowing to study the evolution of the interface formation process. The process involves two steps: formation of thin layer of silver oxide and subsequent growth of the TiO₂ film. For better understanding of the silver oxidation process, pure silver films were exposed to a low temperature Ar/O plasma for different time intervals providing a possibility to investigate early stages of the oxide film growth.