异丙苯在Cu-HMS分子筛上的催化氧化

以含Cu的中孔分子筛(Cu-HMS)为催化剂,研究异丙苯的催化氧化。研究发现,Cu-HMS催化剂的加入使异丙苯氧化的诱导期显著缩短。在75℃下,以Cu-HMS为催化剂,O2为氧化剂的纯异丙苯氧化反应,苯乙酮为主要副产物,反应的选择性和转化率都很高。当催化剂用量为1 5×10-4mol/ml时,反应8h后,异丙苯转化率为32 7%,目的产物的累积浓度(质量分数)为37 7%,选择性为99%;反应12h后,异丙苯转化率为42 4%,目的产物的累积浓度为46 3%,选择性为95 6%。     

高速往复式内燃机平衡轴低质量设计分析

分析了扇形和偏心圆两种平衡轴设计的要求以及平衡重低质量的设计原则。扇形平衡重半径及宽度应尽量大、夹角应尽量小。偏心圆平衡重的偏心圆半径应尽可能大 ,轴承半径应尽可能小。同样质量的扇形平衡重产生的平衡力比偏心圆平衡重要大。     

Comparison of inward and outward grown Pt modified aluminide diffusion coatings on a Ni based single crystal superalloy

Two commercial Pt modified aluminide coatings (RT22 and MDC150L) on the same single crystal Ni-based superalloy (CMSX-4) were studied by: scanning electron microscopy; transmission electron microscopy; energy dispersive X-ray spectrometry; and gravimetry. The RT22 coating is an inward grown coating (high activity), while MDC150L is produced by outward growth (low activity). Samples were oxidised in still laboratory air at 1050 °C for various times up to 2000 h. It was found that the outward grown coating produced a slower growing oxide that was more spallation resistant. Several possible reasons for this were identified including: coating purity; coating surface topography; and ductile to brittle transition temperature. The microstructural differences between the two coatings in the as-coated condition were investigated and the development of their microstructure during heat treatment was described. A model for coating growth during heat treatment was proposed.     

Preparation, Characterisation and Catalytic Behaviour of a New TeVMoO Crystalline Phase

TeM_xMo_1.7O mixed oxides (M = V and/or Nb; x = 0-1.7) have been prepared by calcination of the corresponding salts at 600 °C in an atmosphere of N₂. A new crystalline phase, with a Te/V/Mo atomic ratio of 1/0.2-1.5/1.7, has been isolated and characterised by XRD and IR spectroscopy. This phase is observed in the TeVMo or TeVNbMo mixed oxide but not in the TeNbMo mixed oxide. The new crystalline phase shows an XRD pattern similar to Sb₄Mo₁₀O₃₁ and probably corresponds to the M1 phase recently proposed by Aouine et al. (Chem. Commun. 1180, 2001) to be present in the active and selective MoVTeNbO catalysts. Although these catalysts present a very low activity in the propane oxidation, they are active and selective in the oxidation of propene to acrolein and/or acrylic acid. However, the product distribution depends on the catalyst composition. Acrolein or acrylic acid can be selectively obtained from propene on Nb-free or Nb-containing TeVMo catalysts, respectively. The presence of both V and Nb, in addition to Mo and Te, appears to be important in the formation of acrylic acid from propene.     

New Reaction Engineering Concepts for Selective Oxidation Reactions

In order to enhance product yields in selective oxidation reactions, numerous reaction engineering concepts are being studied worldwide. Periodic operation has been investigated for decades, yet its application is limited to a few examples, such as the butane oxidation after DuPont or reverse-flow reactors for VOC removal. The use of microchannel reactors is a younger field, but it has already yielded promising results for process optimization. Catalytic wall reactors have proved to be a helpful tool for kinetic studies. On the laboratory scale, membrane reactors have displayed favorable behavior in selective oxidation. The Na vapor-catalyzed dehydrogenation of methanol to formaldehyde is a final example of an unusual new concept for selective oxidation.     

间苯二酚的生产技术现状

介绍了间苯二酚的主要用途和国内外生产现状 ,并对主要的生产方法磺化法和氧化法从环境效应上进行了比较 ,对今后我国间苯二酚的生产发展提出了建议     

试论会计电算化系统的内部控制

阐述了会计电算化系统产生和发展对内产控制的影响，以及内部控制的实施方法。     

Quality of Crude Fish Oil Extracted from Herring Byproducts of Varying States of Freshness

ABSTRACT: Herring byproducts were stored at 2 and 15 °C for up to 72 h. Over time, significant increases of total volatile bases (TVB), histamine, putrescine, cadaverine, and tyramine were detected. However, only tyramine and TVB levels were temperature-dependent. The level of total polyunsaturated fatty acids (PUFAs) was constant. Longer byproducts storage gave rise to an oil with higher levels of free fatty acids, eicosapentaenoic acid (EPA), docosahexaenoic acid (DHA), and total PUFAs, while fluorescent compounds were lower. A higher storage temperature led to oil higher in α-tocopherol and EPA levels and lower in anisidine value. Surprisingly, the oil with the highest content of PUFAs was not produced from the freshest byproducts, and oil with low oxidation products can be extracted from stored byproducts.     

Rare earth oxides as carbon oxidation catalysts

The behavior of a number of rare earth oxides as catalysts for the oxidation of graphite in air has been investigated by the methods of thermal analysis. Of the oxides studied, only CeO₂ showed significant activity in accelerating the gasification of graphite by oxygen between 500 and 1000°C. Cerium salts, which decompose to a finely dispersed oxide phase at low temperatures, e.g. Ce (III) nitrate and ammonium Ce (IV) nitrate, were found to be very active catalysts. The catalytic effect may be due to a redox process involving the cyclic conversion of the oxide from the Ce (IV) to the Ce (III) oxidation state, or the oxide particles may provide sites for the dissociative chemisorption of oxygen.     

High Temperature Oxidation Behavior of La2O3-MosSi3/MoSi2 Composites

The oxidation behavior of 0. 8% La2O3- Mo5Si3/MoSi2 composites at 1200℃ in air was investigated. The results reveal that the oxidation resistance of the material with 0. 8% La2O3 and Mo5Si3 is impaired. The oxidation resistance is decreased with increasing Mo5Si3 content. The mass loss follows a linear law in the initial oxidation. With oxidation time prolonging, a continuous and dense oxidation scale prevents oxygen from diffusing increasing when and leads to mass change a Mo5Si3 content is less than 30%. However, the composite shows ＂PEST＂ with the addition of 40% Mo5Si3. With increasing Mo5Si3 content, the oxidation resistance of 0.8% La2O3- Mo5Si3/MoSi2 decreases. This attributes to the poor oxidation resistance of M05Si3 and the relative density decreasing of 0. 8% La2O3-Mo5Si3/MoSi2 composite.