4-(6′甲基苯并噻唑-2′-偶氮)-3,5-二氨基吡唑与钯显色反应的研究和应用

对6种苯并噻唑偶氮吡唑化合物的分析特性进行了探讨,着重研究了4—(6′—甲基苯并噻唑-2′-偶氮)-3,5-二氨基吡唑(MBTAP)与钯离子显色反应的光度性质。在非离子表面活性剂 Brij35存在下与钯离子形成橙红色的配合物。适宜的 pH 值范围为9.0～10.5.配合物的最大吸收波长为510nm,表观摩尔吸光系数为3.01×10~4L·mol~(-1)·cm~(-1)。钯在0～14μg/25mL,范围内服从比尔定律.显色体系可稳定11h。在柠檬酸存在下可消除 Fe~(3+)、Co~(2+)、Cu~(2+)、Ni~(2+)等离子的干扰。     

碳纤维经氧等离子/KH550处理后的表面形态和结构

碳纤维(CF)表面经氧等离子、KH550和 LiAlH_4处理后,其物理和化学性能得以改善.由于提高了 CF 和树脂间的联结,使 CF 复合材料的层间剪切强度提高50%以上,在湿热下的强度保留率达94%以上.使用纤维接触角测定仪,SEM 和 XPS 等对 CF 表面的浸润性、形态和化学组成进行了研究.实验指出:CF 经等离子和 KH550处理后,其临界表面能有了提高;CF 本身仅受氧离子刻蚀,故其拉伸强度的损失小于其他处理方法.     

Effect of excess boron fertilization on status and availability of boron in calcareous soils

Field experiments were conducted at Al-Qatif area in the eastern region of Saudi Arabia to study the status and availability of B under B fertilization regime in three types of calcareous soils and to evaluate the response of two alfalfa varieties, Hassawi (local variety) and Hyden (american variety), to increasing levels of added B.Boron was applied at 7 rates as Na₂B₄O₇.10H₂O. Four cuttings were taken from each site at different intervals. Data showed that extractable B by hot-water and NH₄HCO₃-DTPA (8 days after borax application) was significantly (p <0.001) affected by soil type and B applications. The amount of B recovered by hot-water from the three soils, 200 days after borax application, was in the following order: sandy loam > sandy clay loam > clay loam.Total dry matter of alfalfa (4 cuttings) was significantly (p <0.05) affected by soil type, borax application rates and alfalfa variety.The critical level of B in plant as determined by Cate and Nelson analysis, ranged from 148 to 652 mg kg^–1 dry matter for Hassawi cultivar and 138 to 521 mg kg^–1 for Hyden cultivar in the first harvest. However, the upper critical levels for the 2nd, 3rd and 4th harvests were 800, 875 and 935 mg B kg^–1 dry matter for Hassawi and 603, 723 and 812 mg B kg^–1 for Hyden varieties, respectively. Nevertheless, the lower critical levels for 2nd, 3rd and 4th harvests ranged from 148 to 153 mg B kg^–1 dry matter for Hassawi and 138 to 142 mg B kg^–1 for Hyden.     

Kinetics for benzoylation of sodium 4-acetylphenoxide via third-liquid phase in the phase-transfer catalysis

In this research, the kinetics for synthesizing 4-acetylphenyl benzoate (R^*COOR) from benzoylation of sodium 4-acetylphenoxide via third-liquid phase-transfer catalysis was investigated. The reaction rate was observed to be strongly dependent on agitation speeds in the third-phase catalytic reaction. By forming the third-liquid phase, the observed reaction can be greatly enhanced to give a product yield of 100% in a duration of 3 min at 20 °C and 200 rpm. If a third-liquid phase was not formed in the liquid–liquid system, the reaction rate is very slow and the product yield is only 2% in 3 min at 20 °C. The reaction conducted in third-liquid phase-transfer catalytic system is faster than that in LLPTC system by 25–28 times. The amount of catalytic intermediate (QOR) in the third-liquid phase was about 50% of the catalyst initially added and kept about 30% of it remained after 1 min, and only small amounts of a catalytic intermediate residing in the organic phase were observed during the reaction using methyl t-butyl ether as the solvent. The concentration of catalytic intermediate slightly decreased with increasing reaction time, while the molar ratio of QOR to benzyl tri-n-butylammonium cation in the third-liquid phase remained almost constant after 1 min and increased with increasing agitation speeds. The experimental results were well described by the pseudo-first-order kinetics. The present work shows an effective method to synthesize 4-acetylphenyl benzoate.     

SiC晶须对Si3N4陶瓷基复合材料机械强度的影响

制备了含10vol％,20vol％及30vol％SiC晶须的Si_3N_4基复合材料,对其室温及高温机械强度的测试研究表明,SiC晶须对基体的高温机械性能有明显的增强作用。含20vol％SiC晶须的复合材料1200℃下强度达780MPa,比基体材料提高50％。通过SEM和TEM研究,讨论了SiC晶须增强的原因。     

Coking kinetics of a Cr2O3/Al2O3 catalyst during 1-butene dehydrogenation: Effect of H2 partial pressure

The influence has been studied of the partial pressure of hydrogen (0–30 kPa) upon the coking rate of a Cr₂O₃/Al₂O₃ commercial catalyst during 1-butene dehydrogenation. Coke deposition has been analysed using a monolayer-multilayer reversible coke growth model (MMRC model). This model provides good fits to the experimental data, within the range of partial pressure of H₂ studied, and allows us to estimate the main kinetic parameters involved in the coking-deactivation process. The results obtained reveal a dual effect of hydrogen: competition against 1-butene for the active sites and the removal of coke precursors from the catalyst surface. Bom effects diminish the coking rate as the H₂ partial pressure is increased.     

洗涤剂用4A沸石工业的回顾及展望

4A沸石具有软化水质的作用，是全球公认的优良的代磷助剂。介绍了洗涤剂用4A沸石在世界各地的发展历程和现状，指出了国际洗涤剂用4A沸石的发展趋势，并就国内洗涤剂用4A沸石提出了发展建议。