二烷基硫代磷酸铵的捕收性能

本文研究了二烷基硫代磷酸铵（ＲＯ）２ＰＳＯＮＨ４（Ｒ＝乙基、丁基、己基、烯丙烯）系列捕收剂对非硫化矿孔雀石、锡石、赤铁矿、白铅矿、方解石和菱锌矿的浮选性能，并就药剂结构与性能关系进行了分析讨论．     

松香及其衍生物在浮选分离中的应用

介绍了松香的来源、化学组成及理化性质；讨论了松香及其衍生物在非硫化物矿浮选分离、有色金属离子的浮选分离以及从水溶液中浮选分离有机物等方面的应用情况。     

异形柱柱头混凝土连续托梁分次置换技术

通过某工程异形柱头混凝土置换实例,介绍了连续托梁分次置换技术的设计计算、施工方法和技术措施等。     

n-Al2O3/Ni复合镀层的组织与滑动磨损性能研究

用电刷镀技术制得了镍基n-Al2O3复合镀层，并对镀层的滑动磨损性能进行了试验研究。纳米复合镀层的表面形貌比较细腻，镀层中纳米粒子分布均匀，与基质金属结合紧密。镀层显微硬度达到HV700，比快速镍镀层提高约40％。滑动磨损试验结果表明，随着纳米粒子含量的增大，镀层的耐磨性提高，摩擦系数也呈增大趋势；但当镀层中n-Al2O3粒子的超过2.56%(质量分数）时，镀层的耐磨性显著下降。纳米复合镀层的磨损机制以疲劳磨损为主，而快速镍底层以粘着磨损为主。     

Split and collectorless flotation to medium coking coal fines for multi-product zero waste concept

The medium coking coal fines of − 0.5 mm from Jharia coal field were taken for this investigation. The release analysis of the composite coal reveals that yield is very low at 10.0% ash, about 25% at 14% ash and 50% at 17% ash level. The low yield is caused by the presence of high ash finer fraction. The size-wise ash analysis of − 0.5 mm coal indicated that − 0.5 + 0.15 mm fraction contains less ash than − 0.15 mm fraction. Thus, the composite feed was split into − 0.5 + 0.15 mm and − 0.15 mm fractions and subjected to flotation separately. The low ash bearing fraction (− 0.5 + 0.15 mm) was subjected to two stages collectorless flotation to achieve the concentrate with 10% ash. The cleaner concentrate (18.9%) with 10% ash was recovered which has an application in metallurgical industries. The concentrate of 30.2% yield with 12.5% ash could be achieved in one stage collectorless flotation which is suitable for use in coke making as sweetener. As the − 0.15 mm fraction contains relatively high ash, collector aided flotation using sodium silicate was performed to get a concentrate of 23.6% yield with about 17% ash. The blending of this product with cleaner tail obtained from − 0.5 + 0.15 mm produces about 35.0% yield with 17% ash and that can be utilized for coke making. The reject from the two fractions can be used for conventional thermal power plant or cement industries using a 23.5% ash after one stage collector aided flotation and the final tailings produced content ash of 61.6% can be used for fluidization combustion bed (FBC). This eventually leads to complete utilization of coal.     

应用硫酸铵提高乌拉嗄金矿石浮选回收率试验研究

经试验发现应用一种化学肥料硫酸铵可以显著提高乌拉嘎金矿石的浮选回收率。闭路试验尾矿工艺矿物学鉴定证明，以硫酸铵作为调整剂的浮选过程中，微细粒单体金和金与石英边生体被有效回收。     

转向柱管承载能力的试验研究

在分析转向柱管花键部位应力集中情况的基础上,通过对某厂生产的转向柱管扭转破坏的试验研究,得到如下结论:①转向柱管的承载能力与其外花键齿与方向盘中心内花键齿之间的非接触区长度有关,以花键端部过渡圆弧的直径大小为宜;②安装方向盘总成时所施加在安装螺母上的拧紧力矩在70N.m左右时,转向柱管的承载能力最大。     

精馏塔静态仿真：Ⅰ.静动态混合数学模型的应用

本文为了克服精馏塔静态仿真不易收敛和初值难以给定等难题，巧妙地利用隐含数值积分方法的特点，将稳态与动态数学模型耦合起来，用以求解高难度的非理想精馏塔静态仿真问题。所得静动态混俣模型大大提高了精馏塔静态仿真的鲁棒性，对于高度非理想精馏塔的仿真尤为有效。通过对某丙烯腈萃取精馏塔的静态仿真，充分证明了这种混合模型化方法的可行性。     

The Lazy Cook Problem, or Scheduling Two Parallel Machines to Optimize Vehicle Utilization

A cook has to prepare n cakes using an oven with two racks. According to the recipe, the i-th cake has to be baked for exactly a _i minutes. Cakes to be cooked are taken from a table and carried to the oven, and once cooked are carried back to the table by means of a trolley that can carry two cakes at a time. What is the minimum number q ^* of round trips required of the cook? This problem has application to the operation scheduling of transportation systems and to material cutting. A different problem arises according to whether the cook accepts or not to stay near the oven for awhile with the trolley. If the trolley cannot be idle at the oven, an optimum schedule with no oven idle-time always exists: consequently, the trolley schedule is trivial, and the problem is transformed into a set packing. For this case, we propose and test a heuristic method which generates all of the promising columns of the set packing, and solves the resulting problem by branch-and-bound. Instead, if the trolley can be idle at the oven for a limited amount of time, a problem arises to find an optimal schedule of the trolley: in this case we show how to use a scaling technique in order to obtain a very good feasible solution by the method above.     

活性炭单柱提取肌苷新技术研究

活性炭单柱提取肌苷新技术研究李永泉，张进，姚恕，郑莲英，俞峰（杭州大学生物系杭州３１００２８）（浙江大学化工系杭州３１００２７）关键词：肌苷，提取技术，活性炭单柱１前言目前，国内肌苷发酵后处理工艺落后，在分离提取工序中肌苷损失严重，收率一般只有５０％...