离子交换法合成三氨基胍叠氮酸盐

三氨基胍叠氮酸（ＴＡＺ）分子中的含氮量高达８５．７％，燃烧分解时不仅－Ｎ３可释放３６７ｋＪ／ｍｏｌ的键能，而且放出大量的氮气，是一个提高比冲，降低燃烧温度的理想的推进剂两组分之一。     

含氟苯胺树脂的合成及其用于环氧树脂固化研究

通过邻三氟甲基苯胺与甲醛缩合，合成了一系列不同胺值的含氟苯胺树脂。将含氟苯胺树脂作为环氧树脂的固化剂，组成含氟环氧树脂体系。通过ＤＳＣ分析，确定了体系的固体条件，测定了含氟树脂体系的表面疏水角、介电损耗及干湿态的体积电阻。结果表明，所合成的含氟环氧体系，具有优良的表面疏水性及湿态电性能，已成功用于防雨防潮绝缘工具     

LiMn2O4纳米粉的湿化学合成与表征

采用湿化学方法，通过水溶液中的化学反应直接合成纳米级LiMn2O4化合物，其结构基本上为无定型，但XRD图谱中已出现LiMn2O4特征峰，说明在水溶液中已初步形成尖晶石结构，运用XRD，SEM，TG－DTA等现代检测手段对样品的性能进行进行了表征，XRD及SEM等分析结果表明，合成样品经简单热处理后，晶型结构完善，形貌规整，均匀，比表面积积显著减小，粒度明显变粗。TG－DTA热分析证明，样品在低于900℃的温度下进行热处理时，仅发生LiMn2O4的晶化过程，产物的化学组成稳定，该法合成锂离子电池正极材料LiMn2O4，具有工艺流程简单，产物的成分，结构及粒度均匀等特点。     

微波高压提取快速测定饲料含氟量的探讨

采用微波高压制样技术,快速提取饲料中的氟元素,结合氟离子选择性电极标准添加和电位极差测试方法,能够快速、准确地测试饲料中的含氟量     

High concentration erbium doping of silicon-rich SiO2 thin films on silicon

In this work, high concentration erbium doping in silicon-rich SiO₂ thin films is demonstrated. Si plus Er dual-implanted thermal SiO₂ thin films on Si substrates have been fabricated by using a new method, the metal vapor vacuum arc ion source implantation with relatively low ion energy, strong flux and very high dose. X-Ray photoelectron spectroscopy measurement shows that very high Er concentrations on the surfaces of the samples, corresponding to 10 at.% or the doping level of 10²¹ atoms cm⁻³, are achieved. This value is much higher than that obtained by using other fabrication methods such as the high-energy ion implantation and molecular beam epitaxy. Reflective high-energy electron diffraction, atomic force microscopy and cross-section high-resolution transmission electron microscopy observations show that the excess Si atoms in SiO₂ matrix accumulate to form Si clusters and then crystallize gradually into Si nanoparticles embedded in SiO₂ films during dual-ion implantation followed by rapid thermal annealing. Er segregation and precipitates are not formed. Photoluminescence at the wavelength of 1.54 μm exhibits very weak temperature dependence due to the introduction of Si nanocrystals into the SiO₂ matrix. The 1.54-μm light emission signals from annealed samples decrease by less than a factor of 2 when the measuring temperature increases from 77 K to room temperature.     

Study of Lateral Spread of Ions Emitted from 2.3 kJ Plasma Focus with Hydrogen and Nitrogen Gases

The characteristics of ion beams of hydrogen and nitrogen with different filling pressures emitted from the plasma focus device of 2.3 kJ energy are investigated. CR-39 SSNTDs are employed for the registration of tracks of ions. The exposed detectors are etched in 6N NaOH solution at 70°C and then examined with an optical microscope. The ion flux is estimated to be of the order of 10^5–6 tracks/cm². The flux with the radial position does not exhibit any regular pattern of variation.     

SMF-425树脂吸附和解吸铼的研究

研究了SMF-425型阴离子交换树脂在弱酸体系中吸附、解吸铼的性能和机理，结果表明，[H^ ]在0.1～1.0mol/L范围内，对铼的吸附有利，吸附平衡服从Freundish吸附等温式，吸附反应吸热，温度越高越有利于吸附。每g干树脂对铼的静态和动态饱和吸附容量分别为169.31mg、175.43mg。用2mol/L硫氰酸铵作淋洗剂，流速为2mL/min时，淋洗效果较好，结果令人满意。     

抽余C_4烃中异丁烯催化逆流水合制叔丁醇

采用大颗粒离子交换树脂催化剂,在φ100mm×10m的反应器中进行了异丁烯催化逆流水合制叔丁醇的中间试验。考察了反应温度、水油体积比和抽余C4烃的流速等对异丁烯转化率的影响。试验结果表明,异丁烯催化逆流水合制叔丁醇的适宜操作条件为:反应温度80~90℃,水油体积比为4~5,抽余C4烃的流速为0.45~0.55mm/s。在此条件下,异丁烯的转化率可达88.8%。工业装置运转结果表明,异丁烯转化率大于75%。     

NdFeB水磁体表面离子镀Cu-Al-In三元仿金

分析了真空离子镀的基本原理，研究了NbFeB永磁合金表面离子镀Cu－Al-In三元仿金合金的新工艺。合金镀层晶粒较小，均匀美观，光泽柔和；合理的工艺条件为：偏压200V，主弧电流5A±0．25A，间距120mm，加热功率11kW，氩气分压1．33Pa～0．0133Pa，时间30min。     

内热式液态合金离子源

本文介绍了一种实用的液态合金离子源结构，我们利用本结构研制成功了Ａｕ－Ｓｉ和Ａｕ－Ｓｉ－Ｂｅ液态合金离子源，测出了它们的发射特性。