Au/ZnO and Au/Fe2O3 catalysts for CO oxidation at ambient temperature: comments on the effect of synthesis conditions on the preparation of high activity catalysts prepared by coprecipitation

The preparation of Au/ZnO and Au/Fe₂O₃ catalysts using two coprecipitation methods is investigated to determine the important factors that control the synthesis of high activity catalysts for the oxidation of carbon monoxide at ambient temperature. In particular, the factors involved in the preparation of catalysts that are active without the need for a calcination step are evaluated. The two preparation methods differ in the manner in which the pH is controlled during the precipitation, either constant pH throughout or variable pH in which the pH is raised from an initial low value to a defined end point. Non-calcined Au/ZnO catalysts prepared using both methods are very sensitive to pH and ageing time, and catalysts prepared at a maximum pH = 5 with a short ageing time (ca. 0–3 h) exhibit high activity. Catalysts prepared at higher pH give lower activity. However, all catalysts require a short operation period during which the oxidation activity increases. In contrast, the calcined catalysts are not particularly sensitive to the preparation conditions. Non-calcined Au/Fe₂O₃ catalysts exhibit high activity when prepared at pH ≥ 5. Calcined Au/Fe₂O₃ prepared using the controlled pH method retain high activity, whereas calcined catalysts prepared using the variable pH method are inactive. The study shows the immense sensitivity of the catalyst performance to the preparation methods. It is therefore not surprising that marked differences in the performance of supported Au catalysts for CO oxidation that are apparent in the extensive literature on this subject, particularly the effect of calcination, can be expected if the preparation parameters are not carefully controlled and reported.     

0.91Pb(Zn1/3Nb2/3)O3-0.09PbTiO3的析晶行为及助溶剂法生长

研究了0.91Pb(znl/3Nb2/3)O3-0.09PbTiO3(PZNT91/9,摩尔分数)在不同组分和配比熔盐中的析晶行为及其对晶体生长的影响。发现B2O3,PbF2等助溶剂不利于钙钛矿相的析出;而BaTiO3-PbO复合体系虽然能够促进钙钛矿相析出,但晶体析出量很少;只有适当比例的。PbO助溶剂比较适合于生长具有铁电性的钙钛矿相PZNT91/9单晶。助溶剂法生长的工艺参数为:溶质与PbO助溶剂的摩尔比为l:l,泡料温度1 150-1 200℃,泡料时间10 h,晶体生长时降温速度0.8-2℃/h,当温度降到900℃时停止生长,以50℃/h快速冷却至室温。所得晶体为琥珀色,最大尺寸达φ30 mm×15 mm,其压电系数和机电偶合系数分别为2000 pc/N和0.92。     

ZnO-P2O5-H2O反应体系磷酸锌颜料的防锈活性研究

采用X—ray、FT—IR、TEM硬化学分析等手段测定了ZnO—P2O5-H2O反应体系制备的磷酸锌防锈颜料的组成、结晶水、粒度分布、颗粒形貌、溶解性、润湿角、比表面积，及其在醇酸树脂中的分散性，研究其化学物理性质。结果表明：该法生产的磷酸锌含有16％未反应的氧化锌，颗粒粗大呈砖形，大部分分布在15～45μm之间；其比表面积较小，在水中溶解度小，离解程度低，在中性介质中表现为一种惰性颜料；磷酸锌在水和有机溶剂中均可润湿，但很快发生沉淀，分散性欠理想。     

Ce:Nd:ZnWO4激光晶体的生长及其光谱性能

采用提拉法生长出光学质量的Nd:ZnWO4,Ce:ZnWO4和Ce:Nd:ZnWO4晶体.通过X射线衍射仪对晶体样品的微观结构进行了分析.测试了晶体的吸收光谱、电感耦合等离子体原子发射光谱和荧光光谱.根据Judd-Ofelt理论计算出Nd:ZnWO4晶体中Nd3 的强度参数为:Ω2=6.820 2×10-20 cm2,Ω4=0.463 3×10-20 cm2,Ω6=0.443 5×10-20 cm2.研究了Ce3 和Nd3 之间的能量转移现象.结果表明:Nd3 在850 nm激发时产生上转换发射峰位于474 nm和572 nm处,分别对应于2G9/2,4K13/2到基态能级4I9/2跃迁,计算出该峰的自发辐射几率为1 360 s-1,荧光寿命为7.353×10-4 s,发射截面为0.905 9×10-23 cm2.     

氧化锌对高胶凝性水泥熟料矿物形成及强度的影响

采用工业原料配料，对以硅酸三钙（C3S，C=CaO，S=SiO2）、硫铝酸钙（C4A3 S^-，C=CaO，A=Al2O3，S^-=SO4^2-）为主导矿物的含C4A3 S^-矿物硅酸盐水泥熟料的矿物形成及其强度进行了研究。借助X射线衍射和热重一差热分析研究了矿物形成过程；探讨了微量元素ZnO对熟料性能的影响及在熟料体系中的固溶情况。研究结果表明：生料中掺入ZnO可使C4A3 S^-和CaS等矿物通过低温反应形成，共存于同一熟料体系中，并可提高熟料的强度；过高的ZnO含量亦会降低C4A3 S^-矿物的分解温度。     

ZnO微／纳米纤维的静电纺丝及其表征

以聚乙烯吡咯烷酮(PVP)为络合剂与醋酸锌[Zn(CH3COO)2]反应制得前驱体溶液,用静电纺丝法制备了PVP／Zn(CH3COO)2纤维,经煅烧得到具有微孔结构的氧化锌(ZnO)微／纳米纤维。对所制备纤维分别采用差热-热重分析、红外光谱分析、X射线衍射分析、扫描电镜等手段进行了表征。结果表明: PVP/Zn(CH3COO)纤维表面光滑,直径约300-700 nm,经700℃煅烧后,可得到ZnO微／纳米纤维。     

锌系工件的静电粉末涂装和工艺管理

讨论了锌系工件喷涂的相关工艺、现场管理、技术参数、质量检验和环境要求等。     

Admittance—Frequency Response in Zinc Oxide Varistor Ceramics

The lumped parameter/complex plane analysis technique revealed several contributions to the terminal admittance of the ZnO—Bi₂O₃ based varistor grain-boundary ac response. The terminal capacitance has been elucidated via the multiple trapping phenomena, a barrier layer polarization, and a resonance effect in the frequency range 10⁻²≤ f ≤ 10⁹ Hz. The characterization of the trapping relaxation behavior near ∼ 10⁵ Hz (∼ 10⁻⁶ s) provided a better understanding of a previously reported loss-peak. The possible nonuniformity in this trapping activity associated with its conductance term observed via the depression angle of a semicircular relaxation in the complex capacitance ( C *) plane has been postulated.     

弱酸性铵盐与碱性锌酸盐双缸套镀锌工艺及低铬钝化

总结了弱酸性链盐镀锌和碱性锌酸盐镀锌的优缺点，并综合两者的优点，提出了一种弱酸性铵盐与碱性锌酸盐双缸套镀锌工艺。钝化膜的性能得到了改善。     

锌精矿制酸三级旋风除尘器的设计与实践

介绍了锌精矿制酸系统采用三级旋风除尘器替代电除尘器的设计及运行情况。为了提高旋风除尘器的除尘效率，硫酸系统各工序作了适当调整。运行实践表明，三级旋风除尘器除尘效果良好，硫酸系统能长期稳定运行。