Physicochemical characteristics and leachability of scale and sludge from Bulalo geothermal system, Philippines

Scale and sludge from Bulalo geothermal field, Philippines, have been characterized by whole rock analysis, radioactivity counting, size analysis, light microscopy, scanning electron microscopy, and X-ray diffraction. Their leachability was assessed by regulatory leaching procedures and by sequential extraction. Both scale and sludge consisted mostly of oxides of Si, Al, and Fe with no radionuclides detected. The scale had 10% S content. Sulfides and silicates were important phases in both samples having size ranges from submicron to 2 mm. Geothermal soils at Bulalo have higher than normal soil levels of As, S, Cu, Cr, Zn, and Pb but regulatory leaching tests indicated that these elements are not released. However, the sequential extraction showed that As, Cu, and Zn were leachable under extreme conditions.     

Partial scan design and test sequence generation based on reduced scan shift method

This paper presents a partial scan algorithm, calledPARES (PartialscanAlgorithm based onREduced Scan shift), for designing partial scan circuits. PARES is based on the reduced scan shift that has been previously proposed for generating short test sequences for full scan circuits. In the reduced scan shift method, one determines proch FFs must be controlled and observed for each test vector. According to the results of similar analysis, PARES selects these FFs that must be controlled or observed for a large number of test vectors, as scanned FFs. Short test sequences are generated by reducing scan shift operations using a static test compaction method. To minimize the loss of fault coverage, the order of test vectors is so determined that the unscanned FFs are in the state required by the next test vector. If there are any faults undetected yet by a test sequence derived from the test vectors, then PARES uses a sequential circuit test generator to detect the faults. Experimental results for ISCAS'89 benchmark circuits are given to demonstrate the effectiveness of PARES.     

液压随动系统在线监测与故障诊断系统

介绍了集随动系统在线监测与故障诊断于一体的智能系统。利用基于知识的诊断推理技术与神经网络技术相结合的方法构建了随动系统在线故障诊断专家系统，使得神经网络推理与基于符号的知识诊断控制、解释有机地结合起来，取长补短，大大提高了系统的工作效率和诊断可靠性。     

Test Generation for Crosstalk-Induced Faults: Framework and Computational Results

Due to technology scaling and increasing clock frequency, problems due to noise effects lead to an increase in design/debugging efforts and a decrease in circuit performance. This paper addresses the problem of efficiently and accurately generating two-vector tests for crosstalk induced effects, such as pulses, signal speedup and slowdown, in digital combinational circuits. These noise effects can propagate through a circuit and create a logic error in a latch or at a primary output. We have developed a mixed-signal test generator, called XGEN, that incorporates classical static values as well as dynamic signals such as transitions and pulses, and timing information such as signal arrival times, rise/fall times, and gate delay. In this paper we first discuss the general framework of the test generation algorithm followed by computational results. Comparison of results with SPICE simulations confirms the accuracy of this approach.     

赵41断块干扰试井资料分析

对晋县凹陷41断块油田采用小直径电子压力计试井新技术，成功地进行了干扰试井。通过对观察井、激动井所得试井资料的详细分析、评价，证实了干扰井组中各井间地层的连通性，为下一步实施注水开发提供了可靠的依据。同时，进行了地层产能的分析，做出了产能预测，认为随着原油流度、产能的降低，整个断块油藏产量将快速递减。因此，提出要对油藏及时补充能量，并采取原油降粘措施等建议。     

The chloride stress-corrosion cracking behavior of stainless steels under different test methods

Chloride-induced stress-corrosion cracking (SCC) is one of the failure modes of stainless steels. Highly alloyed austenitic stainless steels S32654, S31254, and N08028, and duplex grades S32750 and S31803 possess much improved resistance to SCC compared with S30400 and S31600 steels. With the development of a database, SSData, experimental data collected from calcium chloride tests, autoclave tests, and drop evaporation tests were evaluated. Stress-corrosion cracking data generated by autoclave tests agreed well with the practical service conditions and can be used to discriminate alloys for SCC resistance in sodium chloride solution. Drop evaporation test data can be used in situations where evaporation may occur and cyclic loading may be involved. The SCC resistance of alloys under each method increased with increasing molybdenum equivalent Mo + 0.25Cr + 0.1Ni. For a given alloy, the testing result depends on the stress state and environment; different test methods can give different ranking orders concerning SCC resistance. The performance of duplex stainless steels in a chloride-containing environment at higher temperatures was not as good as expected when dynamic loading was involved.     

特超稠油污水回掺降粘集输工艺

通过对河南古城油田BQ10区特超稠油乳状液的室内试验分析,指出该种乳状液的实际相突变点为68%左右,当相浓度Φ≥68%时,以W/O型为主的乳状液突变为以O/W型为主的乳状液.乳状液变型后,原油与管道内壁之间的摩擦以及原油之间的摩擦转变为水与管道内壁及水与水之间的摩擦,从而大幅度降低其粘度和摩阻损失;通过对古城BQ10区特超稠油区块单元内部污水回掺降粘集输的现场试验,证明与室内试验分析得出的结论相符合,说明区块单元污水回掺不同于常规的掺热水,也不同于掺联合站处理过的净化污水,它优于单井掺稀油.最后指出该工艺可有效地降低井站回压,方便生产管理,降低开采成本,提高采油效率和经济效益,具有低耗节能的优点.     

电力变压器局放超声传感器及其应用

作者研制成一种带光纤的电力变压器局放超声PZT传感器.文中分析了它的灵敏度与宽频带特性,介绍了原理、结构设计、实验数据及现场成功实例.理论与实验研究表明:具有这种高灵敏传感器的超声定位系统是确定电力变压器绝缘故障部位的一种方法.     

On the Yustova threshold plates

A response to criticism of threshold plates for the study of color vision developed at the Mendeleev All-Russia Research Institute of Metrology and published in 1994 is presented. The critics base their conclusions on colorimetric testing and the examination of the plates. In response to the article by M. V. Danilova and J. D. Mollon [4]. __________ Translated from Izmeritel’naya Tekhnika, No. 1, pp. 37–39, January, 2007.     

低浓度CO合成甲酸甲酯中试研究

进行了低浓度CO合成甲酸甲酯的中试研究,探讨了温度、压力、流速、催化剂浓度等因素对反应的影响,在优化条件下考察了系统的稳定性。结果表明,低浓度CO(体积分数15%)合成甲酸甲酯CO的单程转化率达到50%以上,粗品中甲酸甲酯含量达到7%～9%,可以满足工业浓缩要求,且整个合成系统未发生母液堵塞的问题,与高浓度CO羰基合成甲酸甲酯相比,单位生产成本可降低30%,具有良好的技术先进性。