Graft copolymerization of methyl methacrylate onto cellulosic biofibers

In this article, we have used the potassium persulfate to initiate the graft copolymerization of methyl methacrylate onto cellulosic biofibers in aqueous medium. Different reaction parameters, such as reaction time, initiator molar ratio, monomer concentration, amount of solvent, and reaction temperature, were optimized to get the maximum percentage of grafting (50.93%). The graft copolymers thus formed were characterized by Fourier transform infrared, scanning electron microscopy, X‐ray diffraction, and thermogravimetric, differential thermal analysis, and derivative thermogravimetric techniques. A mechanism is proposed to explain the generation of radicals and the initiation of graft copolymerization reactions. On grafting, percentage crystallinity decreases with reduction in its stiffness and hardness. The effect of grafting percentage on the physicochemical properties of raw as well as grafted fibers has also been investigated. The graft copolymers have been found to be more moisture resistant and also showed better chemical and thermal resistance. © 2011 Wiley Periodicals, Inc. J Appl Polym Sci, 2011.     

催化动力学光度法测定痕量钒(Ⅴ)的研究

研究了在 p H=4及没食子酸存在下 ,微量钒 ( )催化溴酸钾氧化邻苯二胺的动力学条件 ,建立了催化动力学光度法测定痕量钒 ( )的新方法。方法的测定范围为 0～ 0 .0 2 5 μg· 2 5 m L- 1 ,检出限为 1.18× 10 - 6 g·L- 1 ,相对标准偏差为 4 .6 3% (n=10 ) ,线性回归方程为△ A=2 5 .6 6 c(μg· 2 5 m L- 1 ) - 0 .0 15 7(r=0 .9997) ,表观摩尔吸光系数ε4 6 0 nm=3.2 7× 10 7L· m ol- 1 · cm- 1 。该法灵敏度高 ,选择性好 ,直接应用于水样和食品样中痕量钒( )的测定 ,结果满意     

山梨酸废水的生化处理

山梨酸生产废水有机浓度高、可生化性好、含盐量高。废水中CODCr为8000-16500mg/L，B/C≥0.5，含盐量≥15g/L。本工程通过淹没式厌氧生物滤池和膜分离活性污泥法处理，CODCr总去除率高达93%-99%，出水CODCr≤300mg/L，达到GB8978-1996《污水综合排放标准》行业二级排放标准，顺利通过当地环保部门的验收。     

Surface modification of coir fibers. II. Cu(II)‐ IO initiated graft copolymerization of acrylonitrile onto chemically modified coir fibers

A study of the graft copolymerization of acrylonitrile (AN) onto chemically modified coir fibers was carried out using a CuSO₄ and NaIO₄ combination as the initiator in an aqueous medium in a temperature range of 50–70°C. The graft yield was influenced by the reaction time, temperature, concentration of CuSO₄, concentration of NaIO₄, and monomer concentration. Grafting was also carried out in the presence of inorganic salts and organic solvents. A combination of copper(II) and sodium periodate (Cu²⁺‐IO) in an aqueous medium with an IO concentration of 0.005 mol L^?1 and a Cu²⁺ concentration of 0.004 mol L^?1 produced optimum grafting. The chemically modified and AN grafted fibers were characterized by FTIR and scanning electron microscopy (SEM). The SEM studies revealed that grafting not only takes place on the surface of the fibers but also penetrates the fiber matrix. The tensile properties like the maximum stress at break and extension at break of untreated, chemically modified, and AN grafted coir fibers were evaluated and compared. The extent of absorption of water of untreated, chemically modified, and grafted coir fibers was determined. It was found that grafting of AN imparts hydrophobicity onto coir fibers. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 84: 75–82, 2002; DOI 10.1002/app.10221     

己内酰胺副产硫酸铵的综合利用

介绍了硫酸铵转化法生产硫酸钾的工艺技术 ,对该方法的经济效益进行了探讨 ,提出了利用己内酰胺副产硫酸铵生产无氯钾肥硫酸钾的建议     

溶解和离子交换反应中K+的快速测定

离子溶液中快速传递及反应动力学过程的跟踪研究在实验上较为困难 ,为此基于离子选择性电极建立溶液中离子活度即时采集系统 ,并结合活度系数模型准确计算离子浓度 .该方法测定速度快 ,最小间隔为 1s,且所得离子浓度最大偏差小于 2 % .用此方法测定了硫酸钾溶解过程以及钛酸钾离子交换反应过程中钾离子浓度的变化 ,获得传统方法难以测定的数分钟内相关动态过程受溶剂、pH值的影响结果 .该方法可推广应用于研究其他各种动态过程 (如溶解、结晶、沉淀、离子交换、吸附和扩散等过程 )     

复分解四步循环法制取硫酸钾新工艺

介绍了制取硫酸钾的一种新工艺－－复分解四步循环法，即氯化钾与硫酸铵反应生成硫酸钾铵与氯化铵钾，硫酸钾铵再与氯化钾溶液反应生成硫酸钾，氯化铵钾再与硫酸铵溶液反应生成氯化铵。整个工艺全封闭循环生产，产品硫酸钾K2O质量分数≥50％，钾收率达92％。     

结晶法净化湿法磷酸生产磷酸二氢钾研究

研究了三聚氰胺结晶法净化湿法磷酸复分解生产精细磷酸二氢钾工艺中磷酸三聚氰胺与氯化钾反应生产磷酸二氢钾的工艺条件。采用二次正交组合实验设计，对反应过程中反应温度，反应时间，搅拌速度，氯化钾用量，氯化钾初始浓度等诸因素的一次作用，二次作用及交互作用对五氧化二磷转化率的影响进行了研究，得到了适宜的工艺条件，所得磷酸二氢钾达到HG2321－91质量标准。     

杂卤石中钾的提取工艺

以四川渠县农乐杂卤石为原料，进行溶浸实验，并确定了最佳溶浸条件，实验表明，当溶浸剂质量分数为5％，固液比为1：4，在温度为40摄氏度条件下，溶浸10h，钾的浸出率可达95％以上，通过蒸发实验考察了溶浸液中钾的收率及钙，镁的去除率，并提出了从杂卤石中提取K2SO4的工艺方法，为我国深层杂卤石矿资源的开发利用提出了一条新的途径。     

黄原酸钾含量的示波滴定

报道了用示波滴定法测定黄原酸钾含量 ,在 p H5～ 6的 HAc- Na Ac缓冲底液中 ,加入四苯硼钠 ( Na- TPB)沉淀 K+ ,过量的 Na- TPB用氯化四乙基铵标准溶液滴定 ,滴至 Na- TPB示波图切口消失为终点 ,终点直观敏锐 ,方法快速简便 ,准确度、精密度均高。标准加入回收率在 99.8%～1 0 0 .2 % ,RSD<0 .2 %